Having problems with your Dyson DC18 all floors Bagless Upright Cyclonic Vacuum ?

Power button will not stay in the on position.


Answers :

If you have a rubber mallet tap it slightly hard than tapping. Use it all the time. If not take it in for service for new switch. Rarely replace those use that repair at my shop daily.
Repair Help & Product Troubleshooting for Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Power button will not stay in the on position.


If you have a rubber mallet tap it slightly hard than tapping. Use it all the time. If not take it in for service for new switch. Rarely replace those use that repair at my shop daily. ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

When i hit the power button on my miele carina, it doesnt lock and stay on. i have to hold down the power button for the power to stay on. Please advise


Try a little WD-40 sprayed sparingly on the button. work the button a few times- may be sticky spring or contact. if that doesn't work, check with retailer where you purchased it- see if you can get a replacement switch! if you're handy, or have a ha ... Miele Carina Vacuum Vacuum

Power button wont stay on. have to hold the power button manually for it to stay on.


Most likely you have to replace ON/OFF switch. look at detail instructions how to do it on our website:http://www.goodvac.com/kb_results.asp?ID=18 ... Kirby Ultimate G Bagged Upright Vacuum

I have a miele S712 (2 yrs old worked fine yesterday) - I had been doing some diy work inside and had the vac on just to reduce some of the dust in the air - after a while the vacuum fizzled out. I guessed it had overheated and took it outside to cool down - when I tried to turn it back on pressing the power button gives it power and it starts to **** but it won't STAY on, soon as you release the power button it stops, and the orange bag indicator is showing full. As I have a compressor I took


You have got dust in the micro switch and it is not latching on, if you look at this and clean it, that will solve your problem, however blowing the motir has probably wrecked the motor bearings. ... Miele Vacuums

Bissell 5770 vacuum power won't stay on. The power will only stay on if you hold down the button the whole time.


I just had this happen to me. I took the top part of the vacuum off, unscrewed all of the screws from the top piece and opened it just enough to pop off the plastic red power button. Then I pressed the switch mechanism up and down a few times to rese ... Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum

Power Problem Whenver I push the power button on the handle the vacuum stays on for a few seconds then turns off. I have to push the button on the handle all the time to keep the vacuum working.


Hi There,\015\012\015\012Unfortunately this is being caused by static electricity building up in the electronic controls in the handle of the hose. I've seen this problem on numerious occasions, and in fact I have the twin brother of t ... Miele Blue Moon Bagged Canister Vacuum

Power button not engaging...vacuum will not stay


The power button is worn out and needs to be replaced. That vacuum is pretty simple. So even if you don't know how to take it apart it shouldn't cost much to have it repaired. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

I have a new (couple of months) Cuisinart Espresso Maker EM-100C. One has to turn on the power button on the front in order for the unit to heat the water. The button will only work if the two manual knobs are in a certain position. Very occasionally, it took a few tries to get the button to turn on. Now it usually does not work but will once in a while. Any ideas what we could do to repair this problem?


... Vacuums

No power unable to manually turn off power, i opened up rear handle hatch to inspect the mechanism/linkage. The red on/off button seems locked in the on position. I replaced the hatch and now i have no power at all. what happened? Is there a fuse?


This vacuum has a recall notice on it. It has to do with the switch. You might want to check... They will fix it for free ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Power Button won't stay down/on.


Hi There,\012\012Most likely your switch has gone bad, and you'll need to replace the \012on/off switch on your Dyson DC07. If you have to hold down the switch in\012 order to keep the vacuum on, this is indicative\012 of nee ... Dyson DC07 Bagless Upright Cyclonic Vacuum

When i push on the power button on it runs only as long as my foot stays on the on/off power switch once i move my foot it immediately shuts off?


... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Dyson DC35 beater bar stays on when power button isn't pushed


... Dyson DC35 Multi Floor Digital Slim Cordless Vacuum

Power won't stay on when power button pushed - Dyson Vacuums


... Dyson Vacuums

I love my dyson but it suddenly won't stay powered on! I push the on/off button and it works fine but only if I hold the button down. As soon as I take my hand away, it stops. I've had it and


Probably needs a new on/off switch here is video how to do it ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have a Hoover Anniversary Special Edition and the Power Brush stays in the Off position. What am I doing wrong. It will not go into the "on" position. I have changed the floor surfaces and still it does not come on?


Hi,Have you checked the Brush On/Off switch?If you find that switch is not working :-Order it at :-http://www.govacuum.com/hoovwinonswi.htmlAlso, Try to adjust the position of the brush. Som ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Power button won't stay on. If I hold it down, it sucks fine, but it won't stay pushed down.


Bad switch ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

While vacuuming the beater bar shuts off all by itself, the main power source stays on. I touch the power button on the beater bar to start it again and it shortly after shuts off again. why is this happening?


... Dyson Stowaway DC23 Bagless Canister Cyclonic Vacuum

The power button does not work 80% on the time. I have to keep flicking it on and off until it turns on. The battery is fully charged, so that is not the reason. Once power is on, no issues staying on.


... Oreck TEK100 Handheld Vacuum

Won't retain power, only stays on when you hold power button


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson will not stay powered on unless power button is continuously pressed. Is this a switch malfunction or something else?


Yes, you probably need to replace the switch - call the Dyson helpline, they'll give you the info for your closest authorized repair dealer who will open it up and replace the switch for you. ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

My dyson won't stay on. I push the red power button and it begins to start but as soon as I stop pushing it, it stops. It will only work if I keep pushing down the start button the whole time I'm using it. HELP!!! I love my vacuum!


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

The power head model #116. 53812300 does not stay on. When I push the belt reset button it only stays on for a second or so. The belt is not jammed or the roller.


... Kenmore Vacuums

I just got a Shark Bagless Upright Pet Pro V1310PT-FS and the power switch will not stay on. If you hold it down, it will turn on and the vacuum will pick up but the switch doesn't seem to stay in the "On position". Any ideas how to quick fix this?


... Vacuums

Eureka hard surface floor cleaner power button doesn't stay on


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Vacuum won't stay powered without holding the button down.


This is over a year too late, but perhaps this will help other people in your situation. Here is how the switch assembly should go together: ... Dyson Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 1.6749 seconds