Having problems with your Dyson DC25 All Floors Bagless Upright Vacuum ?

The extendable wand is jammed at full length and will not push back in?


Answers :

Try a little wd40 or tap it lightly at the top.
Repair Help & Product Troubleshooting for Dyson DC25 All Floors Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The extendable wand is jammed at full length and will not push back in?


Try a little wd40 or tap it lightly at the top. ... Dyson DC25 All Floors Bagless Upright Vacuum

I HAVE EXTENDED THE WAND TO CLEAN MY STAIRS AND CANNOT GET IT TO GO BACK INTO THE HOSE.. IT IS AS IF I NEED TO CLICK A BUTTON TO ALLOW TO GO BACK IN BUT CANNOT FIND 1 ..IT IS NOW STUCK UP FULLY EXTENDED .. HELP ( YES IT IS NEW )


... Dyson DC27 Bagless Upright Vacuum

My telescopic wand height adjustment won't lock the height in place. The wand extends to full height with no locking in place. How do I fix it?


These wands have a very small nub that locks them into place. They wear out very easily. You might have to replace the wand. ... Euro-Pro NV31 Infinity Vacuum

The extended wand will not retract back down hose l do not not know how this works


... Dyson Vacuums

The retractable handle doesn't stay in place. a small spring came out near the button that you push to slide the handle up and down to change the length. i need to know where the little spring goes. there is a small pin that the spring fits around but i can't seem to get it to go back in place once the spring is on the pin.


... Panasonic Kenmore Canister Vacuum Vacuum

Loud grating/rattling noise comming from dyson dc04 when ever hovering upright as soon as i angle back the handle to push it. the belt has not come off, the roller is rolling and not jammed. sucks ok from the flexible hose.


... Dyson Vacuums

Model 116.27914 power mate connection to lower wand is loose. Head unit works when pushing forward putting downward pressure on it, but looses power when you pull back on unit and connection is lost.


... Kenmore Vacuums

I bought a used Miele vacuum with the SET210 wand, but the push button to release and clamp the telescoping wand was missing. I can get the wand to slide by pushing with my finger, but it's a little difficult. The main problem is that nothing holds it in place at the desired position. I bought a replacement push button online, but it came with no instructions. How do I install it?


Your best bet would be to put on your friendly face, and take the unit into a Vacuum Repair Shop, and have them assist you, or at least give you tips on the procedure. Chances are you will have to disassemble the unit a lot more than you might want ... Vacuums

Wand in stowaway dyson is hard to extend. Seems like u have to pull 3 clips from grooves in 3 rings around wand to extend and shorten wand which is a struggle


Hi there, you should just be able to hold the telescopic wand in one hand, press the button and pull the whole length of the wand out to its fullest position. If the telescopic wand on your particular Dyosn is very stiff, you may need a r ... Dyson "Stowaway" Canister Vacuum Vacuum

The wand is locked in the extended position on my Dyson DC28 and I don't know how to release


... Dyson DC28 Animal Upright Vacuum New DC 28 Animal

Dyson dc07 wand handle jammed


Is this what you mean ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!


... Miele Vacuums

Extending wand problem...


You need to press the colored button on the end of the hose. It's the catch that releases the wand from the hose, and lets it be reinserted. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have a tank style vacuum. When I vacuum with the power head it dims and slows down when I push the power head back and forth, but it powers back up louder when I stop pushing it If i remove the powerhead from the hose the vacuum works fine.


Most likely the belt. Thats the cheapest so try it first ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

My eureka central vac power brush turns off when pushing forward than back on when pushing back. Ever seen this before?


Yes I repair them all the time. What that means is that the connection of the hose handle to the power brush upper wand is loose. This can happen over time with use. The connection just loosens up. Do you have the exact model of the power brush? ... Eureka 1810 Central System Vacuum

I have a Infinity Vacuum Cleaner. Shark Model NV32. I took the wand out to vacuum a spot and now I can't put wand back in. I keep pressing the wand release button when putting the wand in but no good


... Vacuums

My vacuum is a Kenmore Special Edition with a Power-Mate 12.0 AMPS wand. I ran over the edge of fringed edge of my living room carpet and immediately turned off the vacuum. Although I have removed the fringe pieces from the wand head and I have pushed the overload protector reset button on the wand, the wand brush will not turn. Help- it's the Thanksgiving weekend and guests are coming soon! Thank you.


... Kenmore 25512/ 25513 Progressive Canister Vacuum

My Dyson DC25 Animal vacuum head is not staying flat after pushing Red Release Bar.


... Vacuums

Can't lock my telescopic wand


... Vacuums

HI, I have a Kenmore 25813 and it seems like there is an intermittent short. When I have the extension wand on and the power floor attachment on, when it rotate the wand the light cuts out and so does the power floor attachment, when I twist it back it comes on again. I don't have this problem if I remove the wand and just use the crevice tool with the hose. Any idea where the short might be and can I fix it myself? Thanks. Gary


This is common you may have a short in the contacts from the handle to the wand or a break in the cord that goes into the powerhead ... Kenmore 25812 / 25813 Progressive Bagged Canister Vacuum

Fantom vpw46h,house pressure washer.the motor runs,it was setting for sometime started,using it,but never had any pressure besides the house hose pressure, with the motor running,then the pressure startes to work great,while using it the wand hose came out of the pressure washer,i put it back in,now the motor will only run when i try to adjust the wand head but will not produce any pressure and will shut the motor off,it seem like as soon as the wand hose came out of the presure washer and after


... Vacuums

Hi! I have a Pfaff Creative 1475. The presser foot seems "gummed up" or stuck. The back lever lifts it with great force, but then instead of staying up like the lever usually does - it then falls back down. The lifting foot stays stuck up and I have to push on it to get it back down. Help?


Bdfbjhfjffjfjfjfjfjfjfkfjfjffjfjfjjfjfjfjfjff ... Vacuums

While using my mop yesterday, it stopped letting steam come out. Tonight I plugged it up again and you could hear it trying to steam. I push the button in to release the square frame and it pushed out a burst of steam and pushed the head off. Put it back together and it still will not let steam out. No matter how much water is in it.


\012Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Ste ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Hi. I borrowed my friend's Hoover VC340 to clean my house. I was vacuuming when i noticed the cannister was full, so I turned the vacuum off, pulled out the barrell, and followed the instructions on the barrell to empty it. I put it back into the machine, but it wont turn back on. I tried different power outlets, but to no avail. any thoughts?


... Vacuums

The wand does not have much suction and then when trying to use the wand the machine just shuts off, when I turn it back on the brushes will not turn for a while. Please HELP.


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0549 seconds