Having problems with your Dyson DC28 Animal Bagless Upright Vacuum ?
Good evening. my 6 month old dyson does not have suction going through the wand attachment.
Repair Help & Product Troubleshooting for Dyson DC28 Animal Bagless Upright Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Good evening. my 6 month old dyson does not have suction going through the wand attachment.
... Dyson DC28 Animal Bagless Upright Vacuum
Carpet attachment has two little holes just below where it snaps into place on the wand -- the airs going out those holes and not getting to the attachment so there's no suction
There is a small brush attachment that goes in there, you don't need it. Just tape up the holes. ... Kenmore Magic Blue 24195 Bagged Canister Vacuum
DYSON DC17 ABOUT 4 YEARS OLD. I HAVE TWO FILTERS THAT I ALTERNATE BECAUSE AFTER 2 HOURS OF VACUUMING I LOSE SUCTION. I HAVE TO WAIT 3 DAYS FOR MY FILTER TO DRY BEFORE I CAN SWITCH THEM AGAIN. THE FIRST TWO YEARS I HAD THE DYSON I COULD GO A COUPLE MONTHS BEFORE CHANGING THE FILTER. WHATS WRONG?
Hi there! This is John from Jerry's Vacuum Sales in Modesto Ca. Are you using any type of carpet fresh product on your carpet? If so the fine powder is leaking onto the filters and causing them to clog. Discontinue use and over time the problem will ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
No suction Just received my refurb. dyson animal bagless. Finally figured out how to get it all together, turned it on and there is no suction coming up thru the beater bar. The hair is just collecting around the bar and not going up into the canister. It appears all the suction is going thru the open red end of the attachment hose, which has a vented cover piece. Am I missing a piece or is there a switch to turn of the attachment suction?
So the red hose isn't connected to a part on the vaccum so like it is connected to the connester but not to an opening just above the beater bar, this is the only idea i can supply you with. good luck, maybe i got lucky and helped you out. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
On my DC17, the wand is not working right. The upright part works fine, but when I go to use the wand, the hose sucks in on itself. I get suction for a few seconds, then the hose collapses in on itself and no more suction.
... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
There is no suction to the wand and attachments. Floor suction is great. Seems like something is blocking the wand.
It may be nothing wrong with the wand...but the valve that redirect the suction from the floor to the want...Either is not closing proper in the position that redirect the suction ...or it has something that block it when it tries to do the action.. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
I have a Filter Queen Majestic canister vacuum cleaner. At the end of the wand, a button to release the attachement not only broke, but also one eyehole on the wand where one nipple on the button falls into. So therefore a new button isn't going to fix the wand because there isn't a hole on one side of the area where the button falls in place for a nipple to secure the button in place. IS THERE A REPLACEMENT PART FOR A NEW SECTION OF THE WAND WHERE THE RELEASE BUTTON IS SECURED IN PLACE THAT I C
... Filter Queen Majestic Canister Vacuum
No suction My vacuum does not seem to have much suction when in use. The agitator brush is rotating but I'm not able to get much off the carpet. The suction is fine when I use the attached wand.
If the belt is stretched, then it can't turn the brush rol under load, if you haven't chenged it in the last 6 months, then I would put a new one one. Also check the dirt inlet by the brush roll for a blockage. ... Riccar 8955 Upright Vacuum
I have a dyson animal dc17 vacuum and it totally died. Now I can't figure out which wires go where when I install my new motor. (motor #: 160906G) Do you happen to know where the various color wires go or a place I can see a diagram of the motor with wires attached? I should have taken a photo of it before tearing out the old motor. I don't know where to connect the three coming out from the upright portion of the machine and the red seems to go to a switch (?) and there is a black (connected t
No suction Own a Bissell Easy vac (bagless). Only just over a month old & it lost suction from the brush roller & hose. We've cleaned all filters & checked hose for clogging. Any recommendations?
Http://www.fixya.com/support/t1845597-debris_getting_stuck_in_vacuum_hose ... Black & Decker Vacuums
I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!
... Miele Vacuums
Smell/suction I have a Eureka Altima Model 2991 Type AVZ. I have suction when I use the power paw and attachments. I have all hoses clear. My brush is spinning and belt is not broken (I opened it up and checked), but I have no suction when I turn it on to vacuum my living room carpet. I also have a burning smell to go with it after about 30 seconds. I've never had a problem with this vacuum cleaner before.
Ours started smelling too, and it seems that the plastic end on the roller brush was melting. In process of finding rollerbrush for it now ... Eureka 2971AV EZ Kleen Bagless Upright Vacuum
On our new carpet (which is not that thick but thicker than the old) I can't set the carpet thickness high enough. The suction really grabs the carpet and bogs down my self-propelled wind-tunnel Hoover. I then have to push down on the handle to tilt the front up. The thickness setting is as high as it will go. Is there some way that I can further adjust this. The machine is about eight years old.
I can help you out only if you will let me know the front width of the machine. Alongwith the height which you wan't to give raise. KIndly give the width and elevation in cms. ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum
My vacuum has suction with the long tube assembly but not any significant suction down by the rollers. I assume there is a clog or a problem between where the hose attaches to the machine and the rollers but I can't figure out where to look for it. HELP. I've only had this vacuum for a few months and I'm really dissapointed!
Go to the bottom of the machine and to the rhs of the rollers you can see the pipe - also remove hex panel on back and remove hose from elbow , i also found that a filter cx did wonders ... Miele S7210 Bagged Upright Vacuum
My roomba tells me to clean the brushes and stops; however beforehand, it goes around going "click, click, click". The brushes have been cleaned - all hair removed, etc. but the clicking noise persists. What is going on? It's only a few months old!
... iRobot Roomba Discovery SE Bagless Robotic Vacuum
I have a DC17 which is only one year old. Today I lost suction and called for assistance. A Dyson technician told me to pull off the wand and see if it is clear. It was clogged so cleared out the obstruction. My filter was cleaned more than 24 hours ago. The vacuum still has no suction. Is it dead, any other suggestions. Please help.
Take the hoses off and give them a good shaking.\012or get a long piece of stiff wire and gently poke through the obstruction. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
Su2914: loss of suction even when cylinder is empty!! doesnt work correctly when pet attachment is added either, only seemed to work ok for first 4 months then loss of suction, will pick up eventually but quite poorly! Should I take it for a service? Thanks
... Samsung Vacuums
Have a Centralux Aerus about 5 years old. Don't see a model number. There is suction but beater brush quit working. Was using for a few minutes, shut it off for a few minutes, turned it back on and suction only. Tried the reset button also. Tried the sidekick attachment and it works fine. There was no smell like something was hot. Belt is fine. Are there any fuses or anything else to try? This vacuum cleaner has not really been used that much, it is hard to believe the motor would need replaced
There probably is a loose wire in the handle near the switch or a wire off near the swivel elbow near the vac power head. With the right fastener tool to remove some screws you can fix it yourself ... Electrolux Centralux Vacuum
I have a hoover windtunnel bagless vac that is several years old. the floor vacuum part still works fine, but the handtool attachment has no suction and is useless all of a sudden.
Don't have your model number, but some have a valve down on the noozle part that may be broke. When it is its upright position, the valve won't change over to the hose only position. You would have to remove the top cover to see this. ... Vacuums
Model Fantom Thunder (quite old) still runs,no suction from wand, very poor from bottom
Sounds like you have something stuck in the air way you can flip the vac over and they had trap door you open to clean it you may have to use coat hanger straigten out with a small hook on the end ... Vacuums
I purchased the scunci in April all went well until a month ago it no longer makes steam I have the 52000deluxe complete with floor attachments I have gone to countless places to try and get it fixed it is not even a year old the serial number is43194-52000 I paid over $100.00 dollers and I also purchased one for my mother I will gladly send it to you for maintence. My email is firstname.lastname@example.org. My name is Michelle I. Kayes
The only thing I can tell you here is try to take it apart and check the connections to the heating element. It may just be a loose connection. How handy are you with a tool? It might be worth a shot, it's no good the way it is, right? ... Scunci 52000 Handheld Steam Vacuum
My suction wont work. It works for about 2 swipes and then quits. When you stop and restart it does the same. It is only 2 months old!!!!!
Hopefully you don't have a bad impeller on the suction motor. Start with this though: Make sure that you check for obstructions in ALL of the tubes, from the brushes all the way to the bag/canister. I've found that in many cases, especially if you ha ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum
I do not have any suction, to the base or the wand. My brushes also do not turn. The belt appears to be attached & in good condition and there are no clogs (that I can find)
Some times there is a pan beneath the vacume and an opening there, it may be clogged there, thats not real unusual, hope this fixed it,, ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
I am hoping my Kirby Sentra has a reset button. It is only 5 months old and it will not turn on.It worked a couple hours ago. The vacuum will work with the hose attachment but not with the roller.
We have a new hoover bagless that is a couple months old. The pet hair attachment stopped working. I disassembled it found lots of hair wound around the various rollers and removed - painstakingly thorough i might add. Problem is the brush still wont spin and now the belt seems loose - I think I put it all back together correctly but wondering if there is a trick to this?
Without the model number, I can't look it up, but this has a 1 years warranty on it, maybe take it to a warranty shop. Just take proof of purchase, model and serial numbers. ... Vacuums