Having problems with your Dyson DC39 Animal Canister Vacuum ?
How do we remove the dirt canister from the machine?
Repair Help & Product Troubleshooting for Dyson DC39 Animal Canister Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
How do we remove the dirt canister from the machine?
... Dyson DC39 Animal Canister Vacuum
How do I remove top of dirt canister on my Dirt Devil Model UD70010 Bagless Vacuum? Dirt is stuck inside canister and I cannot get it out.
... Dirt Devil Vacuums
My DC 17 is plugged. I can see through the small hole in the top blue "flower shaped" that the holes at the top of the canister are plugged with hair & dirt. I cannot see anyway to get to these small round holes. Is there a way to remove the top blue "flower shaped" piece? I have removed the inner cone from the clear canister but still cannot get up underneath.
Please kindly follow the steps below to clean your vaccum cleaner,1.) Remove the clear plastic handle. You\015\012will have to take out two screws and then unclip from the from the\015\012front. It's stiff, I gently used a flat head screw drive ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
Bosch canister vac BSG81313. Took cover off to remove lots of hair, dirt etc from running without bag in place. Everything went back together OK, but cord reel spring went zip when cover was removed. How do I rewind the spring so there is tension when the cord is pulled out ? Wound cord back onto reel, but reel just clicks ever revolution etc...no tension when cord is pulled out of vac. Bob
The spring inside the hub of the cord wheel has escaped from the locking tab. You must completely dismantle the vacuum to access the cord wheel - take it out, reattach the spring and reassemble the unit. All you need is a phillips screwdriver, a pai ... Vacuums
Hello- my motor filter is becoming clogged every time i use it. i have removed and washed it--I thought maybe i didn't have the lid closed tight enough but for some reason dirt is pouring into the filter, it seems that some of the dirt suctioned is actually being pulled into the filter intead of the canister
One way or another, dirty air is by-passing the cyclone. My best guess is that when you emptied the clear bin, a seal has dropped out (or become displaced) and the base of the clear bin is no longer sealing properly against the bottom of the cy ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
My Bissell 5570 is not staying on. When I push the on botton it goes on but as soon as I remove my finger the machine turns off. The Vacuum is in the upright position and there are no cuts in the electric cord, the canister is properly attached. Please advise. Thank you
... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue
Retractable cord not retracting. How do I access roller drum? The two screws inside the main canister only free up the front edge of the upper assembly, does the rubber gasket that goes completely around the machine need to be removed? Is there a technical drawing showing the complete assembly?
... Miele S246i Bagged Canister Vacuum
Not switching on after an occassion of the canister gettn filled up and the dirt got sucked into the machine viz the hole attaching it to the handle
... Dirt Devil Vacuums
How is the dirt canister removed from the Dyson DC39 vacuum please?
I'm sure you've figured it out by now but there is a button located next to the handle of the canister and you simply click there to release it.Hopefully that helped! ... Dyson DC39 Multi floor canister vacuum cleaner
While vacuuming air started flowing out of a hole on the right side of the machine directly below the canister that catches dirt. And the engine became hot to the touch. We have only had the unit for 3 months and no one in Austin Tx works on this model so any help would be appreciated.
... Shark Navigator Bagless Upright Vacuum
Remove dirt from bag - Electrolux UltraLux 2000 Bagged Canister Vacuum
The bags are not reusable, you will cause damege to the machine if you reuse bags. \015\012\015\012A cheaper alternative is generic bags ... Electrolux UltraLux 2000 Bagged Canister Vacuum
I have a Sears Kenmore canister sweeper with the power mate, but it no longer has sufficient suction to pick up dirt. I took the machine apart and cleaned it, but it is still not sucking, does this model need to have the motor oiled?
When cleaning the machine, did you do a good job of cleaning the beater brush and making sure it turned freely in the holders on each end? Perhaps a bit of WD40?\015\012Also, a new set of belts might help a bit. ... Kenmore 22812 Bagged Canister Vacuum
Kenmore bagless 116.36932502 the interior filter port fills up very quickly-withih minutes of initial startup-- and has to be removed and cleaned constantly. Debris backs up into the interior of the main filter as well, the main canister never gets full. New problem with old machine!
... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum
Over heating I have a simplicity canister we can see the dirt by thr inner filter how do we remove the top to clean or replace the inner filter?
TAKE IT TO A DEALER HE WILL HAVE THE PARTS FOR IT ... Simplicity 7850 Premier Bagged Canister Vacuum
My New Home DX2030 (older than dirt) balls up thread when I try to reverse. I cleaned bobbin holder, hook race and replaced needle, twice. I removed and replaced bobbin and rethreaded machine but no improvement
I have a dyson dc07 original that i bought used. Last owner was obviously a pet owner and the machine smells too bad to even turn on in the house...can I clean the canister with water? What other parts can get wet or is there a better way to remove the odor?
Put some vac freshner in the canister put the vac out side if its fine plug in and switch on leave runing for around 10 minutes that should solve the odour ... Dyson DC07 Bagless Upright Cyclonic Vacuum
I do not know how to remove the canister that catches the dirt. I do not have a manuel.
Sorry to read about your problem, I hope this helps you out.Emptying the Clear bin caution: (i) switch 'off' and unplug machine before emptying the bin.Empty as soon as the dirt reaches the level of the MAX mark - do not overfill ... Dyson Ball DC24 Bagless Upright Vacuum
Kenmore Quick Clean - how to remove dirt from cannister
This is the web site for Kenmore owners manuals--->http://www.managemyhome.com/mmh/<---Please take the time to give this solution a fix ya ra ... Kenmore Quick Clean 30012 Vacuum
I shipped my brother PE 770 embroidery machine purchased sept of 2010, to a lady who perchased it on ebay. Had used only once. Everything worked fine.I shipped in the original formed styrofoam box. I removed the embroidery arm, releasing the locking plastic hook holdind the machine and the arm together. When to lady removed the machine first in the original plastic shipping bag, two parts fell out. Her photo she emailed showed a black plastic piece with two holes or pivot points.also a silver me
This is a link to the manual for this machine. Do you see a picture in the manual of the parts you are describing? Reply with a part number and I will do my best to help. ... Vacuums
We replaced the short hose that connects the sucking part to the hole where the dirt goes underneath my Dyson DC07 but now the side of the hose that needs to attach to the machine falls off.
I know the hose you are talking about it is called the DC07 internal hose. Over time the ends can stretch and perish which will mean y ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
Vacuum throws dirt onto machine and not in it
Hi its Darran at Dyson. It sounds as though your machine is blocked. This is why the dirt is being dropped back out on your floor and also why the bin is not filling up. Simply follow the blockage procedure in your user guide, ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
I cannot remove the canister on my DC07 Animal
... Dyson Vacuums
This is a new machine I got for Christmas. All of the dirt is staying in the area where the brushes are and then falls out when you turn off the machine. I have checked all connections and the hoses seem to be clear. All filters have been cleaned and there is not dirt trapped that I can see.
... LG Electronics Kompressor Pet Care Upright Vacuum Cleaner LUV200R
Hoover turbopower 4900 bagless model U5296-900 - the canister will not seal. Dirt and air leak out where the dirtcup latch mates with the dirt cup canister. how does one fix this kind of issue?
... Hoover Vacuums
I have a Model 116.35922500 Kenmore upright vacuum cleaner. It makes a loud air noise when using the vacuum. I have disconnected and removed the hose to see if anything is lodged in the hose and it appears clear. It makes the noise when the hose is connected. When I remove it, the noise stops. When I place my hand over the hose, the nose re appears. I sounds as though the noise is coming from the fan or internal parts of the machine. So, when there is a load or pull on the machine, it mak
... Kenmore Progressive 35922 Bagged Upright Vacuum