Having problems with your Dyson DCO7 Animal Bagless Upright Cyclonic Vacuum ?

Dc07 when vacuming it will shut down20min to 30mins my startup

\015 We clean filers did not help\015

Answers :

Hi
Check that the main hose is not clogged top and at the base, also check that all inspection airways are clear and after the main brush roll there is nothing clogging. When a vacuum activates its thermal cut out its usually because the motor is straining to produce power and clogging is usually the problem.

If this works, please rate appropriately.
Repair Help & Product Troubleshooting for Dyson DCO7 Animal Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dc07 when vacuming it will shut down20min to 30mins my startup


HiCheck that the main hose is not clogged top and at the base, also check that all inspection airways are clear and after the main brush roll there is nothing clogging. When a vacuum activates its thermal cut out its usually because the motor i ... Dyson DCO7 Animal Bagless Upright Cyclonic Vacuum

Vacume Overheating My vacum is overheating and then shuts down for awhile but doesn't start again untill the vacum has cooled down.. Are there any heat-relays or something like that that could cause the problem ?


There will be a filter between the cylinder/bag and the engine. If your vacuum has a HEPA filter there will be one on the other side of the engine. Remove both of these and clean them out with water, allow to dry and replace. ... AEG Vacuums

I was vacuming with the hose only with my kirby generation 3 vacum and it suddenly made a different sound and smelled strong of burning. I immediately shut it off and unplugged it. It IS about 30 yrs old. Do you think it is worth taking in to pay someone to look at it or it just bit the dust?


It might be the belt and if it is it will be a sipmle fix. If it isn't I think It's time to bite the dust and buy new. You won't believe what you old vacuum was not sucking up and for what it would cost to repair vs buying new it would be about the s ... Vacuums

I bought a Eurika upright vacum (the boss whirlwind lite) it is pretty new, keeps shutting off before i am done vacuming, and the hose doesnt **** very well!!!


Your model mite have a divice that turns the motor off if it heats up if so take it to a repair shop and have them look at it ... Vacuums

The vacum will run until the hose is inserted and then the motor shuts off. The vacum switch must be hooked up incorrectly. Do you have a schematic?


Before trying to take it apart, check the hose for a blockage. Disconnect the hose at both ends, drop a coin in one end, lift that end of hose allowing coin to drop through. If it doesn't come through, there's a clog. You should be able to clear i ... Electrolux C101 Bagged Canister Vacuum

DC07 Shuts Off, won't restart


If it was running for a while... It may be overheating. It has a reset: http://www.ehow.com/how_5943288_reset-dyson-vacuum.htmlBut maybe j ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

M&S FX 2000 vacum shuts off


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... M&S Systems FX-3000 Bagged Central System Vacuum

Dyson DC07 shuts down after 5-10 minutes of use and horrible suction!


I have had this problem on two dysons and have solved it by replacing the so called lifetime pre-filter. The problem is not the washable blue sponge but the material gauze filter in the plastic surround. \015\012\015\012To see if this i ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Electrolux canister vacum model 1401-b makes a whining noise when it's shut off


... Electrolux Vacuums

My DYSON DC07 upright vacum


The actuator in the switch is defective, you can replace just the switch. There are several places to get just the switch, just google "dyson dc07 parts" for places on where to get the switch. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Vacum shuts down when suction starts


Try turning the knob on the top of the vac all the way to the right. ... Electrolux Guardian Bagged Canister Vacuum

My lift off revolution vacume shuts off


Hi Kathryn! Your Lift-Off vacuum is equipped with a Thermal Protector that will turn your vacuum off if the motor starts to overheat. This can be caused by dirty filter or reduced air flow. Here's a quick link to troubleshooting steps to assi ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

Vacume is a mach 4 cyclonic, it runs for about 8 minutes and then it shuts itself off? any idea?


The only thing I can think of from your additional comments is when it warms up something expands and it loses continuity of the circuit. Most likely the switch or the breaker. Another thing to check is if it has a hepa filter it may be clogged ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Vacume overheats and shuts down I replaced the motor.When it cools down it runs again.


The filters had to be cleaned out with air. I replaced the motor for nothing.There are two filters and the cannister give them good cleanings with an air gun. ... Kenmore Vacuums

How to release the hose from the dyson dc07 vacum cleaner?


Look care fully around the handle ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Vacum runs fine with hose disconnected and soon as any pressure is put to hose recepticle including your hand it shuts off


These machines have a "Suction" sensor this has become blocked or gone faulty, or the microprocessor has... yes there is one in here too. Probably going to have to get it looked at? ... Electrolux Epic 6500 Vacuum

I can't get the vacume to run for more than 15 minutes before it shuts down presumably do to overload. But I don't get the warning light and I clean it out regularly. I have to let it sit for hours until it resets and I can finish the job


Sounds like you have a blockage. Check your attachment hose by dropping something through it, if it is all clear, then check your duct hose, this is the hose at the base of the cleaner. Many times this will clog and you might have suctionat your ho ... Vacuums

Dyson DC07 Vacume cleaner trips on thermal after 10 min motor not excesive hot resets after 15 min has been doing this for the last 3 mths. Could it be faulty thermal or motor overheat how can I check without changing motor


First, check both filters on that unit. the premotor filter on the side, and the hepa filter underneath the canister. if those filters are clean move through the suction channel and look for a clog or obstruction. also make sure the canister is clean ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

Motor overheats and shuts off - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


The priamry cause of motors overheating is that the filters are not cleaned or replaced frequently enough. Once a motor starts to overheat, it has already been damaged and even after the filters have been cleaned, may well still overheat and cut-out ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Vacum just shut off when vacuuming - Dirt Devil Vacuums


Could be clogged. Check hose check sole plate if its an upright, check handle of hose if its a canister type or check the filter inside the bag/bin area i.e the white or black filter either behind the paper bag or cyclone- if its clogged with dirt th ... Dirt Devil Vacuums

I have a Electrolux Epic 6500 SR canister vacum cleaner. It is nine years old and for the past few weeks it has started shutting off for no apparent reason.The symbol for bag change lights up and it cuts off, but even after I have put a new bag in, it still does the same thing. Do you have any suggestions? There is a little button or switch that the top of the bag fits on. Do you think it could be the problem?


Your machine is probably clogged, look through the wands, look in the bottom attachment, to see if there is anything stuck there. You can also drop a marble through the hose itself to see if anything is stuck there as well. To unclog the hose try hol ... Electrolux Harmony Canister Vacuum - EL6985 Vacuum

Roller brush does not turn when vacum is on - Dyson DC07 Bagless Upright Cyclonic Vacuum


The belt is broken or stretched. You can get replacement belts for the DC07 here:Belt for DC07 with clutch ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I just purchased a DC07 Dyson vacuum cleaner. It is not vacumming my floor - I have hardly any suction at all. Do I need to activate something in order to initiate the suction?


With vac upright suction is sent to the hose ie top of vac handle when handle is tilted down to the user vacuum position it should send the power suction to the floor also make sure collection bin it in securely that make be the problem ... Vacuums

Dyson DC07 overheats and shut off. - Vacuums


Hi,Please CLICK HEREI hope you'll get some idea and please cooperate with Pauldonp.He'll help you out hop ... Vacuums

DYSON DC07 ANIMAL VAC: IT SHUTS OFF INTERMITTENTLY, GETTING WORSE SURE ITS AN OVERLOAD PROTECTOR IN MOTOR. HAVE THOROUGHLY CLEANED THE UNIT TO NO AVAIL. HELP ???


The circuit tracks should be getting cut somewhere in between some where so it leeds to this problem. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0275 seconds