Having problems with your Dyson Vacuums ?

The beater bar/brushes are not rotating.

\015 The belt appears to be OK.\015

Answers :

There is an on/off switch RIGHT NEXT TO THE MAIN ON OFF for JUST the beater bar. It is not highlighted in the manual.
\015\012Thanks for using FixYa - a FixYa rating is appreciated!!
Repair Help & Product Troubleshooting for Dyson Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kirby Heritage II. Beater bar does not turn. One end rotates freely, but the other sticks, preventing the bar from rotating. No obvious means to disassemble the end of the bar. Is there a way to repair this, or does this require replacement of the beater bar? Did clean the front end assembly, and removed all hair, threads and similar obstructions.

The bearing is bad on the end that turns hard. You will need to purchase a new brush roll assembly. If the roller is older that 4 or 5 years, it should be changed anyway. The brush strips that scrub the carpet loose their strength after many years of ... Vacuums

How do you get the beater brush to start rotating, the dyson was just cleaned and the beater brush won't rotate

Sounds like the rubber drive band has not been replaced properly to drive the brush and/or the brush was not properly cleaned.\015\012You can find the manual here:\015\012\015\012http://dl.owneriq.net/4/4d79dca8-65d8-4c46-a58a-a2fef1f89635.pdf ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a Germ Guardian GGU350TT. The Beater Bar Brush is seized up on the ends and no longer rotates. Can it be fixed or can I buy a replacement Beater Bar Brush? I've called the company and they were no help.

... Germ Guardian GGU300 Bagless Vacuum

While vacuuming my carpet, a corner of a throw blanket was sucked into the beater bar. I turned the vacuum off and was able to pull the corner of the throw blanket out without much resistence. I plugged the vacuum in and started it and now the beater bar isn't rotating.

Try pressing the reset button on the nozzle, probably just tripped out the brushroll motor ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

I have a Hoover Mach 5. The beater bar will not rotate. I have taken the plate off of the bottom and sometimes it will rotate. I put the plate back on it stops. I have taken off any hair, string or anything else that may hang up the bar itself to no avail.

Replace the belts part # 38528-034 V belt and 38528-035 flat belt also inspect the belt groove on the brushroll if the new belt rides deep in the groove you will need a new brushroll. there is a tensioner for the V belt that tightens it when the hand ... Hoover Vacuums

Kenmore 39522 vacuum beater bar keeps rotating after unit is shut off. Even unplugged it to move to another room and when I plugged it back in, the bar rotated a few more times! Has a definite clicking sound when this happens. Purchased in January 2008.

The berings or something inside might be going bad. ... Vacuums

Beater bar not rotating in carpet position tried overload protection reset rotates freely by hand model mc-ul594 bagless upright

... Panasonic Vacuums

I was cleaning the hair from the beater bar, and it popped out with the belt still attached...have tired to put it back in , but the beater bar will not rotate when the vacuum is turned on

When you put it back make sure that the ends of the bar fits exactly in the ends o the box and has to roll smoothly even when you rotate it with your hand when you try this has to be disconnected ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC07 is making a sound like the beater is picking up gravel and the beater is not rotating.

You need to take it apart to fix . serch driver repar on your pc. ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

The beater brush bar will not rotate. Fringe on t...

... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

There is suction but no rotation of beater bar

Replace the drive belt.\015\012turn the vacuum over. take the buttom plate off, you can access the roller (beater). there should be a belt attached to the roller and the motor shaft. ... Vacuums

Unit powers up but beater bar does not rotate

Have you checked the belt that drives the beater bar? ... Kenmore 22812 Bagged Canister Vacuum

The beater bar wont rotate when set to floor cleaning on bissell aromatic carpet shampooer

... Bissell Vacuums

Beater bar not rotating

Remove the screws from the bottom of the power head. ... Panasonic Kenmore Canister Vacuum Vacuum

Ran across shoe lace and when I pulled it out the beater bar quit rotating

Just cut the sholace part that you can see... it will get it into a lot of small peices and just pull out the smaler laces ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

Rug Beater isn't rotating during use

This defintiely sounds like your belt has broken or slipped off the motor pulley. The brushes on your vacuum are driven by a belt that attaches to the motor shaft on one end, and the roller brush on the other end.\015\012\015\012If yo ... Bissell 6594 PowerForce Bagless Upright Vacuum

DC15 - beater bar is not rotating

There is a tiny motor for the bar itself at the side of the bar you will see tiny slits which is the vent for the motor which is most likely burned out and will need a replacement. ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

My Dyson 07 beater bar doesn't rotate

Hi.\015\012\015\012If your Dc07 is all floors it will have A clutch fitted this is easy to determine just stand in front of your machine look down at the left hand side there will be a coloured knob on the side e.g. blue.yellow,gre ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Beater brush will not rotate - Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

If you have not had this unit in for any previous service, and you are tilting it back to engage the brush with the swich on carpet mode, then I would likely suspect the switch assembly in the upper handle. The new switch and harness can be replaced ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

The beater bar/brushes are not rotating.

There is an on/off switch RIGHT NEXT TO THE MAIN ON OFF for JUST the beater bar. It is not highlighted in the manual.\015\012\015\012Thanks for using FixYa - a FixYa rating is appreciated!! ... Dyson Vacuums

The beater bar will not rotate but the belt is not broken.

DC07s have two belts - one connects the output of the motor to the clutch, the other connects the clutch to the brush bar.I suspect the belt you ar ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Fantom Thunder vac....beater bar quit rotating - can't even move it manually....seems to be locked up.

... Fantom Vacums XT450K Upright Vacuum

My son dropped the vacuum down the stairs and now the vacuum works but the front part of the vacuum does not drop back down when vacuuming any type of floor. It slowly drops and does not stay on the carpet. hope this makes sense. I have cleaned filters and suction seems strong at the small hose. the beater bar rotate very fast still.

May be part missing. this is unit has 5-year warranty.you can send to service. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Kenmore progressive upright (direct drive) with bag has low suction and the beater bar does not rotate. Also, it is not obvious how to get inside the vacuum

Hi there,\012First of all you look for a reset button on the motor and press it in with cleaner plugged in and turned on, push the little reset button on the side of the lower base of vacuum. Remember that the brush will not turn in the u ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0262 seconds