Having problems with your Dyson Vacuums ?


Answers :

I am not an expert to this kind of machine but I can share with you this link below which I am sure would be a big help to you. Good luck.

Hi an welcome to Fixya. Most any vacuum you remove the mounting screw then take out the cover cord and switch all at the same time.
\015\012Usually you remove the bottom piece first as you are lifting it out as it will fall away if your not careful then cord and switch.
\015\012You can order the cord here. UK
\015\012There is also a NZ dyson parts store:
\015\012Contact us\015\012Telephone: 0800 397 667
Our customer service team is available Mon-Fri 8.30am to 5.00pm. Email:
[email protected]
Repair Help & Product Troubleshooting for Dyson Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :


I am not an expert to this kind of machine but I can share with you this link below which I am sure would be a big help to you. Good luck. http://www.sparesaver.com/help-and-support/dyson-section/dyson-hints-and-tips-451/dyson-dc03-hints- ... Dyson Vacuums

Two questions: 1. My Dyson howls when it starts but usually the noise decreases with time. What can I do to stop it howling? 2. I've had it for a year and would like to have it professionally serviced. Where can I get it serviced? I live in Kennett Square, PA. Thank you.

... Dyson DC25 All Floors Bagless Upright Vacuum

My Dyson Animal is not picking up very well in the drive position. With the hose the pick up is still very good. I have had it for 2 yrs now with very little problems. I have cleaned out all areas etc pipes, the brush underneath and cant find any blockages. The noise of the dyson is the same as usual. Could you tell me if there is a part that it sounds like it needs?

... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a Polti Vaporetto Lecoaspira 710. I have filled the tank and set the machine up as usual. When I turn it on the boiler pump runs continuously for a minute or so and then the 'beep' begins and the machine shows that the boiler is empty. Obviously the water is not getting through. We don't live in a hard water area so it shouldn't be 'limed -up'. The manual says to leave it to cool down and then try again. That had no effect. The only answer that Polti 'Service' could give me was to try 'G

... Polti Eco Pro 3000 Canister Steam Vacuum

Could I have a short in my cord? I can vacuum & then when I move the canister it shuts off, if I wiggle the cord it will turn back on. This last time, it just revs like a car trying to start & then does nothing. I live in a VERY remote area (80 miles from nearest Wal-Mart or McDonalds) so I know I will not be able to find someone to repair this for me. I have great doubt that I will be able to do it myself & my husband is an accountant so he is unavailable for another 6 weeks!!!!! Any suggestion

Whit the vacume plugged in and turned on start where the cord goes in to it and hold the cord whith each hand and bend it slightly. Move up the cord and do the same if there is a brake in the cord the machine will loose power until you bend the secti ... Miele Red Star Bagged Canister Vacuum

Do you have a dyson service center in tampa bay area?

... Vacuums

Dyson service center locations

... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Dyson animal We bought a Dyson Animal from Sears a few years ago along with a service contract. We took it each year to be serviced. One year I took it because it lost it's suction. They sent it to the factory, but it came back still not working right. We did the same procedure over ands over many times than I can remember. I now have the cleaner in my garage and am using my old vacuum because I just can't seem to get anywhere with Sears. Please help me. We paid almost $600.00 and now it can't b

As someone who works for Sears, let me just say right now.. The service contract you bought sucks.. and does not really do anything for you. it was just a wast of money ( they have a new one now.. thats so much better because you get your money back ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I need to replace the brushbaron my DC17 Animal model Dyson. It's almost four years old. I can't find the correct part number on the Dyson Website and I can't seem to find a Dyson repair center in Albuquerque, NM. What are my alternatives? If I can't service this machine without returning it to Dyson, I won't ever buy another one.

Hi,\015\012\015\012The original Dyson part number for the brush bar (often called brush roll) is: 911961-01\015\012\015\012If you type the above part number into Google Products (click link below) you will get a list of suppli ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Where can I find a dyson service center. my dyson

On the side of the machine somewhere should be the telephone number for the Dyson Helpline.\015\012\015\012Give them a call and they'll point you in the right direction. ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

Why does my dyson dc04 work for about 5 mins then cut out the wire on my dyson 04 needs replacin but i cant get the casing off.

This post may be of assistance: http://www.fixya.com/support/t2842769-fix_new_power_cable_dyson_dc07\015\012\015\012Hope it helps ... Dyson DCO7 Animal Bagless Upright Cyclonic Vacuum

I have a shark vacuum model EP754C with a Euro-Pro powerhead. The vacuum is working, but the powerhead isn't getting power. I checked the powerhead plugged into a different vacuum and it seems okay. I live in London ON Canada...do you have a service depot or service center here?

... Vacuums

I cant get service of compressor GL 90 TG in rajkot and want to know about deler and service centre in rajkot

... Electrolux Epic 6500 Vacuum

My dyson DC04 started to **** a dog toy up the main bit with the brushes - stopped it immediately and removed the toy but since then the suction is still ok/strong with the extension hose picking up but no suction is getting to main scetion/brush area - sounds like a pipe is disconnected from the front area - nothing obvious on the surface....HELP! Thanks in anticipation........... Julie Price

Get a different brand vacuum. Dyson's are easily the worst vacuum I've ever owned. I've tried the DC14, DC25 and DC33 they are all heavy plastic POS's made in Malaysia. I've owned every kind of vacuum under the sun. Rainbow, Kirby, Oreck, Riccar, Seb ... Vacuums

My older Dyson DC14 (the purple one) early model with a clutch on the beater bar belt needs a clutch replacement. The bar has been cleaned and there are no worn or damaged parts so I conclude that the clutch at the motor end of the belt needs to be replaced. I can find the part online but no instructions on how to disassemble the vacuum to get to and replace it. Dysons only advice is to give me the address and phone of the nearest service center. Can you help me?

Have a look at www.dysonmedic.com which has some very useful info on dismantling and repairing Dysons.\015\012\015\012Although this site doesnt actually cover the DC1 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I cant remove my wand on my Dyson vacuum. - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Hi its Darran at Dyson. It is possible that if the hose is blocked that the wand handle may become jammed. For help releasing this, please contact our Helpline on 0800 298 0298 (UK) or 1866MYDYSON (US) and one of our advisors can talk yo ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Dyson My dyson stopped working, and now I cant get it to come on at all, I have cleaned everything.

Proberly fauly cable ,switch,or motor req,all parts can be supplied ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I recently put a call into dyson regarding a problem with my vaccuum and a supervisor was supposed to get back to me. no one has. back in august, we were on the phone with a technician regarding a problem with out machine. after trying a list of things, she said to take it to american vaccuum services and it would be covered by dyson. when i did, the man told me it was clogged and i would owe $45. i would not have taken it for that price! please advise as now i am stuck. i want my vaccuum and th

Unless you can Dyson to intervene and have this repair covered under their warranty, You are stuck to pay for the service. Clogs may not be covered under warranty, but I don't know how their warranty states. If it says that if you have a problem, t ... Vacuums

Sometime when I am vacuuming carpet or a large area rug, my Dyson starts making this loud, horrible, wrenching noise. It stops when I lift one of the wheels up. What is causing this? I have only used my Dyson 3-4 times.

You will need to have the clutch replaced. this is causing your problem. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!

I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Hello- My wand has lost a lot of it's suction. I am sure it's clogged somewhere. I cleaned everything after watching a video on U Tube, but it is still not sucking properly. My model is the Dyson DC28 Animal air muscle. I have only had it a few months. Also, I am not having any luck finding a local Dyson repair shop. I live in Pella, IA. Thank you, Kim

You do have a clog ... I feel certain. I have never worked on a Dyson. Please continue with your disassembly until you find that wad of chewing gum and cat hair and tell us how you did it.\015\012\015\012Im sure you will find a clog som ... Vacuums

How do you put the telescopic wand down? Just got a new dyson 17 and I cant use it cause I cant get the dang wand down..

Make sure your handle is snapped in all the way on to the machine, that will release the clip on the hose to allow for the wand to slide in. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Why does my dyson dc04 work for about 5 mins then cut out the wire on my dyson 04 needs replacin but i cant get the casing off. My DC04 cuts out after abou 5 minutes use. I think there may be a thermal cut-out somewhere?

Thermal cut out in coils of motor,you have not been keeping filers clea,I THINK.\015\012motor is avaliable ... Vacuums

Cant undoe the Dyson in order to clean it - Dyson DC07 Bagless Upright Cyclonic Vacuum

To clean the brush bar area: Lie the machine on its back, look for the three plastic screws under there. Turn them anti-clockwise using a 2p coin (or a quarter if American) and the sole plate comes off that way. This gives you access to the brush bar ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I was putting some bedding in a bag for storage and decided to ''**** it down with my dyson hose to fit it in a smaller space. My dyson quit working and now it will not turn on can you please help...??? I know I didn't **** anything up but I can't live without a vacuum!! I have tried the brush reset button but can't find another reset...

There is no other reset. The Dyson will cut out if it gets too hot, but resets itself when it cools. In doing the job you describe, I doubt that you have operated it long enough to cause overheating, or to do any other damage. I suspect the problem i ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3334 seconds