Having problems with your Dyson Vacuums ?

No suction and rollers not spinning - Dyson Vacuums


Answers :

Hopefully this will help. On the back of the vacuum at the bottom the is a U shaped tube. Depending on what model you have it will either be a thumb release or a quarter turn screw head release. Remove that and check for a plug. Two things can cause the roller to not turn, 1) Broken belt or 2) Shut off switch. On the head, to the right there is a round large knob with a pointer, it must point to the lines (or carpet). If in the other position it is shut off for bare floors. Remember that it automaticly shuts off when the handle is in the upright position.
Repair Help & Product Troubleshooting for Dyson Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No suction and rollers not spinning - Dyson Vacuums


Hopefully this will help. On the back of the vacuum at the bottom the is a U shaped tube. Depending on what model you have it will either be a thumb release or a quarter turn screw head release. Remove that and check for a plug. Two things can ca ... Dyson Vacuums

Hoover Model# U8185-900 Problem: No suction, not engaging Vacuum cleaner roller spins as usual, but there's no suction when trying to vacuum the carpet. Can anyone point me in the right direction? Tha


... Hoover U8185-900 Upright Vacuum

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!


I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Dyson Animal has good suction and works fine for actually picking up dirt, but when I use the vacuum with the roller, I hear a grinding/rumbling noise. Its only when I use the vacuum with the brush rotating. It does not happen hen I shut the roller brush off. The belt is fine. I cannot figure out what is wrong as there are no clogs, debris, or foreign objects stuck in the brush or in the belt. The noise seems to be the only issue. The vacuum picks up fine. It just doesn't sound right a


Trace the path of the suction into the tank and see if there is anything loose or ingested.\015\012Also, remove the brush and clean as best you can. Perhaps there is something caught in it. Lubricate where it makes sense with some WD40. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

The roller on my Dyson vacuum has stopped rotating (I still have suction) I have checked the belt (not Broken) and have checked and cleaned the roller and spindle and also checked the "auto" button setting on the vacuum but to no avail ... Anybody have any clue as to the problem Many thanks


... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Dyson DC24/ all floors, serial number 530-US-D78353 that I have registered already w/ your company. The vacuum is generating suction from the main outlet (that goes to the canister)///but once I place the canister into position..there is no suction from the floor foot. The roller is working/spinning, but no suction..picks up nothing, I have cleaned and rechecked all filters and can not figure out why I suddenly have no suction. Appreciate your input and/or advise where there is a local


... Dyson Ball DC24 Bagless Upright Vacuum

Its like the roller brush won't lower and it doesn't "engage" anymore. I posted this but input the wrong vacuum model ....not sure if that matters? I can vacuum and you still see footprints on the carpet. I have suction, just no brush action, yet the brush spins....


Sorry about that, I guess I have to post this as a solution in order for the pictures to display. Here's the entire solution on a similar problem that I've answered previously. Please let me know if you need help further diagnosing the machine, I ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC24 will not pick up despite the rollers are spinning.(i have cleaned the rollers) All the filters have been changed. When usng the hose after a second a loud hiss can be heard and then no suction. Please advise


I have the feeling you have something stuck somewhere at the hose. carefully use a clothe hanger and clean inside the hose. use a flashlight to see the object. ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

Dyson dc25 roller bar works but no suction - Dyson DC25 Animal Bagless Upright Vacuum


Hi there,I'm sorry to hear you're having difficulties with your DC25. If the machine doesn't seem to be picking up as well as usual, this may be due to a blockage. The filters may also need a wash.The easiest way to locate and remove ... Dyson DC25 Animal Bagless Upright Vacuum

Dyson 28 animal. When I start the vacuum the roller spins for a couple of seconds the stops. I have to turn machine off and on again then the roller will work for another couple of seconds.


... Dyson DC28 Animal Bagless Upright Vacuum

I was vacuuming with the Dyson DC 17 and sucked up a berber carpet string by accident and after cutting and pulling it all out of the bottom brush part, the brush no longer spins but the suction part works. What do I do?


The belt could be snapped. If this model has a brush protected belt then it has to be repaired by a service call. If however you can get to the brush roll belt by removing the bottom sole plate (turning over the vacuum so that you're looking at the b ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson 50 spinning but no suction - Vacuums


... Vacuums

Brush wont spin and no suction through hose - Dyson Ball DC24 Bagless Upright Vacuum


Hi there,I'm sorry to hear you're having difficulties with your DC24. This machine is equipped with a safety device which shuts off the brushbar if something jams it. After you've checked the cleaner head for obstructions and removed any thre ... Dyson Ball DC24 Bagless Upright Vacuum

I have the Dyson DC14 and its like it's not brushing the carpet anymore, The brush is spinning, but its like it isn't self adjusting to the carpet height? It still has suction, but doesn't make the same sound it used to when you'd start vacuuming. Its like it never adjusts anymore???


Hi its Darran at Dyson.It sounds as though the internal hose underneath the machine has twisted slightly. With the machine switched off, lay it on its side and look at the base. You should be able to see a small corrigated hose. Simply t ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My dyson has suction with the handpiece, but makes a horrible noise when using it upright. The roller does spin in the upright position. Help!


... Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum

Brush doesn't spin. no suction felt at brush - Dyson DC14 All floors Bagless Upright Cyclonic Vacuum


Check that the brush has not become fouled with string, etc. If it still doesn't work try the following.\015\012\015\012Some Dyson's have a switch for the brush on the front of the handle. If yours does, please make sure its on. This m ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

I have a dyson dc07 upright which no longer picks up lent and hair. The roller brush is not spinning when the vacuum is turned on. How can I tell if it is the belt that needs to be replaced or the clutch and belts?


Need replaced Clutch Assy and Brushbar \015\012\015\012Clutch Assy part no:900252-04\015\012\015\012Brushbar Assy part no:904174-01\015\012\015\012try cleaning all Hose\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson vacuum has no suction but beater bar spins


... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson roller stopped spinning - Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum


I had the same problem hit the reset button never heard a click but it started spinning again! ... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

My dyson roller ball vacuum cleaner has lost suction i suspect it's blocked how can i take it apart to check?


... Dyson Ball DC24 Bagless Upright Vacuum

Roller does not spin - Dyson DC07 Bagless Upright Cyclonic Vacuum


A broken belt is the most common cause. Check and replace. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dirt Devil M088600 roller doesn't spin, no suction...


Check the belt ... Dirt Devil Featherlight Bagless Upright Vacuum

My vacuum has suction with the long tube assembly but not any significant suction down by the rollers. I assume there is a clog or a problem between where the hose attaches to the machine and the rollers but I can't figure out where to look for it. HELP. I've only had this vacuum for a few months and I'm really dissapointed!


Go to the bottom of the machine and to the rhs of the rollers you can see the pipe - also remove hex panel on back and remove hose from elbow , i also found that a filter cx did wonders ... Miele S7210 Bagged Upright Vacuum

Kenmore Canister Vacuum (model 21513001) - Suction, no. Spin, yes


... Kenmore Straight Suction 20185 Vacuum

My dyson vacuum cleaner doesn't seem to have the same suction power it used to. I have cleaned out the canister and have taken apart the vacuum head (for cleaning carpets) and it doesn't seem to be blocked but it seems to lose suction by the time it reaches the head. The suction is strong at the end of the hose (where you attach the telescopic attachment with vacuum head) Any ideas? Thanks, Irene


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1092 seconds