Having problems with your Dyson Vacuums ?

My dyson dc 35 bin there is a trap door in the neck how do I get it back in

\015 The bin on my dyson dc35 has a trap door in the neck witch opens when in uses has come out\015

Answers :

Repair Help & Product Troubleshooting for Dyson Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dyson dc 35 bin there is a trap door in the neck how do I get it back in


... Dyson Vacuums

Dyson DC07 bin trapdoor won't stay closed: The small plastic piece on the tip of the center rod on the cylone assembly broke off, so my trap door won't stay closed. Any idea how to find just that part, so I don't have to replace the entire cylone part?


You can buy that part here: Dyson DC07 Spares ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Broken trap door on dirt bin, can I just replace the door or do I need the whole bin


I have the same problem, and found the "trap door" available at http://platinumvacuum.com/dyson-dc07-bin-base-assembly-904279-10.html ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC07 cyclone release catch will not click (lock) back into position after removing the clear bin assembly to empty the bin.


... Dyson DC07 Bagless Upright Cyclonic Vacuum

How do i put the u shape trap back onto my dyson


Which model of Dyson would be helpful ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson dc 07 bin door - Vacuums


... Vacuums

I have a Liftmaster garage door opener and the garage door faces south. Normally the opener works great except at certain times on a sunny day.The sunlight is not directly hitting one of the sensors but the door will comedown as far as half way and then it will go back up and the lights will flash. If I go inside and use the button I can hold it down until the door is fully closed. However, sure is a pain to have to take the car out, go back into the garage, shut the door and then leave the h


Sounds like a problem with a limit switch or something getting in the way of the electric eye that interrupts for safety reasons. \015\012Clean the electric eye transmitter and sensor of debris and cobwebs and make sure the wires are attached properl ... Vacuums

I recently put a call into dyson regarding a problem with my vaccuum and a supervisor was supposed to get back to me. no one has. back in august, we were on the phone with a technician regarding a problem with out machine. after trying a list of things, she said to take it to american vaccuum services and it would be covered by dyson. when i did, the man told me it was clogged and i would owe $45. i would not have taken it for that price! please advise as now i am stuck. i want my vaccuum and th


Unless you can Dyson to intervene and have this repair covered under their warranty, You are stuck to pay for the service. Clogs may not be covered under warranty, but I don't know how their warranty states. If it says that if you have a problem, t ... Vacuums

GE Spacemaker Microwave PVM1870 fan keeps running after door closed and won't shut off. Have to open door or unplug. As soon as door is closed and plug is back in, fan starts up. If door handle is pressed downward, microwave starts! If door handle is raised, fan shuts off but light stays on.


... Vacuums

This dyson dc15 is pulling to one side not sure what it could be, also the wheels at the back dont seem to be staying down the are flipping back up when trying to stand it up, can anybody advise what


Look at the guide ... Vacuums

I have a Dyson DC17 and the clear bin won't lock into place. The bin is clear, and the filter is clean. I have to hold the bin against the base while vacuuming, which is quite a hassle. Any thoughts?


Is the rubber seal properly seated? ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have an animal dyson. The front nose dives into the carpet when moving the dyson in the forward motion, fine when pulling back. A huge amount of effort is required to move it forward. Took it to a technician and he said he could find nothing wrong. He had only short nap carpet for test. Works fine on short nap, if the carpet nap has any lenght to it like shag, the dyson severly nose dives. It's like the nose is sucked into the carpet. This problem just occured after the wife used the ho


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

How do I reattach bin on my dyson? - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


Place the bin on top of the filter housing, with the bin tilted slightly away from the vacuum, then while the bin pressing down and towards the vacuum keep pressing until you hear it 'click' onto the latch. Sometimes it helps to lift up the latch whi ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My dyson animal's clear bin latch is stuck and won't release. I can't take off the bin via the outer shroud release either.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Sharp R-1480. Microwave would not start - jarred door, and it heated and worked. Replaced bottom of the 3 inter-lock door switches. Turns back on - all seems normal. No heat (it does overall sound louder). Thanks, Mark [email protected]


Hi Mark,It sounds like you have a magnetron problem now or at very least a rectifier that is shorted. The elevated sound level comes from one of those two components. But since you had a door switch problem I would lean toward ... Vacuums

My dyson's canister will not snap back. I just emptied it and now it will not snap back... Whats going on?


... Vacuums

My dyson hand held shuts down after about 30 seconds, It turns back on again, but it does this over and over again, even after being fully charged with caontainer emptied. Its almost like an overheating thing, but different since it starts right back. It is annoying.


... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

Dyson Quits My Dyson quits after running a few minutes. Than starts back up after a bit.


Cut out switch on the motor needs replacing this overheats and cuts of the motor when the motor cools down it will start again you have to keep both filters and cyclone clean and free of dust or after replacement the same will happen again ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Plugged my Dyson in this morning, switched it on and power came on for not even a second and died. No power what so ever to dyson - checked my house sockets, changed fuse. Still not working - dead as a door mouse. What could it be? Many thanks Sam


It is either your power cable, cable rewind mechanism or your motor. \012\012Try switching it on, and wiggling the lead near the plug and see if it fires up. If it does, remove the moulded plug and fit a standard plug. \012\012If not, lik ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!


I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson 25 animal won't go back into the stand up position...what is wrong and how can I get it back up?


I unscrewed the side panel (left side looking from rear of vac), it is gray and shaped a bit like a "C" or elbow joint and that let me get to the metal bar in the red foot pedal. I needed to move the metal bar so that it would slide along the grove i ... Vacuums

Dyson animal We bought a Dyson Animal from Sears a few years ago along with a service contract. We took it each year to be serviced. One year I took it because it lost it's suction. They sent it to the factory, but it came back still not working right. We did the same procedure over ands over many times than I can remember. I now have the cleaner in my garage and am using my old vacuum because I just can't seem to get anywhere with Sears. Please help me. We paid almost $600.00 and now it can't b


As someone who works for Sears, let me just say right now.. The service contract you bought sucks.. and does not really do anything for you. it was just a wast of money ( they have a new one now.. thats so much better because you get your money back ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Jammed release bin latch on dyson ball - Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum


... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

Today i was hoovering, and then my dyson just cut out! i left it a few hours then went back to it, it gave a little noise when i switched it on, then again i tried but it failed to come on! ive even changed the fuse in the plug! and now my dyson wont turn on at all, ive cleaned everything there is too clean! help! :D


It looks like you need a professional repair. If you're really lucky this may just be a break in the flex, or the switch has failed - both relatively cheap and simple to sort out. More likely, though, is a problem with the motor (carbon brushes worn ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0555 seconds