Having problems with your Dyson Vacuums ?

I cannot remove the canister on my DC07 Animal

\015 Vacuum works fine. The release to remove the cansiter from the device is not working so I cannot get it off the machine to empty it\015

Answers :

Repair Help & Product Troubleshooting for Dyson Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I cannot remove the canister on my DC07 Animal


... Dyson Vacuums

My DC 17 is plugged. I can see through the small hole in the top blue "flower shaped" that the holes at the top of the canister are plugged with hair & dirt. I cannot see anyway to get to these small round holes. Is there a way to remove the top blue "flower shaped" piece? I have removed the inner cone from the clear canister but still cannot get up underneath.


Please kindly follow the steps below to clean your vaccum cleaner,1.) Remove the clear plastic handle. You\015\012will have to take out two screws and then unclip from the from the\015\012front. It's stiff, I gently used a flat head screw drive ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Samsung Quiet Storm Canister Vacuum VAC-9049 The motor will not run. Power is on to the motorized rug tool. How can I remove the upper housing to get access to the motor? I have removed the six visible screws, but the housing is restrained at the rear. I suspect there are additional screws under the power switch and cord retractor assembly, but I cannot remove that either. HELP!


Hi Daltm,\015\012Thank you for contacting Fixya. This is Anil.\015\012I understand that you need assistance n opening the Samsung Vaccum VAC-9049 motor. I will be glad to help you with it.\015\012Please go through ... Samsung Quiet Storm 9048R Bagged Canister Vacuum

I have a Dyson DC23 animal canister. This is the first time I emptied the canister. After putting it back on, the vacuum won't start. I have removed and reseated the canister several times, also attachments, but it will not start. Help!


... Dyson DC23ACTUSC Bagless Canister Cyclonic Vacuum

How do I remove top of dirt canister on my Dirt Devil Model UD70010 Bagless Vacuum? Dirt is stuck inside canister and I cannot get it out.


... Dirt Devil Vacuums

My dyson DC07 animal does not have the suction it once had I saw a dyson program that showed a filter in the top of the canister I was just aware of the filter around the wheel. Is there one on top of the canister and how do you get to it


Hi\012\012The DC04 Dyson has a filter at the top, but the DC07 has one at the side on the bottom and one underneath the cylender.\012\012Take all the parts off your dyson and throw them in the washing machine and then put them ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson dc07 The rotating brush on the bottom of my vacuum was filled with strings. I removed the brush by undoing all yellow plastic screws from plate. Removed all strings and replaced as best I could and it was hard to get the brush back in and the belt around it. I dont have my manual but it fits so it should be correct....? Right? No, not true, because when I turn it on and try to and vacuum (by lower canister with foot release) it makes that terrible ratching sound). Please help


The loud ratching is a warning to tell you that there is something stopping the roller bar from rotating this is a very common thing lay the machine on the floor front side down take off the bottom plate and just check the belt is in the centre of th ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Need to remove the clutch on my Dyson DC07 animal and I can't get the clutch cover off. All the videos look like it should come off easy after removing the three screws.


... Vacuums

On the DC07, the entire cyclone assembly must be removed to empty the dust, debris, etc. collected when vacuuming. On the top of the cyclone is a "trigger" that you lift with your finger to release the bottom catch, which allows a clear flap to open on the "clear bin," thus letting all the debris fall out. My problem is when you lift the finger trigger, it does not release the catch on the bottom. Since the catch won't release, I cannot remove the entire clear bin either from the cyclone.Any sug


Beofre you go to the extent of buying a replacement canister, you can remove the top and using a straightened coat hanger type thing open that bottom lid. Then maybe you can clean the rim and possibly add some silicone spry to loosen things up. Here' ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Why won't my dyson DC07 Animal turn on when the wand is removed?


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have an Aerus Guardian canister vacuum with a clogged hose. The tiny stuffed animal toy is lodged right below where the swivel handle meets the hose. Switching the air flow does not dislodge it. I would like to remove the handle from the hose. Any suggestions?


Consider this. If your vacuum is still under warranty, removing the hose will void the warranty on the hose. I strongly recommend calling an authorized dealer/consultant.\012Although it may seem to be fairly simple to remove the handle, there ... Electrolux Guardian Bagged Canister Vacuum

Removal of drive belt on dc 07 full kit - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

RE: DYSON DC07. Cleaning the roller I removed one end and cleaned it. Cannot get the roller back on the vaccum. If you could give me instructions on how to do this I would be very appreciated. Thank You


Try this link. http://www.sparesaver.com/help-and-suppor ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

I have a dyson animal dc07. The base does not lower so I cannot vacuum the floor. I push on the "foot pedal" area and it is not budging. Can you help? Thanks


Have a look atwww.dysonmedic.comwhich has some great info on repairing your machine. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson dc25 animal: cannot remove the telescope reach wand.


The hose is getting twisted on the machine and so the wand gets stuck in the hose.\015\012\015\0121) Pull the wand out as far as you can - if you can pull it out completely, separate it from the hose and apply baby powder to the \01 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My DC07 animal vacuum canister won't stay closed.


Maybe the clip is just bent ... Vacuums

I have the dyson dc07 all floors and have a new belt- I have removed the black cover but cannot see where to attach the new belt ! Hope you can help-Carole


Hi there Carole, VacuumGuru here. \015\012I have made a video on how to access the ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Cannot put handle on dyson - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


Hi,Did you receive the handle with the wand already attached? It should be. Then, to get it into the hose pres the wand release button on the end of the hose and slide the wand into the hose. The wand should then be pushed into the slot o ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have a dyson dc07 original that i bought used. Last owner was obviously a pet owner and the machine smells too bad to even turn on in the house...can I clean the canister with water? What other parts can get wet or is there a better way to remove the odor?


Put some vac freshner in the canister put the vac out side if its fine plug in and switch on leave runing for around 10 minutes that should solve the odour ... Dyson DC07 Bagless Upright Cyclonic Vacuum

DC07 DYSON REPLACEMENT HOSE. HOW DO YOU REMOVE IT FROM THE HANDLE. I have a kenmore whispertone 8540 canister vaccum. The electrical wires (3) to power the beater are embedded in the hose, in a spiral fashion. The yokes that hold the hose on both ends (and attach to the beater on one end and the unit on the other) have no screws or pressure latches; i don't want to use brute force as i may damage the attachment device inside the yoke. If someone can tell me the trick to get these yokes off each


Should be a pry off dot on the underside revealing a screw ... Vacuums

My DC07 dyson animal has no suction when i put it on carpet mode. The beater, canister, and filter are cleaned and there are no clogs. Any more suggestions?


If you've tried everything else and still just don't have suction, try this:\015\012\015\012http://www.ehow.com/how_5870417_modi ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dead motor I purchased a new motor for my Dyson Animal but I cannot figure out how to get the thing apart to replace it. There are weird star shaped screws but I can't even see how removing those would get me where i need to be. HELP!!!


Ace Hardware or Home Depot should have your star screws ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Dyson DC07 Filter Release Catch removal


If its the part im thinking of its a small spade like catch thats glued into a hole in the chassis normally id lay the machine on its front and gently tap the old catch out with a flat end screwdriver and a small hammer be carefull its very brittle ... Dyson DC07 Bagless Upright Cyclonic Vacuum

How do I remove the collar to replace the cord to the power bar, I have the part, cannot get the little collar off to connect the new wire, purple to white and white to black... cannot get the old wir


... Hoover Powermax S3530 Bagged Canister Vacuum

The removable filter at the front is cleaned regularly, and is not clogged. However, the machine appears to be suffering from being clogged by dust, as it has started to make a high pitched noise, and I fear it may burn out. I can see some dust inside the front panel but cannot see how to remove the front to clean it out. (NB. I have located two screws - one on either side - but cannot see how to proceed further.) Please help! Thank you.


\015\012\015\012Hi,Here\015\012is a tip that I wrote about my Bissel but I bet you have the same\015\012problem and the hose is clogged...Bissell Bagless Upright\015\012 ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0546 seconds