Having problems with your Electrolux Centralux Vacuum ?

My centralux has minimal suction.

\015 I emptied the canister and wiped the sponge filter off and almost no suction. I can hear the vacuum when I plug in the hose and turn on the switch. What do I look for?\015

Answers :

Your supposed to WASH the sponger fileter out thouroughly NOT wipe it off. the dirt is in the poors thats why the air can't get through. At this point i would replace the filter if its never really been washed.
Repair Help & Product Troubleshooting for Electrolux Centralux Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My centralux has minimal suction.


Your supposed to WASH the sponger fileter out thouroughly NOT wipe it off. the dirt is in the poors thats why the air can't get through. At this point i would replace the filter if its never really been washed. ... Electrolux Centralux Vacuum

My A 2045 Karcher vacuum's suction is really weak and the motor seems to be working VERY hard. The motor sounds like it used to when the vacuum fell over and went into overdrive! Now it's in overdrive all the time and the suction is minimal. Nothing is blocked and the filter is clean and dry. What do I need to do?


... Karcher K DS 5500 Vacuum

Suction centralux vacuum two years old doesn't have the volume air movement it once had. Unit will still quickly reach an extremely high head of suction so no broken pipes. ran napkins thru no blockage, overode filter safety switch ran with out filter no difference. just don't move air like it used to


Hi!!! clean motor blower blades ,they collect alot of duct and the air in chopped,Good luck.Clean blower fan blades.. ... Electrolux Centralux Vacuum

Have a Centralux Aerus about 5 years old. Don't see a model number. There is suction but beater brush quit working. Was using for a few minutes, shut it off for a few minutes, turned it back on and suction only. Tried the reset button also. Tried the sidekick attachment and it works fine. There was no smell like something was hot. Belt is fine. Are there any fuses or anything else to try? This vacuum cleaner has not really been used that much, it is hard to believe the motor would need replaced


There probably is a loose wire in the handle near the switch or a wire off near the swivel elbow near the vac power head. With the right fastener tool to remove some screws you can fix it yourself ... Electrolux Centralux Vacuum

Sounds like suctions gets clogged after a second or two being powered on. - minimal suction.


... Sharper Image Dyson Slim DC18 All Floors Vacuum

Hi I need help because I have a problem with my Electrolux Centralux Central Vac system in my house. When I plug the vac hose in the central vac socket at first I heard the motor running very gently with NO suction then after a minute or so it went completely dead and they is NO motor sound, suction, or anything happening what so ever. Can anyone tell me what this problem is???


Have you checked for a clog in the lines or in the hose? If there is no clog in the system anywhere, then your motor could be dying. ... Electrolux Centralux Vacuum

My Dirt Devil M082476 Full Bag indicator light keeps coming on when I turn my vacum up to full intensity. I have tried changing the bag and checked that all hose is clear. If I leave the vacum on low intensity the suction is minimal and does not increas when I turn up the suction. Is there a solution to this? I look forward to your response


... Dirt Devil M084105 Jaguar Vacuum

Powerhead woes Drive belt for power head beater brush on Hoover S3755 keeps jumping off drive motor shaft when vacuuming low pile carpets like oriental rugs unless minimal suction is used. Any tricks to keeping the belt in place other than this?


I've had my Hoover S3755 for about 2 years and loved it, at least until the last couple of months when the "belt slipping off" problem started. I changed the belt and the vacuum would work for a little while then the belt would come off again. I pu ... Hoover S3755 WindTunnel Bagless Canister Vacuum

Minimal Loss of suction on a Miele Gold Horizon Canister?


... Vacuums

No suction - Electrolux Centralux Vacuum


If this is an Electrolux, start by testing the suction at the inlet nearest the vac or at the 30 degree elbow on the left. If you have suction there but not elsewhere, and can hear the vac running when the hose is plugged in you have blockage in your ... Electrolux Centralux Vacuum

I have the ultimate G The belt is on, new bag, vacuum runs but no roller rotation and minimal if any suction????


Check that the pipe between the floor pick-up and the bag is not blocked. This occurs frequently on up-right vacuums - look from both the bag side and the machine underside. \012\012See if you can turn the brush by hand and look to see ... Kirby Ultimate G Bagged Upright Vacuum

It shows only 2 bars of performance. The suction is minimal. I don't see a blockage, the filter is cleaned and it has a new bag. The vacuum is eleven years old. Can it be fixed or do I need to replace it.


Depending on the brand of machine its a call you have to make . If it is a dept store machine I would recommend replacing it as the brushes in the motor are most likely worn out. Anyways I would go to local vacuum shop and inquire about a re furbish ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Have an electrolux 2100 canister vac, it has lost suction power thru the years. no clogs in newer hose or in sweeper. even with new bag, filter and belt only increases power minimally.


Have you ever over the years replaced your brushroll ? Have you tried dropping a coin thru the hose from one end to see if it comes out the other end ? Have you taken the wand loose from the elbow ( the swivel part of your carpet sweeper) to see if t ... Electrolux Vacuums

Troubleshooting i have a rainbow vacuum model D4C that has minimal suction power. hose if free and clear, but i am missing the gasket that fits under motor. could thius be the problem?


That gasket is a water seal, but it can impact the suction, the top of the water tank can't seal without it. ... Vacuums

Bissell 6596 bagless turbo - minimal suction & burning smell


You can reach the motor, however your motor is no longer in operable condition. This is what you hear when you turn it on. You must replace the motor for this to go away. Below is the motor part number if you would like to replace it. It will cost ... Bissell 6594 PowerForce Bagless Upright Vacuum

There is minimal suction in the hose. Nothing appears to be blocking the hose.


You most likely have a gasket out of place.\015\0121. On the bottom, there is a panel held in by two screws. Open that up. Inside you will see a white gasket that should be aligned with the hole. If it is not aligned, you will not get good s ... Bissell 9200 Upright Vacuum

No suction on Powerhead


Sounds like their is a pressure loss somewhere along the lines. Without more detailed info, i can only tell you its a pressure loss, some further looking into it we may be able to determine where that loss is coming from, but there is pressure loss. ... Electrolux Centralux Vacuum

Bissell Proheat 1699 won't spray from main/min. suction


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

No suction from my kirby sentria


I just took a stiff piece of coax cable, and took the bag off where it attaches to the main unit, and took the head off ( the part with the brush roll in it) AMD cleaned every thing really well, turning the spindle for the fan while " snaking" it and ... Kirby Ultimate G Bagged Upright Vacuum

Dyson has lost suction and loud noise from base(?),


I had the same problem, from right out of the box. Now that I just threw mine out, I see this site that indicates there's a fix for it: ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Lack of suction even with filter removed.


I used to be a service manager for Electrolux. It sounds like possibly a clogged fan or hose. Take the hose off and check the amount of vacuum at the opening of the cleaner. If it has more suction without the hose, hold the hose in place backwards ... Electrolux UltraLux 2000 Bagged Canister Vacuum

No suction Just received my refurb. dyson animal bagless. Finally figured out how to get it all together, turned it on and there is no suction coming up thru the beater bar. The hair is just collecting around the bar and not going up into the canister. It appears all the suction is going thru the open red end of the attachment hose, which has a vented cover piece. Am I missing a piece or is there a switch to turn of the attachment suction?


So the red hose isn't connected to a part on the vaccum so like it is connected to the connester but not to an opening just above the beater bar, this is the only idea i can supply you with. good luck, maybe i got lucky and helped you out. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Suction Cover The suction cover of my Eureka Deep Steam 2575A is broken - the tabs snapped off of the cover so I am unable to screw the suction cover back on. I need to purchase a new suction cover but can't find one anywhere. Anyone know what I can do? thanks


The exact same thing happened to me. i just called and ordered it from eureka. the number is 1-800-282-2886. the cover cost 13.07 and the s ... Eureka 2576A Steam Vacuum

No suction I am getting no suction on my central vac at the vac. I do not believe that the piping is plugged up, the vacuum is not creating suction. What are the causes of no suction at the vacuum and how do I take the top half of the Nutone central vac off?


Use the guide at builtinvacuum.com/flowchrt.html to find the issue and solution. Most likely you need to test it without any filter and be sure the bottom of the unit is attached :) To get access to the motors you need to unbolt the very top sides. ... Broan-NuTone CV350 Performance Bagged Central System Vacuum

Hi my dyson dc18 has great suction from wand but when you got to use the vac for floors little suction but wand still got suction even while vacuming floors is it suposed to stop suction from wand


My Dyson dc18 had the same symptoms. The wand worked well and the floor bar had no suction. After removing pieces & shoving my fingers into the machine (no blockage) I found the suction pipe rotates between two positions (floor and wand). It look ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0408 seconds