Having problems with your Electrolux Centralux Vacuum ?

My beater bar doesn't work on my power nozzle


Answers :

First make sure you have power at the valve if you have a Direct Connect\015\012 (no cord on end of hose) style valve. If it happens at every valve, you may have a bad switch in the handle or a loose wire where the handle meets the hose. If it's still under warranty contact the store. If it's not I would recommend you still take it the store as removing the handle, reattaching the wire (after slightly crimping) and putting the handle back on without bending the fingers that contact the concentric rings on the hose is tricky at best and is better left to someone familiar with the operation. I didn't read your original post concerning the sidekick, so I don't know if your problem exists at the end of the wands or when you attach directly to the handle. If it's at the handle you won't need to take your wands into the store, otherwise take your hose, wands and electric attachments.
Hello,
\015\012
\015\012This could be caused by a few problems. I happened to notice a different repair that you posted about your Sidekick handheld power head also not working. Is this correct that you have two motorized attachments that don't work? If this is the case, this sounds like your electrical hose has gone bad, and has a short circuit somewhere inside of it.
\015\012
\015\012You may verify this by using a simple Continuity Tester that you may pick up at any Hardware store. Simply place one of the testing prongs into the wire harness at the end of the hose that connects into the wand, and the other arm of the tester on one of the prongs that plugs into the wall. If the tester doesn't light up, move the one prong into the other electrical connection on the end of the hose that connects to the wand.
\015\012
\015\012If neither one of these ports lights the tester up, then this indicates your hose has gone bad and needs to be replaced. Unfortunately there's really no way to repair the hose once it has a short circuit.
\015\012
\015\012Here's a link to a replacement hose on our website that will work with your Electrolux Central Vacuum:
\015\012http://www.govacuum.com/elcevareho30.html
\015\012
\015\012If you do have continuity in the hose, then try pushing the reset button on the power nozzle (small red pole on the right hand side). If you indeed however do have two different attachments that don't turn on, chances are most likely that your hose needs to be replaced.
\015\012
\015\012I hope this was helpful to you in answering your question. If this helped, please be so kind and rate my repair helpful, or leave feedback for me. This is really appreciated by the Fixya community when an answer was able to fix your problem.
\015\012
\015\012Thanks again,
\015\012
\015\012Chris Jones
\015\012GoVacuum.com
Repair Help & Product Troubleshooting for Electrolux Centralux Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The beater bar motor doenst work when i push the bar button the bar button doesnt light up like power button how can i test bar motor or bar switch or what is the common problem wiyh this model I have 2 that dont work the same way


If it do not work ...and you already are on the second one that behaved in the same way it may be a problem with the power in your place and the cause it may be the main fuse...Im not sure where is located in this model but it has to be near the powe ... Vacuums

Seems to be a short in the power nozzle (light and beater bar sporadically work) while suction is just fine. How to fix the short?


I am having the same problem...great suction but unit on the floor won't vaccuum. I hit the reset button and the rollar still won't work! ... Electrolux Central Vacuum

My beater bar doesn't work on my power nozzle


First make sure you have power at the valve if you have a Direct Connect\015\012 (no cord on end of hose) style valve. If it happens at every valve, you may have a bad switch in the handle or a loose wire where the handle meets the hose. If it's stil ... Electrolux Centralux Vacuum

My power nozzle has stopped working. The vacuum itself is still working but not the power bar. I would like to order a power nozzle. Can you tell me how I can order a nozzle for a Kenmore Whisper Belt 12.0 amps


... Kenmore 23313 Whispertone Bagged Canister Vacuum

The power to rotate the beater bar only works half the time..it seems to be very positional. In the past I could get it to work, now it just won't turn. Have tried the re-set button . Expensive vaccum with poor reliablility!


Is the power nozzle motor itself not working? If it's not, the problem could be the wiring, the switch, the vacuum power switch, the connectors from hose to machine, or the circuit board in the machine.\015\012My best guess would be the connec ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Kenmore model 116 58015700 power mate beater bar stops working


Just pulled mine apart and the bearing on the belt side is toast.\012In the past five years I have had several items fail due to less then optimal bearings. Including a transmission in a Vibe and a front load washing machine. ... Kenmore Vacuums

I am looking for a replacement "beater bar" -roller brush for my Centralux power nozzle model # N106M. Thanks, khaler45


They have all product replacements on the Manufacturers web sites. ... Electrolux Centralux Vacuum

I have a hayden premier supervac central vac system, while working on the switch in for the beater bar, the actual unit has turned off, the green light is no longer lit, is there a fuse on it somewhere or a reset button, i have tried unplugging it and replugging it in, but can not seem to get it to power up now?


Should be a reset on the main unit near the top ... Vacuums

My Dyson DC17 beater bar motor works intermittedly. I have to almost whack it on the floor to turn it on and then shuts off again. I have checked the belt and it is fine, also have checked for blockages. The switch to turn the beater bar on or off will not work when the beater bar motor is off. the suction is fine though.


Buy a Kenmore for less money ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a dyson DC28 vacuum and the power button flashes on and off and the beater bar quit turning. I turned it over and found some string caught on the beater bar which I removed, but the beater bar still does'nt turn and the power button still flashes on and off. I hope you can give me a solution to this problem.


I had the same symptom with my wife's DC28. The problem was associated with the cam driven height adjustment mechanism. The beater bar must rock freely up and down when pressing on the tabs that the end cam lobes actuate. On ours I found hair and cru ... Dyson DC28 Animal Bagless Upright Vacuum

Windtunnel first one used 6 times beater bar stopped working, took apart cleaned and belt was fine. this one had a reset switch for beater bar. had insurance at best buy so returned for a new one. used 2x beater bar not working and not dirty, no reset switch on this one., now back to the store for another? i don't even want the same one. I wonder how many they are gonna give me. This seems to be a common occurance.


Sorry, you feel like that. I have rentals and 6 windtunnel's (I prefer the bagged ones) and have never had a problem such as you have described. I think Hoover makes a great vacuum. ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Unit powers up but beater bar does not rotate


Have you checked the belt that drives the beater bar? ... Kenmore 22812 Bagged Canister Vacuum

Dyson DC35 beater bar stays on when power button isn't pushed


... Dyson DC35 Multi Floor Digital Slim Cordless Vacuum

I was vacuuming with my DC28 Animal and all fo a sudden the beater bar stopped working and NONE of the floor mode buttons work.. no lights or anyhting. I checked for obstructions per the Dyson manua


... Dyson DC28 Animal Bagless Upright Vacuum

I was vacuuming with the regular nozzle and all was well. Then I changed to the powered nozzle and the 2nd power level wouldn't work and then when I detached the powered nozzle I was unable to turn it ....there was no suction. The lights are on for low and high level but not middle level power.


... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

I have a DC25 that I just bought in Dec 10. The last few times I vacuumed the carpet, the beater bar worked on and off. Now it does not move at all. I took off the beater bar to see if there were any obstructions, but there were none. Could you please help me with this. Right now my husband is saying that we should not have bought such an expensive vacuum (which he has said all along). I want to prove him wrong!! Up til a couple of weeks ago, it was working perfectly and I have loved it!


This is a good quality machine which I am sure wil last a long time in answer to your question make sure that the setting is set for carpet and not just flooring ..the head needs to be flat on the floor for the beater to work .I am assuming that thi ... Dyson DC25 All Floors Bagless Upright Vacuum

While vacuuming the beater bar shuts off all by itself, the main power source stays on. I touch the power button on the beater bar to start it again and it shortly after shuts off again. why is this happening?


... Dyson Stowaway DC23 Bagless Canister Cyclonic Vacuum

My Electrolux central vacuum power nozzzle was working hit/miss and now has stopped working. The metal connectors in the wand and power nozzle get very hot, enough to burn. The metal connectors also


... Electrolux Central Vacuum

Electrolux oxygen canister vacuum beater bar attachment not working


... Electrolux Vacuums

Beater bar doesn't work


... Kenmore Vacuums

Power nozzle of my S3670 does not work (vacuum itself does work), the headlight bulb in the nozzle is broken. This happened in the past several times - we would bring the vacuum to service center - I don't know what they did other than replacing the bulb. I decided to go to ACE and buy replacement bulb myself, replaced the one in the nozzle - this did not fix the problem. I don't see any fuzes or anything in the nozzle. However, the manuals says to "Use only HOOVER part no. 27317307, which is a


... Hoover S3670 Bagged Canister Vacuum

Electrolux Epic 6500 SR ...no power to power nozzle. I think it is the switch in the handle because if I use my friend's hose/handle (same model), my power nozzle works fine when I turn on the switch. If you think it is the switch, can I get a part for it?


That's about the best one to narrow down a problem, however, there could also be a break in your hose wiring. Switches, hoses, and hose handle assemblies are all available at your local Aerus Electrolux store. Simply take your entire machine in so ... Vacuums

The power bar button does not engage the power bar.The on-off switch works.the power bar still works but will not run if you dont hold it on.


... Dyson Vacuums

Power nozzle N106M on our Electrolux Guardian has stopped workin


... Electrolux Guardian Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0541 seconds