Having problems with your Electrolux Centralux Vacuum ?

Centrallux service light

\015 How to reset service light\015

Answers :

Repair Help & Product Troubleshooting for Electrolux Centralux Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Centrallux service light

... Electrolux Centralux Vacuum

Scooba 340 used once, now service 4 mess and not charging. Charger outputting 22volts but still not charging. When the charger lead is plugged in the scooba light flashs for 20 seconds then gives the service light with 4 beeps.

... iRobot 5800 Scooba Vacuum

Scooba service light and tones go away when re-seating power supply

... iRobot Scooba 350 Robotic Vacuum

I have the IROBOT discovery that just got a new battery. IT ran great! As the battery was dying, I put it into the home base. The "brick" is green, the home base has two green lights and the on/off pulsates red. It never charges though. Eventually the red light stops pulsating. Customer service said to reset it, clean the metal, and nothing works! They told me to just buy another one. The problem is that I know it was working! Help!

The best thing that you can do is take the charger into somewhere that can test it for the proper output voltage. It should be somewhere very close to 22 volts with no fluctuation. The charger is the easiest thing to test in this case. ... iRobot Roomba 4210 Bagless Robotic Vacuum

I have an Elnapress 1004 which seems to have stopped working. The on/off light does not light up, and the unit does not heat up. Please identify the problem and recommend a local repair service in Vancouver, BC Canada that could do the necessary repairs.

... Vacuums

Passat 2000 W Reg Had the rear brakes and disks changed then a month later had a front tyre replaced and as I drove off something went tinkle tinkle on the road (like someone had left a spanner). Week later the ABS light and the brake light come on with the usual STOP Brake Fail Service Manual message. Had brakes checked but they could find no fault. I've tried the ABS under controlled conditions and it works. What could the problem be?? I've been running the car under these conditions and no pr

The ABS module has a history of wearing out on VWs. Nothing wrong with the brakes themselves, but the ABS module would need to be replaced to stop the lights coming on... but the problem is a new ABS module can be very expensive for a new one (~$900 ... Vacuums

When i charge,the service light is on and beeping

Get back to the person that you bought it from i would think they would give you some kind of waranty.i don't trust buying from ebay .i hope you didn't pay a whole lot for it.send an email to ebay themselves.please leave feedback ... iRobot 5800 Scooba Vacuum

Service centre of bright light torch in kodungallur?

... Vacuums

It says it is a Bissell 12 Amps Pro Heat with Safeguard, and a light indicator on it. So basically it is not spraying out water. I just got it serviced today and cleaned.

Take it back to the place where you had it service/cleaned and tell them to do it RIGHT! ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Ladybug 2350 It starts to heat up and after a few minutes the malfunction call service light comes on.

... Ladybug 2350 Tekno Steam Cleaner

I fixed my scooba's check tank problem, now it has the service light on and keeps beeping 4 times

Amber it might be a valve stuck get a straw and blow air into the solution valve under tank on right or try droping scooba 2 inches from ground as this might reset the ball valve . ... iRobot 5800 Scooba Vacuum

Fantom Canister The vacuum head light keeps going on and off as well as the suction.  I actually purchased a new head, at the recommendation of their service dept., and the problem is still happening w/the new head.  Any suggestions.

It sounds like you have a hose problem. You should be aware that the Fantom company went bankrupt many years ago. I know that the Fantom name was bought by another company and there may be Chinese units sold under that name, but service and parts ava ... Fantom Vacums Lighting Canister Vacuum

Scooba runs for a short time then the service light comes on

Have you emtied it and cleaned it good.take the battery out and let it stand for 30 minutes then try again ... iRobot 5800 Scooba Vacuum

How to reset service reminder after i changed oil and filter after a week the engine light came on and derated the engine power

Check oil level if good have car scanned for trouble code (check engine light)service reminders dont cut back the porwer the code will give u a start point ... Vacuums

No Suction My two year old Kenmore Progressive stopped working in January. The guy at the Sears service center convinced me that buying a new one would be cheaper than getting it fixed. So I bought the exact same model and now this one has given out in the exact same way! I'm so confused. When I press on, it lights up and makes the whirring noise. Everything seems to be working but there is no suction anywhere. Not in the main part or the hose and there's no "cyclone effect" in the chamber. All

Try looking within the vacuum to see where the suction is getting stuck at. You may have to do some disasselbmeing but this is a manufacturers problem. You should also try to speak to the manager at the support and make a big dispute until you get yo ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

My "service" light has been

Most likely it's a dirty filter. Remove dirt tank and empty it. Remove the filter and rinse thoroughly in running warm water until the water runs clear. Allow to air dry thoroughly before using. I recommend having two filters so you have one to u ... Electrolux Centralux Vacuum

Karcher rc3000 The robo vacuum was working just fine.  The other morning, I looked at it and there were no lights on.  Now nothing happens.  Obviously a major failure.  I will be a little bit ticked off if this is broken for the money that has been spent on it.  I can't find any service center listed.

Ask cleanstuff.co.uk ... Karcher RC3000 Bagless Robotic Vacuum

Sebo Automatic X1 vacuum 'check brush' light on

I work in a Sebo agency, where we sell and repair Sebos - although they're so reliable we don't get that many to repair.  What's "automatic" about this machine is that it automatically adjusts the brush height so that it's ideal for whatever flo ... Sebo Automatic X1 Bagged Upright Vacuum

Dyson dc35 charger doesn't light up

... Dyson DC35 Handheld Vacuum

Andorra collection, withcommand system 2000 wall control. Light will not turn off by light switch, when light switch is depress light blinks is it the wall switch or the light?

I searched under the following search terms and did not find it on the Internet:\015\012'andorra collection withcommand system 2000 light control'\015\012\015\012and found:\015\012\015\012 ... Vacuums

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I

The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum

I have a Propress 2500 series steam cleaner which requires a heating element. It stopped working during a small steaming session. I notice now that with sufficient water in the cylinder both lights come on, the on light and the low water light , the second light remains on all the time. Can you help.

... Vacuums

I have a clarke bench grinder model 1002. I have a light that I would like to attach into the wiring though the grinder wiring in it's base. The light has two wires, and the grinder has a ground that is grounded to the base, a black that goes to a switch then to the motor. The white goes directly to the motor. where would I have to splice in the two wires from the light? I have a switch that I would like to put in for the light on off also.

Attach the white wire on your lamp to the white wire on the grinder.\012Attache the black wire on your lamp to the black wire on the motor side of the switch.\012This will give the lamp power any time the grinder is turned on.\012Yo ... Vacuums

Confusion and embarrasement have caused me to appeal for expert advice. I need to add a second flourescent light fitting in the loft. I recently added one from the existing wiring circuit via junction box and pull chord switch and it works fine. I have wired in the second light and now neither of them work. I have replaced the starter (as I had a faulty one in the first light. But i annot get them to work. I have installed a second junction box for the second light and wired all like terminals

... Vacuums

I have a Casa Blanca Intelitouch ceiling fan. Panama5 12004T model no.?? serial no.: AU16550 A casa blanca tri-switch on the wall: lights-fan-power When I turn it on, the lights and fan work fine. After a period of time, the lights go off by themselves. I don't remember the fan ever going off by itself, only the lights.

The light are going off only because after a period of time the circuit lets off the trigger on the switching thyristor. So the fault is within the control box of the unit which must be taken out to confirm.\015\012Now attempt to do the job onl ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0395 seconds