Having problems with your Electrolux EL1000A2 Pronto Bagless Stick Cyclonic Vacuum ?

Cannot determine where the plug for the charger is placed.

Answers :

There is a small hole/receiver on the left of the grey stand near the top. If you have lost your charger plug be certain to replace with a 15v unit to be compatable with the charging unit. Good luck
It plugs into the gray stand that came with the vacum
Repair Help & Product Troubleshooting for Electrolux EL1000A2 Pronto Bagless Stick Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cannot determine where the plug for the charger is placed.

There is a small hole/receiver on the left of the grey stand near the top. If you have lost your charger plug be certain to replace with a 15v unit to be compatable with the charging unit. Good luck ... Electrolux EL1000A2 Pronto Bagless Stick Cyclonic Vacuum

I want to recharge my Philips PET741 D/05 portable DVD Player. But when I push the plug into the charging point on the side of the player,at one point, as the plug goes in, there is a quick flash of red - but no more. The red charging light does not light up, and the player does not charge. The plug cannot be held at the point where the sudden momentary flash takes place

1.With the AC power unit plugged in to the wall plug into your dvd player and wiggle it a little bit and see if the light goes on or off. If so the the power port is bad. \015\0122.Try a different wall outlet to see if it helps.\015\0123.Ensure there ... Philips Vacuums

I have the vacuum on the charger and the charger is plugged into the wall but i cannot make it work. Please advise thanks,

The battery is probably not taking a charge anymore. And I don't think that you can get a battery replacement for this model ... Black & Decker Vacuums

I cannot charge my two year old electrolux pronto. I purchased a brand new hand held vacuum for it, but even the new one does not charge. When I plug in the cord nothing happens. If I turn on either the long handle or the portable unit within the long unit, the blue charging light comes on for a few seconds, then out. This tells me that the circuit is intact without a broken wire somewhere. I took it all apart carefully and could see nothing broken or out of place. On re-constructing it, it

It must be the charging transformer. We have already ruled out the vacuum unit. Unfortunately the transformer is not a serviceable part, and will need to be replaced. ... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne

Where do you plug in charger? I did not receive a manual or instructions with my new Roomba 560 and cannot get it started.

There should be a little plug on the side that allows it to charge. its a small circular outlet similar to the one that would plug into any electronic from an adapter ... Vacuums

My Little Green Machine has stopped sucking (second one with this problem!) I have removed the bottom plate and cannot find how to get to the hose to determine if there is a blockage. How do I do this? There is a screw that seems to hold a piece in place but it does not come out to get access to the hose.

Remanufacturing is a big problem since we don't know what was changed and how. ... Bissell Vacuums

We have an Aquanot II charger for our backup sump pump. We unplugged the charger from the battery, and just plug the charger into an outlet. As soon as we plug it into an outlet, the two LEDs lite up, and then the fuse trips within a second. We bought the whole sump pump backup system in June 2009, so it is fairly new. Any idea whether the charger can be repaired?

Https://app.qleapahead.com/rtp/libraryget.aspx?asset=88182,63\012\012Above is the owners manual for your pump system. Included ar ... Vacuums

Cannot locate where to plug adaptor in. Sharper Image LumiNight Weather Station EW400 Instructions do not show or explain. Unit comes with adaptor which is mentioned in manual, but cannot locate a plug in on actual unit or sensor.

Hello--to plug in the power you'd need to open the base battery compartment ... Vacuums

My DC 17 is plugged. I can see through the small hole in the top blue "flower shaped" that the holes at the top of the canister are plugged with hair & dirt. I cannot see anyway to get to these small round holes. Is there a way to remove the top blue "flower shaped" piece? I have removed the inner cone from the clear canister but still cannot get up underneath.

Please kindly follow the steps below to clean your vaccum cleaner,1.) Remove the clear plastic handle. You\015\012will have to take out two screws and then unclip from the from the\015\012front. It's stiff, I gently used a flat head screw drive ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Help...we just replaced our existing radios and chargers. When examined our old charger we noticed it was powered through the amp model # AA19920. Our new chargers have no amp...can we plug directly into the wall receptacle?

... Vacuums

Need Charger for Shark: Charger # KA12D090015023U and Im sick and tired of looking for it. It shouldn't be this hard This shark was purchase by my mother who is 85 years old from HSN, she bought 2 one for a gift and one for her self. Somehow the charger got damaged and I cannot find one any where please assist me in finding this item. This Vacuum has been used one time. I hate to contact Home Shopping Network

Call 1-800-798-7398 the person I talked to was knowledgable. The cost of the charger KA12D090015023U is $14 including shipping and takes 2 days to deliver. ... Vacuums

I cannot fit a Miele SF-AH 50 Active HEPA filter into my S524 Miele vacuum. It doesn't seem to have the rear tabs in the right place to push it into place all the way. When I put it into the place, the top won't close. I'm afraid I'll break something if I force it down. What is wrong?

... Miele S524 Mercury Bagged Canister Vacuum

The tension knob came off of the front of my sewing machine while I was sewing. I cannot figure out how to put it back on. I have the metal rod that fits into the back of the tension knob, but cannot figure out how to put it back into place. Keeps falling off

It sounds like your machine is the kind that has a knob with a 'set screw', a teeny tiny screw that tightens and holds the thing in place on the rod. Look for a small hole, probably on the bottom and look for a very small screw near the machine. ... Vacuums

Remington R7130 shaver is not charging, hand piece is showing zero on the panel and a power plug representation but does nothing when plugged into charger

... Vacuums

Elna 7200. The bobbin spring seems to have come loose, but cannot figure out how to get it in place again, so we cannot work, Pls help.

The best course of action in your case is to take sewing machine center and let them show you how to get it in place. They may even help for free because you might become a potential costumer. I hope that there is a repair center near you. ... Vacuums

I have a Dyson DC35. It has just stopped working. The green light on the charger is on and the vacuum is plugged into the charger, but it is like the vacuum is completely dead.

Aside from mechanical issues or broken wiring, ALL rechargeable batteries have a finite life; measured in the number of times they are charged, the temperatures they are exposed to, the charging currents / voltages they are exposed to, and so on. ALS ... Dyson Vacuums

I have to rewire the plug on a Pfaff Dorina 75 sewwing machine (foot pedal & electrical input. I cannot get it right - anyone can tell me what to connect to which of the three connections in the plug ?

The colour of the wires differ depending on where you are. If you're in the USA and using 120V system the wiring isBlack (the hot wire) goes to the brass connector, The White goes to the Silver connector and the green goes to the Earth connec ... Vacuums

Getting part My repair shop cannot get the part for my filter queen. It's the plug in the body of the machine that the short plug goes in from the hose. It's been bent. Can I get a replacement part?

Have you called your filter queen dealer? i used to be a rep. and we would fix problems at the office that i worked out of. hope this helps. ... Filter Queen Majestic Canister Vacuum

Plugged in the charger to my model AV-701B electric broom after not using for a few months. Charging lamp went green as soon as I plugged it in. Unplugged the unit but it will not turn on.

The same happened to me. The battery will no longer take a charge. Oreck store was of no help. Do NOT buy the new model it is poorly designed. you can find other brands in the same category at half the price and much better brands for about the same ... Oreck ElectrikBroom AV-701B Handheld Vacuum

The electrical cord that plugs into the machine has burnt the tips so they don't make good contact also the points where they plug into are burnt. I cannot seem to locate where I can buy these ends

The only place you will be able to get these is through the manufacturer. ... Vacuums

Hey my duracell CEF 23 battery charger has a detachable wall plug at the end, and what my question is what is the area after you disconnect the wall plug component for? i cant figure it out

It allows you to use other plugs besides US style two prong plugs, such as UK, or European or Australia type plugs. It's designed to use most any plug on the planet. ... Vacuums

Wondering if the head is plugged up because it makes a sound like air is escaping somewhere. I've replaced the original cloth bag with a comparable "O" paper bag from Sears. I tried to see if there was a clog in the hose by placing a broom handle in the hose to see if something would loosen. I also cleaned the filter and the air filter. If the head is plugged, how can I fix it? We can't get the vacuum apart. Thanks.

I had this problem, but suction improved when the attachments were properly secured in their holders. ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Scooba 340 used once, now service 4 mess and not charging. Charger outputting 22volts but still not charging. When the charger lead is plugged in the scooba light flashs for 20 seconds then gives the service light with 4 beeps.

... iRobot 5800 Scooba Vacuum

Charger schematics found charger not woerking on further investigation determined resistor r-5 burned up. not being able to read the bands on resistor need to now actual resistor value to fix correctly. PS 2 1M ohms connected in parralel works but would like to do it correctly.

WASHINGTON, D.C. - Consumers should stop using this product unless otherwise instructed. \012\011It is illegal to resell or attempt to resell a recalled consumer product. \012\011Recall Summary \012\011 Name of Product: Ryobi P113 Dual Ch ... Ryobi P113 18 Volt One Charger 140501001

I have a Dyson DC35. It has just stopped working. The green light on the charger is on and the vacuum is plugged into the charger, but it is like the vacuum is completely dead.

... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0320 seconds