Having problems with your Electrolux EL5020 Vacuum ?

Stuck power cord - Electrolux EL5020A VacuumCleaner

\015 I have a Electrolux EL5020A VacuumCleaner and the power cord is stuck. It will not move in or out. I ahve followed the instructions in post http://www.fixya.com/support/t1061517-change_cord_electrolux_el5020 to the point where the lft wheel should come off.I removed all of the screws, including the two next to the wheel but am not able to see how to remove the wheel.Any help would be appreciated.ThanksChris\015

Answers :

Repair Help & Product Troubleshooting for Electrolux EL5020 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Stuck power cord - Electrolux EL5020A VacuumCleaner


... Electrolux EL5020 Vacuum

Electrolux Centralux I have a Electrolux Centralux. When I plug the hose in at one of the wall outlets the motor will not start. If I go to the motor and slap the unit it will start.....then...it will not stop unless I unplug the power cord to the motor. If I plug the power cord back in, the unit will not restart until I slap the motor unit again. The unit has only been used 20 - 30 times. Any suggestions?? Thanks, Bruce


I dont know if you had your unit looked at yet but it sounds like the Power module is going. I repair the machines so I know some of the work. ... Electrolux Centralux Vacuum

I need a new power cord for the power nozzle on my Electrolux 2100 canister vacuum. The power nozzle has part number N115M written on the bottom. I have found the power cord for power nozzles PN6 and PN7 online, and it looks identical in photos but I'm not sure if it's the right part.


You can buy the hose at an authorized Aerus Electrolux store. If near enough, they will deliver, if too far, they can ship it. The nearest dealer can be found using the below link. Just follow the instructions.\015\012Just provide the model ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Frayed power cord on electrolux canister vacuum


1 screw in the front, two in the blower port. take them out and the top bezel comes off. one screw in the bottom and two on the top. need a flat blade screw driver to pry out the cord reel. 4 screws holds the sheild of the reel. take them out and the ... Electrolux UltraLux 2000 Bagged Canister Vacuum

How to replace power cord on Electrolux 6500 epic series


... Vacuums

Power cord stuck dyson dc19


... Vacuums

How do I take the Hoover Spirit canister vacuum apart to unjam the power cord? The cord is stuck and I can't pull it out.


... Vacuums

I have a electrolux 7000 my cord brok off and it got succked in. igot it apart. I DONY KNOW HOW TO PUT THE COIL SPRING ON THE POWER CORD WHEEL. NEED HELP


This is very difficult to reassemble correctly, and more difficult to explain properly. You need to take the vacuum to the nearest authorized Aerus Electrolux store for reassembly. Or call for free pick up and delivery.\015\012\015\012 ... Electrolux Lux 7000 Bagged Canister Vacuum

My electrolux ambassador power wand quit working. I replaced the switch that shuts it off when the roller stops, but it wasn't the problem. The on/off switch is fine, the motor is fine. We have traced the problem to the wires inside the canister by opening the inside cover to the bag container. We see the power cords going into the canister but we're not able to get to anything. We can't find any screws to undo that would open it up in order to follow the wires deep into the canister. We've bypa


... Electrolux Vacuums

Epic 3500 electrolux uptight installing new power cord . Clamp won't snap in place to secure cord in handle ???


... Vacuums

Replace power cord on electrolux 1521 - Electrolux Epic 6500 Vacuum


... Electrolux Epic 6500 Vacuum

The cord rewind button for my electrolux vacuum cleaner is stuck so it always rewind the cord. how to fix it?


... Electrolux Vacuums

We bought a new cord winder for our Electrolux 1205 Canister Vacuum cleaner and we are trying to install it is not turning on. We get it all connected but it doesn't turn on. Is there a reset button or some advise you can give me to get it working? I used a voltage detector to see if there was power running through the cord winder and there is.


Did you put a bag in the vacuum?\015\012I suspect there's an improper wire connection somewhere, but there are other things that could cause this I strongly recommend taking it to an authorized Aerus Electrolux dealer and letting a trained tec ... Electrolux Vacuums

Power cord will not retract on my Electrolux UltraLux 2000


You will need to take the machine apart to correct this. Open the front of the canister\015\012and remove the bag. As you are looking\015\012at the front of the unit, there are two vinyl covered strips that run\015\012the length of the unit. Pull for ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Kenmore vacuum 27612690 power cord stuck


... Kenmore 22612 Bagged Canister Vacuum

Electrolux Vacuum cleaner model z5830t retractable power cord replacement instructions


... Vacuums

Electrolux EL 7001 Oxygen 3 power cord continually retracts


The button has two parts - the inner part (button) and the outer part (surrounds the button). The press the outer part to deactivate (pop out!) the inner part.It took me a while to figure this thing out, but I was glad the vacuum wasn't b ... Electrolux EL7055A Bagless Canister Vacuum

Where do I buy battery or power cord for electrolux pronto 2-in-1 model el1000 type B


... Electrolux Vacuums

My Hoover Pet Cyclonic power cord is stuck. No going in or out. How do i access this area so i can repair it?


... Dirt Devil Hoover Uh70085 Pet Cyclonic? Upright Vacuum

Need to replace the power cord - Electrolux Epic 3500 Vacuum


Please to go www. repairclinic.com and get the parts. God bless you ... Electrolux Epic 3500 Vacuum

Power nozzle cord broken. how to rewire it? - Electrolux UltraLux 2000 Bagged Canister Vacuum


... Electrolux UltraLux 2000 Bagged Canister Vacuum

The power cord is stuck part way out - it seems to have slipped over the edge of the reel inside the machine, so it won't pull out and it won't retract. Pulling hard does no good.


Hello,Yes, pulling hard is not a good idea. You need to use techniques to get it out.Get a flat Phillips screw driver, use it to bring it out. Or use a screw drive to disassemble the part that that went inside the machine. If ... Vacuums

Electrolux twin clean cyclonic has the cord stuck halfway and won't retract. Can anyon ehelp?


... Electrolux EL1000A2 Pronto Bagless Stick Cyclonic Vacuum

Cord stuck all out - Electrolux Guardian Bagged Canister Vacuum


Lift the front of the vacuum so the canister is at about a 75 degree angle. Gently tug and release cord. It may take a few tries, but it usually works. ... Electrolux Guardian Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0567 seconds