Having problems with your Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum ?

The vack just stopped working no lights or anything was using it for a couple minuits and it just stopped


Answers :

Sounds like your machine may have overheated and tripped the motor protect fuse. Does it turn back on after an hour or so?
\015\012
\015\012Check your hose for blockages. Disconnect the hose from the machine and get a small marble and see if it will pass from one end of the hose to the other. If there ism you may need to pass a broom through the straight end to try and dislodge.
\015\012
\015\012Make sure the you don't have a full bag. Also check the motor filter inside the bag cavity to check for blockages.
\015\012
\015\012If there are no blockages and the bag is findm you may need to refer to a Service Center. It's a reasonably new model, so check your warranty papers.
Repair Help & Product Troubleshooting for Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The vack just stopped working no lights or anything was using it for a couple minuits and it just stopped


Sounds like your machine may have overheated and tripped the motor protect fuse. Does it turn back on after an hour or so?\015\012\015\012Check your hose for blockages. Disconnect the hose from the machine and get a small marble and see i ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Press the power button on - good got a green light (new battery) press the clean button - got a green light iRobot runs for a couple of seconds and stops, then starts, then stops. After two or three times I now have a red light on for the Status. All of the wheels seem to be clean. I used compressed air to clean the underside. But still have the start stop problem.


How many times does the red light blink before it pauses? ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop's head but all of a sudden no power light would go on and no steam would come out. I can still use the mop, cause water from the tank still is able to flow down to the head. It's just that I'd have to use it like an ordinary mop not as the steam mop I liked. Pls help!!!


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a kenmore progressive direct drive handi mate jr. upright vacuum. My daughter used it last night to vacuum up some cat litter that had spilled on the floor. I went to use it today and it turned on for a second and then stopped working. I have hit the reset button but it will not turn on. Help this vacuum is only 2 years old Is there anything that I need to reset or do so that the vacuum will work again?


Its probably clogged up with cat litter.might have gotten into the motor.your motor has a motor guard inside if it. when it overheats it will shut down till it cools off.you need to clean all th cat liter out of it.and clean the filters.with a direct ... Kenmore Vacuums

DC44 Used right out of the box for about 10 minutes, then I took a break and plugged it in. Went to use it again and after 1-2 minutes it just stopped. The green light on the charger unit is lit but the one on the handheld part is not lit. Is it just charging or did it stop working??


... Dyson DC44 Animal Cordless Vacuum

I have an electrolux oxygen canister that's 4 yrs old and it just stop working. It just doesn't turn on and no lights display. I veryfied that the outlet works. I took it at my local Eletrolux store but they don't deal with this model. They told me that this model is made in Europe and they don't support it. Where can I take it to be looked at or do you have any ideas what the problem might be. Last time I used it it was working fine. Thanks, Rodi


... Electrolux Oxygen Z5540 Pet Lover Vacuum

My filter queen majestic quit working. I opened up the unit to see what was wrong and I did not immediately notice anything wrong. Upon furter examination I noticed one of the traces on the printed circuit card was burnt. I used a soldering iron to "bridge the trace and it appeared to fix the problem for a while. Now it has stopped working again, and when I jumper the trace to run the motor it seems to work. Should I just replace the card? Or is there a more serious problem with too much current


I recommend replacing the card. Soldering involves the risk of further damaging the card, so it would be useless anyway. Why waste valuable time?\015\012There is a possibility of the motor overheating, generally due to a blockage in the airfl ... Filter Queen Majestic Canister Vacuum

Hello, my Kenmore 27514 canister vacuum only works on the hard floor...the carpet suction stopped working while I was using it. Is there anything I can do to fix it or is it necessary to take it in for repair? The vacuum is only 1.5 years old. Thanks. Susan 702.340.8015


You need to replace the belt that drives the beater bar. You can do this yourself very easily. If you need help, let me knowJim ... Kenmore 27514 Bagged Canister Vacuum

My Shop-Vac 5870400 was working just fine, and then one day while i vac the floor its just stop working, tried to turn on/off a few times, swicth to different outlet. i did even tried to open it, but found no burn or anything that suspicious. i never drop nor used outside, only inside the house for normal vacumm. please help. thanks.


Same thing just happened to mine. My solution is to get another one but a different brand. I think it should have lasted longer than four years of fairly light usage. From what I read, if it does as we both described, the motor is shot and not wor ... Shop Vac 587-04-00 Canister Wet/Dry Vacuum

My vacuum just stopped working, so I don't know what the problem is. I used it in the kitchen to vacuum the hard wood floor. I turned it off, and a few minutes later, turned it back on to finish vaccuuming the kitchen floor. It just would not turn on. I had not unplugged it or did anything to it. I then tried to see if it would work in another plug, and no luck. I'm trying to figure out if it can be fixed or if I need to look for a new vacuum.


When I get most Vacuums that have dies on people most of them the wire has been worn and cut one or more wires on the plug cord. Sometimes the cut can be over looked. Please unplug and check the wire carefully.Also please post the make model a ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

I have a Kenmore Elegance Vacuum with Dirt Sensor, Model # 116.30750400C, Serial number M41901532. When vacuuming the carpet the power head will work for 3-6 mins then automatically shut off, power is still there and lights work but the power head motor turns off and the suction stops. I will turn it off and on, check the outlet, flick the on off buttons...nothing. I will turn it off for a couple minutes and it turns back on and runs like normal. I've check the bags, filters, cleaned the hos


It is an electrical problem in the handle, if you can or know somebody that has any fix it ability it can be fixed in about ten minutes. Oh, and Sears SUCKS!! ... Kenmore 34612 Bagged Upright Vacuum

VAX vacuum stops working after about five minuits use then I have to wait an hour before it will work again


The symptoms you describe are those of a machine that is overheating. Almost certainly there is a blockage somewhere, or one or more filters are clogged, thus impairing air flow. Clear the blockage and the problem should be solved.\015\012If this doe ... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

I have Hoover WindTunnel Air Upright Vacuum - UH70400 just used couple of times. While vacuuming the carpet carpet fringes were rolled up in to brushroll and brushrol stopped working. It means vacuum is not working effectively now. Brushroll indicator is flickering.


... Hoover Vacuums

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop's head but all of


HEATING ELEMENTS BURNT OUT. WILL COST OVER $100. TOFIX. SHARK NOW HAS A NEW MODEL "SHARK 3" MUCH BETTER ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My black & decker cyclone type1 blender model blc 12600b has only been used a couple of times and now it has a flashing power light when I plug it in and will not work?


... Vacuums

Roomba when fully charged will only go about 2 feet then powers down and won't do anything with remote either. Use to work great with remote or off the light houses. Do you have any help for it


Try this link below for helphttp://uksupport.irobot.com/app/answers/detail/a_id/883/related/1/?cc=uk ... Vacuums

116 31811010 Vaccum motor stopped working during use. It's getting power, lights and brush rotation, but no suction.


... Vacuums

My Eureka Enviro Steamer won't make steam. It is only my second time to use it. It came on for about 5 minutes, then the steam stopped. The green light stayed on. I turned it off and let it cool down, added more water, then turned it on again. It didn't do anything--not even warm up.


... Eureka Enviro Steamer 310 Stick Vacuum

My Shop Vac QAS60 stopped working while I was using it. Is there anything I can check and/or repair on my own?


... Vacuums

The Petmate powerhead roller stopped rotating. I checked for anything binding it - nothing. There is power getting to it, just no rotation. As the guy said in the post above, it's like it is locked into the plastic housing, although it just worked last time I used the powerhead. Help!


... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

My Shark steam mop just stopped working completely. No light or anything. What could be the cause?


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My electrolux vacuum cleaner twinclean cyclonic 13MXXL Reach stopped working..lights on filter clean started flashing. I washed the filters...anything else I need to do. I'm waiting for the filters to dry. Thanks .Erika


... Electrolux Vacuums

Power problem I have a Generation III and lately the power button doesn't always work when it is pressed. You have to click it a couple of times and then it will turn on and sometimes it will even stop while I'm in the middle of using it. Thanks for your help


I would replace the power switch. Here are the instructions for the repair...\015\012http://rev ... Kirby Generation 3 Bagged Upright Vacuum

I was using my sharp twin enegry vacuum when the motor stop working. The light never went out.


... Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum

My silent ionic breeze GP just stopped working (no blue light, no static). only a couple of years old. cleaned weekly. how do I obtain someone to possibly fix it as trouble finding replacement?


Http://www.airpurifierrepair.com/ProductDetails.aspx?ID=0&ProductId=473&gclid=CKWj6N--u6cCFYjsKgodLxrBB ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1073 seconds