Having problems with your Electrolux Epic 6500 Vacuum ?

Electrolux Epic 6500/ handle clip broke....

\015 Realized yesterday that the clip that holds the wand to the handle is broken. Is there a way to fix the handle and not have to buy a whole new hose piece that runs about $60+?\015

Answers :

The clip can be replaced by taking apart the handle. Small round plastic inserts cover up the screws that hold the handle together. Use a very small screwdriver to pry them off, then use a small screwdriver to remove the screws(Some of the screws may be star screws requiring a special screwdriver. The top part of the handle will then lift off and you will be able to change out the clip. Before reasembling the handle, clean the contacts which attach to the hose and be careful that you do not bend the contacts. It is kind of tricky to put back together.
\015\012
\015\012Good Luck
\015\012Captaintek
Repair Help & Product Troubleshooting for Electrolux Epic 6500 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Electrolux Epic 6500/ handle clip broke....


The clip can be replaced by taking apart the handle. Small round plastic inserts cover up the screws that hold the handle together. Use a very small screwdriver to pry them off, then use a small screwdriver to remove the screws(Some of the screws m ... Electrolux Epic 6500 Vacuum

Vacuum cleaner: AEG electrolux Cyclone XL bagless; the plastic clip (release button) broke off the lid of the dust container. Do i need to replace the entire dust container or can i just buy a new clip?


... Vacuums

No power, will not turn on. Checked switch on the handle, no burned or other obvious problem. Pulled handle from body and checked the three electrical poles, not burned or dirty. It is an Electrolux 3500 sr epic. Thank you Lucian


Does the plug shaped light on the top come on? If so, the vacuum is getting power, so another problem exists.\015\012\015\012See the following link for trouble-shooting, with recommeded "fixes".\015\012 ... Electrolux Epic 3500 Vacuum

I have an Electrolux Epic 6500 SR vacuum and the hose end with the handle is separating. Power nozzle losing contact intermittently. Is this piece replaceable or repairable?


It is replaceable. Just take it to the nearest Aerus Electrolux store and the service tech will take care of it for you.\015\012Go to the following site and follow instructions to find the stores nearest you. ... Electrolux Epic 6500 Vacuum

Electrolux Epic 6500 SR ...no power to power nozzle. I think it is the switch in the handle because if I use my friend's hose/handle (same model), my power nozzle works fine when I turn on the switch. If you think it is the switch, can I get a part for it?


That's about the best one to narrow down a problem, however, there could also be a break in your hose wiring. Switches, hoses, and hose handle assemblies are all available at your local Aerus Electrolux store. Simply take your entire machine in so ... Vacuums

My epic 8000 electrolux will not power on. the red light is onat the top handle ( it does not power up) but the bottom part of the floor adapter does not light up at all nor turn on ? is there a fuse ?


If there is light on handle but the electrolux is not starting then the handle switch needs to be checked and its connections.\015\012The vacuum cleaner is operated by the controls on the handle. The handle has different switches which change h ... Electrolux Epic 3500 Vacuum

My electrolux epic 6500sr vacuum has a seized motor. How do I acess the motor to service or change it? There are no obvious screws or clips to open the motor outer case


... Vacuums

How to re mantle vacuum hose at handle - Electrolux Epic 6500 Vacuum


It is explained in the manual. If you need manual, let me know, i can send the link for it. Car Parts ... Electrolux Epic 6500 Vacuum

Epic 3500 electrolux uptight installing new power cord . Clamp won't snap in place to secure cord in handle ???


... Vacuums

The handle broke off of the canister of my electrolux el 6988


Here is a website for parts for your model\015\012http://www.partselect.com/Entry.aspx?Brand=Electrolux&am ... Electrolux EL6988A Bagged Canister Vacuum

Electrolux epic series 3500 sr serial v87779 l


Sorry I didn't see this sooner. Your problem may be solved as simply as pushing the small red reset button exposed on top of the power head when you tilt the arm back. Very simple. Hope this helps.\015\012John ... Vacuums

Parts for Electrolux Epic 6500


You need to look under AERUS Electrolux to find a Dealer with parts. Electrolux USA sold the brand name back to AB Electrolux of Sweden a few years ago and there is no relation between the two. You may also find a common component of a d ... Electrolux Epic 6500 Vacuum

Electrolux Epic 6500 SR cord will not rewind - Electrolux Epic 6500 Vacuum


Unfortunately most cord reels cannot be repaired and must be replaced as a unit. That Vac Guy ... Electrolux Epic 6500 Vacuum

My electrolux 2100 vacuum hose broke. I replaced the hose but now I dop not have power at the hose end. is there a curcuit breaker in the canister tha supplies power to the hose??


... Electrolux Guardian Bagged Canister Vacuum

I had a house fire and lost most of my belongings. But I had just purchased a Shark Steam mop 3501. Loved it. Well it did not get destroyed in the fire but someone managed to break the handle off. Just the handle itself was broke off the rest of the handle rod is ok. I'm trying to see if I can replace the handle and not the whole shaft. Can you help me.


Yes you can replace jus the handle, the replacement part for the handle is available at the manufacturer's web site in the Parts and Accesories section. Enter M/N: S3501 to confirm it's the same as on your unit.\015\012\015\012 ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I broke the handle part of the shark steamer #53101. I don't have the book to try to tell you the parts I need. Can you send me a picture or a copy of the steamer. It is purple. The above number may not be the correct one. It is broken in the center part. It has a little small circular piece that joins the two pieces which are broken. The beginning of the handle at the bottom of the steamer and the next session which has the steam release. The top of the handle is okay . It the middle and bottom


Hi,Ann there are very few parts for these...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

How do I change the outer bag clip? Can't figure out how to get the top apart to put in the new clip. The clip that goes to the handle.


I had a Kirby Classic and I had to slide off the clip.Don't rate me if this doesn't work. ... Kirby Generation 3 Bagged Upright Vacuum

Floppy handle When I depressed the pedel to lower the handle on our Savvy there was a snap and now the the handle won't stay up. I assume there is a spring or someting else that broke. I can't find an exploded view of the vacumm to to take it apart to find out whats broken. Any ideas on what it is.


You have to take the base cover off to find out what broke,there are some screws on the bottom remove those to take the bottom plate off then,then up inside there are more screws to on the top remove the emblem and take that screw out ,that should e ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

I have just purchased two (2) Electrolux Nimble vacuum cleaners. Not one, but both, straight out of the box, the beater bars will not run. It turns on, select carpet, and lower the handle, the red light to check beater bar/or filter lights up. You can reset the light by unplugging the unit, then plugging it back in, but with same results. Now the kicker, if you take out the handle, select carpet, lower the body by the carry handle, it will run and operate correctly, however, as soon as you r


... Vacuums

Handle broke handle of 2961avz somehow snapped in half. any ideas how to find a replacement handle?


Part # for the handle is 75765-3. You should be able to order thru a local service repair shop. ... Eureka 2971AV EZ Kleen Bagless Upright Vacuum

Electrolux Discovery II 1500c Upright Handle Switch Assembly


... Electrolux Vacuums

Electrolux Epic 2500 suction stopped - Electrolux Vacuums


It could be the switch or could be the suction motor. Also, there is a thermostat on the motor that will shut it off if you don't have the air flowing to keep it cool. If that is the case, the motor will re-start after it cools down.\015\012If ... Electrolux Vacuums

Cord will not retract on epic 6500 sr - Electrolux Epic 6500 Vacuum


Try tipping it on its end,or nearly so. Then tug gently and release until it retracts. This has worked for me nearly every time I'd tried on various Electrolux vacuums.\015\012If this doesn't work, the vacuum needs to be taken to an authorize ... Electrolux Epic 6500 Vacuum

What kind of bag for the epic series 3500 sr - Electrolux Epic 3500 Vacuum


"U" (upright) style bags, available at any Aerus Electrolux store, or from their consultants. These are the genuine bags made only by Home Solutions. Generic bags WILL decrease the lifespan of the motor.\015\012\015\012Contact your loca ... Electrolux Epic 3500 Vacuum

The handle on my h2o steam mop broke. Where can I find a new handle?


We have no resources to find parts, sorry if u didn't understand that, that said based on my experience you will not be able to buy parts for this, this type of product is considered "throw away" ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0427 seconds