Having problems with your Electrolux Epic 6500 Vacuum ?

I need to remove the handle of my Eletrolux 6500 from the hose.

\015 I was vacuuming the car interior without any attachments. Apparently under the seat was a part of a plastic Easter egg that went right into the vacuum hose handle but is now stuck there because it's too big for the hose. I tried blowing it out but it must be lodged in there.\015

Answers :

If it is in the tube part of the vacuum, you could poke it out with a long and skinny pole, or a meter stick. If it is stuck in the hose, just open up the part that closes the vacuum bag, and do the same with a very long piece of metal or wood, as a meter stick will not be long enough.
Repair Help & Product Troubleshooting for Electrolux Epic 6500 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need to remove the handle of my Eletrolux 6500 from the hose.


If it is in the tube part of the vacuum, you could poke it out with a long and skinny pole, or a meter stick. If it is stuck in the hose, just open up the part that closes the vacuum bag, and do the same with a very long piece of metal or wood, as a ... Electrolux Epic 6500 Vacuum

Need to remove handle from suction hose on Dyson dc-07 vacuum.


You have to remove the connector at the bottom part of your hose - It is Yellow in color ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I need to remove the handle from the suction hose on my Dyson DC-07 vacuum and can't seem to find screws or tabs to do this.


Take the handle out by pressing the Yellow tab on the top. Next remove the hose from the vacuum by lifting the yellow tab at the bottom part of the hose ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Hi I need to know how to remove the handle from the hose on a tristar vacuum. thanks, Hartley


... Tristar Vacuums

My vacuum hose has split very close to the handle- how do I remove the handle, cut the hose at the split & reattach it to the handle unit - Centralux central vacuum system. Where can I find a diagram of how to remove the handle?


Do Not Cut the hose! It has wiring inside to control the vac and power head. This is a swivel handled hose with both low and high voltage contacts in it. The same wiring which gives the hose its ribbing, is conducting current for two applic ... Electrolux Centralux Vacuum

I need to reassemble my rainbow e series electrified hose handle


Yes, it is a ground wire. When you put it back together, make sure that the two halves of the hose handle are holding the wire up against the metal. I just had one apart the other day for the first time and if I recall correctly, the wire goes near t ... Rainbow E series Canister Wet/Dry Vacuum

Remove hose from handle on old electrolux canister


BE careful here. Do not fish a coat hanger in the handle. The original hose has a set of detachable handle componnets.There are two metal screws in the underside of the hand grip.Do Not pry. Once removed go to the suction dial area underside of ... Electrolux Central Vacuum

Clogged hose... I have a clog in my hose, probably a sock, I have pushed it through to the hard plastic handle end of the hose, help! can the plastic handle wand be disconnected from the hose to remove the clog??? Thank you


Hi!\015\012 \015\012Low suction, poor pickup, or no suction may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action in the Dirt Con ... Bissell 6594 PowerForce Bagless Upright Vacuum

I have an Aerus Guardian canister vacuum with a clogged hose. The tiny stuffed animal toy is lodged right below where the swivel handle meets the hose. Switching the air flow does not dislodge it. I would like to remove the handle from the hose. Any suggestions?


Consider this. If your vacuum is still under warranty, removing the hose will void the warranty on the hose. I strongly recommend calling an authorized dealer/consultant.\012Although it may seem to be fairly simple to remove the handle, there ... Electrolux Guardian Bagged Canister Vacuum

I have lost the manual and forget how to use the hose part of vacuum, also the handle turns and is not secure ( that is the handle in the upright position). It is a bagless Stick Shark Vac. I need to know how to attach the hose to the vac so I can clean furniture and corners.


... Euro-Pro V1828 Shark Stick Vac Bagless Vacuum

Can you remove the plastic hose that leads to the handle as mine has split. I thought i could remove it by pushing in the two black bits of plastic then shorten the hose. so far it wont budge. Is it meant to as Dyson sell the whole thing in one? cheers john


Yeah sorry it is sold as a complete unit and its a real pain to strip down so it better and faster to just buy the whole thing from dysons website  ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I want to remove the hose from the handle of the vacuum? I already removed the plastic clip. I thought that would free the hose, but it did not. Any ideas?


There are two discs on top on the dandel that cover the screws. You need to remove the two screws and the you can take the handle off the hose.\015\012\015\012Bob\015\012 ... Electrolux Centralux Vacuum

Bissell Spotbot hose needs removed and cleaned


... Vacuums

DC07 DYSON REPLACEMENT HOSE. HOW DO YOU REMOVE IT FROM THE HANDLE. I have a kenmore whispertone 8540 canister vaccum. The electrical wires (3) to power the beater are embedded in the hose, in a spiral fashion. The yokes that hold the hose on both ends (and attach to the beater on one end and the unit on the other) have no screws or pressure latches; i don't want to use brute force as i may damage the attachment device inside the yoke. If someone can tell me the trick to get these yokes off each


Should be a pry off dot on the underside revealing a screw ... Vacuums

My 8 yr old kenmore vacuum works well - however the hose has worn under the handle where there is a hole (resulting in decreased suction power). I'd like instructions on opening the handle and bypassing the worn piece of tubing rather than replacing it for $129. Some of the handle screws remove easily but the last one doesn't loosen easily.


Hi,Have you tried spraying the stubborn screw with WD40 and let it soaked for a while? Other than these screws holding the handle together, there would no other way of opening it up. Hope this be of initial help/idea. ... Kenmore Vacuums

The small button on the hose handle is missing, I need a replacement


... Euro-Pro EP923 Canister Steam Vacuum

My dyson DC17 will not turn on unless the handle is pulled back.(into the vacuuming position) The attachment hose will not work at all (0 suction thru it). I've checked the hose and made sure there is no obstruction. Any ideas?


Not sure if I can help, but I'll try. The DC17 has two motors: the vacuum motor and a separate motor for the brush bar. It is normal that the brush motor works only when the handle is pulled back in the vacuuming position - that's the way it's made. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Connecting hoses I removed the hoses and need to reconnect them. Help, please. Thank you. Julie


You can boil the end of the hose in water to make it swell enough to fit ... Dirt Devil Vacuums

Remove handle I took out the screws, but there is a circular locking by the hose. How do I remove this?


... Hoover S3639 WindTunnel Bagged Canister Vacuum

I need a hose handle for a centralux hose. Where can I purchase one?


... Electrolux Centralux Vacuum

How do I remove the hose handle on my electrolux to remove a clog


What model? ... Electrolux Vacuums

I need to find a way to replace the attachment hose on this unit. the tube to spray the detergent snakes into the base next to the wheel and i'm unsure of how to take it apart without breaking it. is there a simple way to remove the wheel? do i need to do something special to replace that tube?


The best thing for that situation is to look on the side of the road and you will find a Bissel, I see one or two a week. Take one home and experiment on that one not yours. I have brought many and never have I bought one. I never see a Hoover by ... Bissell 9200 Upright Vacuum

S catch i have taken the top part of handle off, removed the screws under hose wrap, and layed the bottom part of handle down, i cannot find the s catch, can you tell me exactly where it is and what it looks like. i have looked all over this thing. thanks randy the model # is 8905


\015\012\015\012Just pull where I marked, it should come loose. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

There is something stuck in the handle of my Miele vacuum. I unscrewed all the screws hoping that I could remove the hard plastic handle from the hose. I was only able to flip up a piece of plastic where the switch is. Should I pull harder to pry the plastic apart? I was afraid I'd break something. Thank You, Chrissy


... Miele Vacuums

Remove hose handle


Click this link for the manualhttp://www.vacsite.com/images/product_user_guides/bissell/bis38-e.pdf ... Bissell 82H1 Cleanview Helix Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0613 seconds