Having problems with your Electrolux Epic 6500 Vacuum ?

Electrolux 6500 can't open canister

\015 Can't get rear compartment open. Peeled back rubber trim strips ... only to reveal white plastic "I-beam" strip. How to proceed?\015\012\015\012(My main problem is a cord that won't rewind)\015\012\015\012Thanks very much for your time\015\012\015\012Tom\015

Answers :

This is what I used to open my vac... Note - the white plastic strips under the bumper clips into the case at the front end (to help these instructions, you may also want to put a thin flat blade screw driver between the white plastic strip and the case, @ the inboard most point)...
\015\012
\015\012If you want to open the machine, the two bumpers on either side, that say ELECTROUX hold the egg shell together. This is the process....
1. remove the bag, leave the bag cover open
2. lay the vacuum on its side on the floor with the bag cover to your right hand side.
3. place screw driver blade flat against the bumper on the opposite end from the bag cover, near the cordwinder cover, strike the screw driver firmly with a hammer, this will unlock the bumper and it will slide off toward the bag end of the machine.
4. turn the vacuum onto the other side, and follow the same process.
5. after both bumpers are removed you can get into the vacuum.
\015\012
\015\012http://www.howtomendit.com/answers.php?id=57063
Http://www.howtomendit.com/~howtomen/answers.php?id=28739\015\012\015\012good luck
Repair Help & Product Troubleshooting for Electrolux Epic 6500 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My electrolux ambassador power wand quit working. I replaced the switch that shuts it off when the roller stops, but it wasn't the problem. The on/off switch is fine, the motor is fine. We have traced the problem to the wires inside the canister by opening the inside cover to the bag container. We see the power cords going into the canister but we're not able to get to anything. We can't find any screws to undo that would open it up in order to follow the wires deep into the canister. We've bypa


... Electrolux Vacuums

How do i open my canister vacuum - Electrolux UltraLux 2000 Bagged Canister Vacuum


Open the bag door and grip the bumpers with a set of pliers. The bumpers cover a set of locking keys which will slide all the way forward and out. The back of the vac will then lift off and the top and bottom will open hinging forward like a **** she ... Electrolux UltraLux 2000 Bagged Canister Vacuum

How to open Electrolux EL7020A Oxygen 3 - Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum


... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

How to open a electrolux 4602 vacuum cleaner - Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum


... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

I need to open my electrolux AP200 canister to reattatch the power cord which has become diconected. How does one open the shell?


... Vacuums

Electrolux 6500 can't open canister


This is what I used to open my vac... Note - the white plastic strips under the bumper clips into the case at the front end (to help these instructions, you may also want to put a thin flat blade screw driver between the white plastic strip and the c ... Electrolux Epic 6500 Vacuum

Need to open the canister to get to the cord assembly of my Electrolux Lux 5000


Why do you need to get to the cord assembly?\015\012If the cord will not retract, tilt the vacuum to about a 45 degree angle and gently tug and release cord. It will usually retract.\015\012Due to problems ensuing from untrained persons ... Electrolux Lux 5500 Canister Vacuum

How to open electrolux diplomat canister vacuum lx body to get to the inside of the on/off switch


... Electrolux Lux 5500 Canister Vacuum

Need to know how to open the canister of my Electrolux Ambassador vacuum to replace the switch


If you switch still"clicks" you need a switch rocker, if it no longer clicks you will need a new switch button. You will get best results with the genuine button from an AERUS Electrolux repair shopThere are a set of body keys under the b ... Vacuums

VAX STEAM CLEANER CANT GET IT OPEN - VAX Appliances V081 Canister Steam Cleaner


... VAX Appliances V081 Canister Steam Cleaner

How do I open the canister of the Aerus Electrolux Lux Guardian? I need to replace the retractable cord mechanism. Aerus won't help me.


Hi there, \012\012This will not be difficult to open, however, inside may scare you. \012\012Remove your hepa filter cartridge (if you have one) \012turn the machine over. \012Undo the 6-8 screws there and pull the ... Electrolux Guardian Bagged Canister Vacuum

My electrolux canister model keeps shutting off after a few minutes use. can reset by unplugging and replugging, or by opening and closing access door


... Electrolux Lux 5500 Canister Vacuum

My electrolux oxygen canister cuts on and off. I have to open and close the vacuum, or take the base of the hose off and then re-insert. I have to do all these things before it will start up again. I sometimes shake the hose around, then it will come back on. If I try to dust with the dust brush (like a lamp shade or shelf) and the suction pulls against the object, the vacuum goes off for awhile. Sometimes I'll have to reset the vacuum by unplugging the electric cord. I never get to finis


Maybe you should have taken it back to that shop, it appartently isn't fixed. I would have replace that board, don't believe in modifing, you usually end up with other problems, like you have. One thing to check is maybe you have a partial clog in ... Vacuums

ELECTROLUX C101H JUST SHUT OFFWHILE WIFE WAS VACUUMING, DOES THIS HAVE AN INTERNAL THERMAL OVERLOAD SWITCH ? HOW TO OPEN UP CANISTER TO SERVICE ??


It does have an internal thermal overload device you need to put the vacuum into the shop they should be able to fix it in a few days ... Electrolux Guardian Bagged Canister Vacuum

Electrolux regency series upright. Clogged hose cant figure how to open body to access to clear hose.


... Electrolux 1910 Bagless Upright Vacuum

I have Electrolux canister vac. The suction end pops open everytime it loads up.


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=689886\015\012Generic problem for all Vacuums\015\012I have Electrolux canister vac.\015\012Posted by w ... Vacuums

Electrolux ultralux how do I open the canister to repair the fly wheel for the power chord


Slide out the two rubber bumper slides. ... Electrolux UltraLux 2000 Bagged Canister Vacuum

When we turn on the vacuum, the canister falls open. The clips holding the canister in place do not seem to hold the canister tightly which I'm sure that it did in the past. The clips do not look bent, but every time we turn on the vacuum the intense pressure blows the canister open only remaining attached the the rest of the vacuum by one clip


Check filter and make sure it is kept clean at regular intervals. Possibly worn out clip retainers on cannister side due to excessive pressure build up. Do not force closure unless pressure is back to normal. May crack cannister or damage unit beyond ... Hayden Industries SuperVac 6000 Central System Vacuum

How do i open canister for cord retract repair


There are four screws under the lid, and there are two additional screws under the face plate for the controls display. You'll need a thin, flat blade screw driver to "pop" the face plate off. The two additional screws that you are looking for are ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

How to open legacy canister


Take out the bag and keep the door open. \015\012While the bag door is still open, turn the machine upside down so you are looking at the serial number.\015\012Pull the cord out one foot.\015\012Use a puddy knife and put it between ... Electrolux Guardian Bagged Canister Vacuum

Frayed power cord on electrolux canister vacuum


1 screw in the front, two in the blower port. take them out and the top bezel comes off. one screw in the bottom and two on the top. need a flat blade screw driver to pry out the cord reel. 4 screws holds the sheild of the reel. take them out and the ... Electrolux UltraLux 2000 Bagged Canister Vacuum

How to take canister apart electrolux 2000 - Electrolux UltraLux 2000 Bagged Canister Vacuum


... Electrolux UltraLux 2000 Bagged Canister Vacuum

Where is electrolux canister reset button? - Electrolux Guardian Bagged Canister Vacuum


... Electrolux Guardian Bagged Canister Vacuum

HOW DO YOU OPEN THE CANISTER ,MODEL C141F -2100 ELECTOLUX


... Electrolux Guardian Bagged Canister Vacuum

Electrolux #1521 Canister Vacuum won't stay closed


Hi from uk your problem with the canister cover/door coming off whilst vaccing ? you have renewed bag ? ok but there is a filter/gauze also inside the canister where bag is fitted if you check inside you should see the filter at opposite ... Electrolux UltraLux 2000 Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0357 seconds