Having problems with your Electrolux Epic 6500 Vacuum ?

Power Nozzle Model No. N137A (for Electrolux Epic Serial 6500 SR) has a broken wire. Can I get a replacement power nozzle or find a repair place in the Everett, Washington vicinity?


Answers :

Repair Help & Product Troubleshooting for Electrolux Epic 6500 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Power Nozzle Model No. N137A (for Electrolux Epic Serial 6500 SR) has a broken wire. Can I get a replacement power nozzle or find a repair place in the Everett, Washington vicinity?


... Electrolux Epic 6500 Vacuum

How do I replace or repair my tristar power nozzle cordI don't know how to get to or how difficult it will be. there is a short in wire because it is separating from the power nozzle.


Dear kerri_clark,Can't you take a picture of tristar power nozzle cord that you mean.I need to take a look at this to assist you further more.regards,dm ... Vacuums

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

Power Switch How do I get the power switch out to replace it? I have a D4C model. Rainbow/Rexair. Is there a place where I can get a parts breakdown of the vacuum cleaner? Steve


This is not that hard:1. - remove gasket (it is glued so you may end up damaging it)2. - remove 4 screws holding baffle 3. - under it yo ... Rainbow E series Canister Wet/Dry Vacuum

The power head of my DC 21 keeps cutting off as soon as I start moving the hose around. The only way to get it going again is to step on the main switch on the canister, then the whole cycle of off and on starts again. I have replaced the entire power head and tested the continuity of all the wires in the hose and they are good. The repair shop says the PCB is bad but can not get one. What can I do ?


Not much. my only suggestion is to dig through the internet and try and find that pcb it may take awhile but it would be worth a shot. if you dont think you can make the repair take it to repair shop with new pcb and let them do it. ... Dyson Genuine DC-21 "Stowaway" Spare HEPA Filter, Dyson

I have an old Hoover vacuum model # U5035-930. The belt broke and I tried replacing the belt myself. I couldn't stretch the belt to attach it to the motor pully. It was belt # 38525-027 M6. Which I got from the previous owner. I took it to a vacuum repair place and he replaced it with belt # 38528-027 J4. I cannot find this belt anywhere.


... Vacuums

I'm using (or WAS using) a Eureka ''the boss'' model 8803. The belt broke, no biggie, so I replaced it with a Eureka model U belt, the problem is when I put the new belt on and turn on the vaccuum, the belt breaks again. I am also having trouble getting the brush roller to fit right when the belt is in place. I can't find any sharp edges that would cut the belt,nor can I find where any small bits may have broken. Anyone have a solution for me?


First, make sure you have the right belt, second, i am thinking that you are not lineing the roller up right, it will only fit one way. look at the ends of the roller and the grooves where it slides in, you should be able to see clearly how it goes. ... Vacuums

Electrolux power nozzle, model 1692, power cuts on and off. I don't have the manual for it, but I'm trying to remove and clean the brush compartment. I removed the top, but not sure how to get to the brush. I would like to find a manual for it, because it's completely different than the one I use to have.


... Electrolux Vacuums

My electrolux ambassador power wand quit working. I replaced the switch that shuts it off when the roller stops, but it wasn't the problem. The on/off switch is fine, the motor is fine. We have traced the problem to the wires inside the canister by opening the inside cover to the bag container. We see the power cords going into the canister but we're not able to get to anything. We can't find any screws to undo that would open it up in order to follow the wires deep into the canister. We've bypa


... Electrolux Vacuums

Belt gone in EL6986 power nozzle. cannot find replacement


... Electrolux EL6986 Bagged Canister Vacuum

Hi, I have a oreck dual power sweeper vacuum DP460 and I am looking for replacement filter for it. Does anyone know where I can find one?


Have you tried this site click the link belowhttp://www.vacpartswarehouse.com/Oreck-DP460-Electric-Broom-s/2975.htm ... Oreck Dual Power Electric Floor Sweeper Bagless Upright Vacuum

NEW REPLACEMENT BATTERY FOR SHARKVAC MODEL SV775R BUT CAN NOT FIND A PLACE TO GET ONE HELP


... Euro-Pro Shark Cordless Stick Vacuum SV775R Vacuum

Where can I get replacement parts for the monster1200...I need a new boiler cap (lost by last user) & the angled nozzle which actually was missing when I got it. I looked on the euroflexusa site but couldn't find anything. Any suggestions?


... Euro-Flex Monster 1200 Handheld Steam Cleaner

The hose does not stay connected to the wand although the collar appears to be locked in place for a while. Is there a replacement part for this? Also the holder where the wand goes in has split horizontally. This appears to be one piece with the body of the unit. Is it repairable? It still holds the wand but continues to get worse.


... Dyson DC07 Bagless Upright Cyclonic Vacuum

Where do I find a replacement hose for the Hoover U5432-900. The hose is crimped in 2 places, so the suction power is not very strong. Thanks! Fran Reisner


Fran,\015\012Please call Hoover Service at \015\0121-330-499-9499 (U.S.) and 1-800-263-6376 (Canada) ... Hoover U5432-900 WindTunnel Plus Bagged Upright Vacuum

Help!!! I bought a replacement nozzle valve for a hoover steam vac hose and I can't get it back in right. Does anyone know where I can find an illustration of this assembly??


Hessco.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

There was a foam piece above the motor of my rainbow d4c power nozzle. When I took the plate off it desintigrated and fell off. Was that supposed to be there? If so how do I find a replacement?


You said "above the motor", so I assume you meant the smaller foam piece located there, and not the gasket seal that is affixed to the inside of the metal bottom plate, (which is what the previous solution responder was referring to).Most ... Rainbow 75th Anniversary Canister Vacuum

My filter queen started smoking from the power nozzle. what is it that needs replacing? The rubber is still in place and works but the burning smell and sparks could well be the pipe. what do you recommend?


... Filter Queen Majestic Canister Vacuum

Hoover belt 38528 is broken where can we find the replacement part and how can I install it again? or is there a place to get service for this vacuum cleaner?


Try your local yellow pages and see if there's a vacuum shop around your area. If so, they will be able to help you with a replacement belt and assist you on putting it on.Most vacuum shops carry parts for Hoover and will service the vacu ... Hoover Tempo Widepath Upright Vacuum - Blue

I have an Electrolux Epic 6500 SR vacuum and the hose end with the handle is separating. Power nozzle losing contact intermittently. Is this piece replaceable or repairable?


It is replaceable. Just take it to the nearest Aerus Electrolux store and the service tech will take care of it for you.\015\012Go to the following site and follow instructions to find the stores nearest you. ... Electrolux Epic 6500 Vacuum

I have an elna 614DE overlocker and although there is power (light on) when I press the foot pedal, nothing happens. Is this a fixed unit which can't be repaired? If so, where can I get a replacement?


I have the same machine same problem did you get it working and if yes what did you do. ... Vacuums

Replacing Power Cord to Power Nozzle


The height adjust mech. has 2 tabs, that you have to unlock, It also is easier when you tip the power head so as not to puit pressure on the Ht. Adj. wheels. Use a flat blade screwdriver and if you look down bertween the ht. adj. mech. and the elbo ... Kenmore 22812 Bagged Canister Vacuum

My Electrolux central vacuum power nozzzle was working hit/miss and now has stopped working. The metal connectors in the wand and power nozzle get very hot, enough to burn. The metal connectors also


... Electrolux Central Vacuum

Power nozzle of my S3670 does not work (vacuum itself does work), the headlight bulb in the nozzle is broken. This happened in the past several times - we would bring the vacuum to service center - I don't know what they did other than replacing the bulb. I decided to go to ACE and buy replacement bulb myself, replaced the one in the nozzle - this did not fix the problem. I don't see any fuzes or anything in the nozzle. However, the manuals says to "Use only HOOVER part no. 27317307, which is a


... Hoover S3670 Bagged Canister Vacuum

Miele seb 213 Powerhead is getting ac power but there is no power to the motor. The light comes on and I get 120V on the ac side of the circuit board with a meter but zero volts on the dc side.can I replace the board or do I have to replace the whole Powerhead?


... Miele SEB 213-2 Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1377 seconds