Having problems with your Electrolux Epic 6500 Vacuum ?

Small potato (yes) stuck in hose, dont know how to reverse. tyvm

Answers :

Possibly, find the location in the vacuum hose, where the potato is stuck, squeeze the hose there to force the potato to break up into smaller pieces that can be sucked through. If it is stuck in the "wand" the solid part, a straightened out wire coat hanger, may suit, instead, but be extremely careful with that, as the wire may pierce the hose. Alternatively, you can reverse, by plugging the hose into the "exhaust" .
Repair Help & Product Troubleshooting for Electrolux Epic 6500 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Small potato (yes) stuck in hose, dont know how to reverse. tyvm

Possibly, find the location in the vacuum hose, where the potato is stuck, squeeze the hose there to force the potato to break up into smaller pieces that can be sucked through. If it is stuck in the "wand" the solid part, a straightened out wire coa ... Electrolux Epic 6500 Vacuum

I have a Dyson 17, the Absolute Brand special for pet hair. I think I have a blockage in the hose. Symptoms are: spewing out fuzz balls and small particles. I have checked all the blockage sites recommended by Dyson and all are clear except a small flexible transparent hose, 6 or 7 inches long, curled up underneath the cleaner head/brush bar unit. Any ideas? I've tried to pull out the stuff stuck in there, but I'm afraid to perforate the hose and I don't know any way to disconnect it.

Try dropping something like marbles into the hose and shake it up and down, may loosen it up enough to draw through.hope this helps you out. ... Vacuums

How to reverse hose on electroluc epic 6500

... Electrolux Epic 6500 Vacuum

My Dyson vacuum works fine for cleaning the rug but the hose doesnt get any suction at all. I removed the hose and all the parts around it that I could and dont see any clogs or broken pieces. I lost my manual so I dont know if this is addressed, or if there is a switch Im not flipping. Gave it a thorough look but found nothing.

Hi there,Sorry to hear you're having a problem with your DC07. If you have suction through the cleaner head but not through the wand, it sounds as though you have a blockage. Although you say you've already checked for these, you may find ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My Kirby shampooer - G4 - hardly used any water from the tank and no suds at all. Pet hair did blow out of the small slotted holes in the tray as I moved the shampooer back and forth, but the carpet was basically dry. I did vacuum before shampooing, so the brush part seemed to work great during shampooing, but no water! The small screen was stuck in the crook of the hose that attached to the tank so I did get that out and put it on the small hole on the tank, but it didn't make any difference. I

Few things:Make sure the sponge and the valve under the sponge (water tank) is clean.Make sure you follow the instructions (f you do not have the manual you can find one ... Kirby Ultimate G Bagged Upright Vacuum

Handle relase stuck in upright position and I have the vacuum apart and I dont know what to do what am I looking for it is still stuck

Dirtdevil vacuums are so cheap. it's jammed. just go to a vacuum shop and get it repaired ... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

I have an Electrolux Lux 7000. My son sucked a small towel into the hose, which is stuck inside the hose close to the attachment end. Can this model blow expel air so I can blow the towel out?

If it does, it should have a door on the top near the back. But if not then something like a plumbers snake or long needle nose plyers may help get it out. ... Vacuums

I have a Bissell power steamer 1631. I do not know how to fill the tank. Where do you add the shampoo? Also, the hose has an added small tube or hose like thing, where does this connect to?

A look here: http://www.bissell.com/Products/c/uprightdeepcleaner/p/1623PSPBS/ak/features/product.aspx ... Vacuums

I took apart my 1697 model cleaner to check the hoses for leaks now I dont know if I put the hoses back on right. I cant find a diagram on how it is suppose to look.

I found a manual that has an assembly guide for your model:\015\012http://www.bissell.com/downloadfile.aspx?id=554\015\012\015\012\015\012\015\012\015 ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

I have an Air Track plus vacuum cleaner and something has got stuck between the flexible part of the hose and the solid black section at the end. I tried to put a coin down to clear it but that has got stuck too. It looks like the rigid section should come apart (a small notch each side) but I can't figure how to do this.

... Samsung Vacuums

I have the brother Ls-2000 sewing machine i threaded the top as well as the bobbin but when i try to sew the thread gets stuck and it bunches up and tangles in the bobbin. also the little bit that did sew was tight stitches on one side of the fabric but very loose on the other side I followed the instruction and it keeps happening i need help i dont know how to fix it please help me

Adjust your tension.You probably did not wind your bobbin properly as well.Make sure you oil your machine every month or so and make sure your bobbin is seated properly before you sew.\012\012Go slower with the pressure foot speed and use the r ... Vacuums


... Dyson DC27 Bagless Upright Vacuum

Hello! The suction in my Dyson animal is very poor. I discovered small holes in the internal hose, but even after a quick duct tape fix, still having issues...sounds like the seal from the canister to the vacuum is leaking air. I know I need a major repair but my mother in law is coming tonight! Any suggestions? ~Lisa

Or you can do this for free:\015\012\015\012http://www.ehow.com/how_5870417_modify-dyson-prefilter-suction.html ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My versatility electrolux vacuum is 2 years old and it has lost its suction, i have replaced the filters and checked every hosing area i have access to, it seems to all be clear. I dont know what else to do, it has a higher pitched whinnig sound when it is on

It sounds like the fan blades have worn away until there's basically no air resistance, thus no air flow/suction. The whine is created by the motor turning at a higher speed due to lack of resistance. \015\012The fan wasn't covered by the wa ... Electrolux Vacuums

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s

I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

I dont know where to connect the hoses - Kirby G4 Bagged Upright Vacuum

Assuming you dont have the manual, you should try to google " manual for kirby G4" and you should see it there. you also have the option of downloading the manual in PDF format, to be opened with adobe reader, which can be acquired from ... Kirby G4 Bagged Upright Vacuum

I have no suction for vacumming the floor. the wand is totally still working and sucking it heart out. clear hosing doesnt looked cracked. dont know where else to look.

Hi, if the wand is doing its job very well, you have to have a blockage some where, either in the hose where it attaches to the bottom of the unit near the roller section. It may be hard to see, but this is what is causing the bottom from not picking ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Cleaning uphoustry I cant figure out how to attach the hose to clean furniture dont know how to hook up attachment to clean upholstery

Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=40488&thid=539310\015\012Cleaning upholstery\015\012Posted by renee123456 on Apr 23, 2008\015\012Hoover ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Shop vac quiet plus series 8 gal 2.5hp blows all small particals and dust out the back vents, dont know if installing filters correctly?

... Shop Vac Vacuums

I have a sock stuck in the hose of my vacuum cleaner. Rennaisance canister model. Because of the design of the handle I can't utilize the reverse blower. Please advise. Thanks

LolTry taping a fishing hook or some such onto the end of a straightened out coat hanger. See if you can push it up the hose and hook the sock.Or, remove the hose entirely, and push a broom handle down the hose.Tha ... Vacuums

It vaccum but it is really loud i dont know if there is something stuck in it or what is causing the problem.

It could be due to a stretched or worn drive belt. Here is a link to the owners manual which has instructions and a link to the\015\012belt you need. ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Dissasemble to clean pump and dont know how hoses go connected again

... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I dont know the order of the hoses so that i can put it back together

I really don't know what vacuum you have, starting from the vacuum find the one that will snap into the vaccum itself (its normally the wider hose).Then size wize, they should graudaly get smaller on most vacuums.if all the hoses a ... Vacuums

Cant get my soap dispenser hose working on my karcher winner 10, any suggestion?, lost my instructions manual so dont know weather i need to be doing anything for it!

If you have not yet found a solution, then here are some steps to take.\0121. The soap dispenser only works on low pressure!!!!!!! So you have to\012 REMOVE the high pressure Sprayer so that all you use is the Trigger \012Gun without the Ext ... Karcher Vacuums

How to Reverse the hose at inlet on power unit on centralux E130A

That is the easiest way, just hold the attachment end of the hose into dirt inlet (preferably the one on the unit itself) and use your hands to try and seal the end as best you can. ... Electrolux Centralux Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6316 seconds