Having problems with your Electrolux Epic 6500 Vacuum ?

Solutions for "heidelberg windmill" problems

Answers :

This a topic for vacuum cleaner troubleshooting. And you are talking about the Heidelberg letterpress model T 10x15 , what do you need?
Repair Help & Product Troubleshooting for Electrolux Epic 6500 Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Solutions for "heidelberg windmill" problems

This a topic for vacuum cleaner troubleshooting. And you are talking about the Heidelberg letterpress model T 10x15 , what do you need? ... Electrolux Epic 6500 Vacuum

I posted my problem earlier today that I was having with my Bissell Little Green Machine not dispensing solution, but sucked up no problem. Someone said that the most common problem was a blockage. We put hot water in the reservoir for 15 minutes as advised and it still will not dispense. The fluid is now ''dribbling''so it is better. It is just not spraying. We are able to blow from the end and make bubbles in the reservoir which shows us it is not blocked. Any other suggestions?

Okay. I fixed this on mine. Undo the screws on the handle, right by the trigger. You pull the tubes off the little valve. Push on the button and see if you can blow through the valve. If not, push a pin around in the valve (with it pushed into the ... Bissell 1720-1 Little Green Wet/Dry Vacuum

I have a Model F7431-900 and is a SteamVac V2. When I press the trigger for water or cleaning solution, the water just runs right through it even after releasing the trigger. What kind of problem do I have? Is it most likely a valve problem? I'm handy at fixing things and want to avoid the large repair bill if I take it in.

This sounds like a stuck solenoid. The Dual V models use solenoids to contol soap and water flow to the floor, along with a pump unit. If your unit is 12 months or less it is under warranty. I am not sure about the cost of the solenoid. ... Hoover SteamVac V2 6-Brush Widepath F7426-900 Vacuum

Cleaning solution When I press the release button the solution does not come out. What could my problem be?

With mine, the problem was that the drain plug was not being pushed into the solution tank far enough to release the solution. Pushing down on the solution tank while squeezing the trigger in the handle released solution. Since ours is a first gene ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

I've recently bought a hitachi HDR505 & haven't had a problem using it with an indoor ariel other than the fact in bad weather conditions there have been problems with the signals. So I tried to attach the ariel wire that connects from a box in the corner of my living room which connects to the outdoor ariel but cannot connect it into the 'ariel in' compartment on the box as it does not fit into that hole but does fit into the 'ariel out' hole. Please could I get help with a solution asap as I w

... Hitachi Vacuums

Hoover steam vac model 7210-900 problem: when i install canister of cleaning solution it immediately starts flowing out of the outlets where the brushes are located. any idea on solution to thisproblem?

Http://hoover.com/support/video-instruction-guides/ and see the video respectively according with your model, use the common sense for troubleshooting.God bles ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a bissell pro heat carpet shampooer model # 8910 and it will not spray any solution out what could the problem be its only been used twice without any problems

Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.B ... Bissell 8910 ProHeat Clear View Upright Vacuum

Attachment problem used a new unit w/attachment for 5 minutes...dispensed solution in a powerful triangular fashion. Then the fluid quit dispensing out of the attachment nozle amost like the pump quit working. Primed the unit several times w/ no success. checked for clogs. can't tell if the floor portion is "pumping' or just dribbling solution onto the floor with the trigger. can see no leaks at this point. unit worked for about 5 minutes on apholstery

Make sure everything is filled and secured tightly, if this a new unit it should be something simple ok, also check where machine folds down that the solution hose is not being pinched its right behind the dirty water tank ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Bissell Proheat Turbo 2x model 9300. It has stopped spraying at the floor. The hand tools will work so I assume this means the problem is at the base somewhere. I cleaned the nozzles but don't know what to try next. It has always had a problem with dumping too much cleaning solution as well, don't know if this is a contributing factor

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Dear sir, i needs a solution for chinese nokia 6300 mobile's white screen problems so help me how i can solve this problems please.......... fast help me sir. thank you

Remove the memory card and battery replace batterry after 30 minutes to hard reset. If the phone boots up then check card for errors, virus, delete, format as required and reset.\012If this wont solve , you will need help fromNokia care to rein ... Vacuums

On several occasions the belt has come off the Hoover Windtunnel beater shaft and had to be re-installed. Is there any way to prevent it from slipping off? The shaft seems to be made so that the middle if it is wider(thicker than either the end or the part closer to the motor, which, to me, is a bad design so I don't know how to overcome this problem. I'd be very grateful for a permanent solution to this problem. Thanks in Advance, mas

Your belt is stretched and needs replacement ( # 38528035 ) . The agitator is crowned so that the belt stays centered. ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

I own a Bissell Proheat Pet Model 8910. After just a few uses and changing both the brush and pump belts (trying to resolve problem) carpet doesn't get wet any longer. Carpet solution comes out normally but the water barly leaves the section of the tank I fill water into, resulting in carpet recieving to much solution and not enough water. Any advice?

... Bissell 8910 ProHeat Clear View Upright Vacuum

We have a Hover F7411-900 which runs great but for some reason the wash does not dispense the cleaning solution. It works fine on rinse but not on wash. We tried cleaning the round piece at the base of the cleaning solution but that did not fix the problem. How can you repair so that the wash will work.

That would be the wash silonod, the thing that makes the soap and water mix together in order to make the soap come out at the bottom were the brushes are. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I was trying to repair my wife's kitchenaid mixer and took part of it apart, including the back part, where the electrical connections are. The original problem was the plastic gear was damaged -- I finally had the good sense to find the solution for that problem on the internet and replaced the damaged part. But now the mixer just won't turn on. I don't think I damaged anything in the electrical section, but I suspect I either blew a fuse or somehow disconnected something.

Do you have a model number? Is the voltage getting to the motor from the switch? ... Vacuums

I have an older model F6056-900 Hoover steamvac Spin Scrub Cleaner. My first problem was that I loaned it out to a friend. Anyway she ran over the hose (used for attachments) with her car. I tried using the cleaner for carpet cleaning this morning but when I tried to put the solution tank into place...its loose...won't snap back in like it used to. When I can get it somewhat in place the solution just complete drains out through the bottom fo the tank. The leak is where the small hole on the bot

... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Suction button Although my Hoover Spin scrub is working perfecting dispensing the solution, when I go to suck up the solution from the carpet--I am having problems with the RED suction button that keeps popping up. I have to stop the cleaner and lift up the dirty water container to break the suction. Ive tried cleaning the netting that is encased around it, but still no luck. Any help would be appreciated! Thanks

This happens when the filter on the inside of the lid for the dirty water tank is pushed all of the way up. You need to leave a 1/4 in. gap from the top to the top of the filter ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Cleaning Solution It really isn't a mechanical problem. I would like to know what kind of solution I need to put into my machine. I bought it used and if didn't have a manual and I can't recall what I was told to put into the machine. I hope someone can answer my question. Thank you in advance Phyllis Woodall.

Most any brand name carpet cleaning solution will work. I like ZEP from the Home Depot. Nice fragrance, low foam and economical vs. Bissell, Hoover, other appliance brand names. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Can't find your solutions. I found my problem

The solutions are sometimes hard to find. As someone who provides answers, I have the same problem at times when looking at answers and responses.Let me know the make and model of the vacuum, and what problem you are having, and I will tr ... Vacuums

A solution to many "non-spray" problems.

The Scotchguard is going to be dicey inside the Bissell, yes, as you have learned the hard way.\015\012\015\012I think the Bissell and the Hoover shampoos sold for their carpet cleaning machines are reasonably safe to use in the Bissell. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell 7920 ProHeat Problems--No solution spray

Is the smart mix valve turning and stopping where is is supposed to, if it turns all of the way around, then it is broken inside the top cover. Try replacing the smart mix bottle insert and cap asm part #2101795 . Make sure that the rubber gasket i ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Cleaning solution distribution problem

Hope the above link was helpful!!! ... Kirby G6 Bagged Upright Vacuum

Cleaning solution isn't coming out. What are dimensions of new tubing. Is this the best answer to my problem?

Take a sample of the plastic hose to an auto parts store or hardware store. About 6' of hose should be enough. Find something more pliable (rubber), but not too fat. ... Hoover F5906-900 Upright Steam Vacuum

Thank you I spent 3 hours on this problem before I got to your solution about the filter being 1/4 inch from the top. WOOOOHOOOO!!! I thank you!

Glad to help\015\012 ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Floormate Spinbrush The water comes out fine to clean but when I out it on the wet pickup setting, it piskc up in streaks and it has the most horrible sound while moving it around, like the rubber is going across the floor dry. Any solutions or anyone with similiar problems and a fix?

Not sure if this will help but these machines are ment to be used in one direction not back and forth like a vacuum cleaner. You should start in one spot and pull towards you slowly with the trigger depressed it is designed ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Bissell I inherited the Bissell Model 790 Steam Vac. No solution will come out. Apparently it's clogged somewhere as the previous owner appeared to have used it to vacumn up a powdered carpet cleaner. How do I resolve this problem as the machine is barely used and I would like to salvage it. Thank you

Check the belts first, if ok, does water squirt out of the hose nozzzle, if it does then the heate in the handle asm. is clogged where the tubes hook up to it. If no water squirts out, the the pump isn't working. Pull the top cover off, check all t ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0453 seconds