Having problems with your Electrolux Ergospace Green Canister Vacuum, EL 4101A ?

I have an Electrolux EL 4010A, canister that needs a cord re-tractor replacement..

\015 I was able to locate (6) 1" screws (some in front and some in back) holding the top to the bottom section of the canister. Apparently however there must be something in the middle near the handle area that is preventing the top of the canister from lifting off. Anybody have an idea?\012Thanks\015

Answers :

Repair Help & Product Troubleshooting for Electrolux Ergospace Green Canister Vacuum, EL 4101A

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have an Electrolux EL 4010A, canister that needs a cord re-tractor replacement..


... Electrolux Ergospace Green Canister Vacuum, EL 4101A

I have a very old electrolux canister vacuum that needs the cord winder mecanism with cord replaced. Where can I locate this part?


... Electrolux Vacuums

Need to replace cord rewinder on electrolux tank vacuum cleaner. How does the canister come apart?


If it's the older style open front and the two rubber strips on each side slide out. this should help you along. ... Vacuums

How do I open the canister of the Aerus Electrolux Lux Guardian? I need to replace the retractable cord mechanism. Aerus won't help me.


Hi there, \012\012This will not be difficult to open, however, inside may scare you. \012\012Remove your hepa filter cartridge (if you have one) \012turn the machine over. \012Undo the 6-8 screws there and pull the ... Electrolux Guardian Bagged Canister Vacuum

Need to replace power cord and can't find how to open canister to replace


I had the same problem and could not find the other screws. You need to pry off the power cord retraction button, you will find two more screws under there. It's pretty easy after that!!!! ... Kenmore 22612 Bagged Canister Vacuum

Have an older model Electrolux canister model. The electric plug is broken so I got a new plug to put on. When I cut the cord to replace the plug, the dang cord retracted into the unit. So how do I get access to the cord area so i can find the end to the cord!


Hi,\012\012You have to open the vacuum cleaner and look for the wire.\012\012It is located inside the circular wheel, where it wind itself up.\012\012Don't be afraid to open it, unless your willing to pay somebody just to install a ... Electrolux Vacuums

I have an aerus electrolux guardian canister vacuum. The cord was damaged but the retraction winder is still fine. I have ordered a replacement cord but I have no idea how to remove the old cord and install the new one. Am I over my head?


The winder is activated by a coil spring located in a drum. The drum transmits the power from the wire with 2 circular contacts. To replace the cable you must dismantle the case to access the drum, take the spring pressure out carefully as to not let ... Vacuums

My electrolux ambassador power wand quit working. I replaced the switch that shuts it off when the roller stops, but it wasn't the problem. The on/off switch is fine, the motor is fine. We have traced the problem to the wires inside the canister by opening the inside cover to the bag container. We see the power cords going into the canister but we're not able to get to anything. We can't find any screws to undo that would open it up in order to follow the wires deep into the canister. We've bypa


... Electrolux Vacuums

The power nozzle on my c141b model aerus electrolux canister vaccum no longer turns on. It was working when a large stringy object was sucked in. When hitting the red reset button, nothing happens. Is it likely that it is the fuse that needs to be replaced? All wires appear intact (I replaced the elbow assembly a few months ago.), and the sweeper moves freely.


It's not a fuse.\015\012Turn the power nozzle on it's top. Try to rotate the brush. If it won't spin, there's till something holding it. Remove all strings, threads, and whatnot from the roller. Try to rotate it again. If it still won't sp ... Vacuums

I need a new power cord for the power nozzle on my Electrolux 2100 canister vacuum. The power nozzle has part number N115M written on the bottom. I have found the power cord for power nozzles PN6 and PN7 online, and it looks identical in photos but I'm not sure if it's the right part.


You can buy the hose at an authorized Aerus Electrolux store. If near enough, they will deliver, if too far, they can ship it. The nearest dealer can be found using the below link. Just follow the instructions.\015\012Just provide the model ... Electrolux UltraLux 2000 Bagged Canister Vacuum

I want to open a Hoover S3825 Elite Cyclonic Vacuum to see if I can repair or replace the cord reel assembly. Currently the reel slowly draws the cord back into the canister once it is pulled out. I found the mounting screws under the rear wheels once I removed the hub but I do not know how to remove the rear wheels, everything is plastic. The front screws are under the front caster wheels and I think I need to take a screwdriver and pry off the little cylinder wheel to get to them by rotating


... Vacuums

Need to know how to open the canister of my Electrolux Ambassador vacuum to replace the switch


If you switch still"clicks" you need a switch rocker, if it no longer clicks you will need a new switch button. You will get best results with the genuine button from an AERUS Electrolux repair shopThere are a set of body keys under the b ... Vacuums

I have an Electrolux LE canister. It runs for about 2minutes then shuts off for about a minute , then turns on again and it keeps repeating this routine!!! It is driving me nuts. What part do I need to replace? Apparently it is over heating. Please help. Thank you.


The LE has a thermal cutoff. If the bag is overfilled or a bag breaks and clogs the bag chamber the vac will over heat. This also happens if the hose, wand or neck of the power head is obstructed. Try dropping a coin through the hose, look thro ... Vacuums

Wertheim 1600 Supersystem 1600 Vacuum Cleaner - can't get the last little screw in the middle of underside out so that I can open canister to see if cord needs replacing.


... Vacuums

Need to open the canister to get to the cord assembly of my Electrolux Lux 5000


Why do you need to get to the cord assembly?\015\012If the cord will not retract, tilt the vacuum to about a 45 degree angle and gently tug and release cord. It will usually retract.\015\012Due to problems ensuing from untrained persons ... Electrolux Lux 5500 Canister Vacuum

Need to replace 8175251 cord - Kenmore 23812 Progressive PowerMate Bagged Canister Vacuum


... Kenmore 23812 Progressive PowerMate Bagged Canister Vacuum

Took canister apart to replace power cord. some grid fell out before i could see where it was. need to know where it goes


... Oreck BB2000 XL Little Hero Canister Vacuum

I cannot find the short cord that goes from the canister to hose anywhere and it needs to be replaced...can u help me find the part model 106766


I believe you are looking for this part number: E-71986-1 and they have it atwww.ApplianceFactoryParts.com , put the part number in their search box and it should come up. Cost is about twenty dollars including the shippi ... GE 106766 Bagged Canister Vacuum

TOOK MY ELECTROLUX EPIC 6500 CANISTER MODEL 1762 APART TO REPLACE CORD REWINDER. TO MAKE A LONG STORY SHORT,MOST OF THE WIRES CAMES OFF OF HEIR CONNECTIONS. NOW CAN'T FIGURE OUT WHERE THEY GO WITHOUT A SCHMATIC. CAN ANYBODY HELP. THANKS CATHY


Hi,\015\012\015\012I will try to find a service manual for you. ... Vacuums

How do I disassemble Electrolux oxygen? I need to adjust the cord re tractor.


... Electrolux Vacuums

Electrolux epic series 6000 sr model canister...we put a new bag in machine but it wont turn on and the light is on saying the bag is full and needs to be replaced...we tried the on-off switch several times but it wont turn on...why?


... Electrolux Vacuums

I need to open my electrolux AP200 canister to reattatch the power cord which has become diconected. How does one open the shell?


... Vacuums

Need to replace the power cord - Electrolux Epic 3500 Vacuum


Please to go www. repairclinic.com and get the parts. God bless you ... Electrolux Epic 3500 Vacuum

Cord retracted into canister-how to take electrolux apart to get it out


You will have to take the cover off...it should be held together my a few screws. Just lay out everything in the orde that you take it off so it is easier to reassemble. ... Vacuums

Cord replacement I need to replace a damaged cord (the reel works). How do I get the top off so I can remove the back end? Once I get it off, will I be able to change the cord, or do I need to buy the whole reel assembly? (and thanks for the help - I love this site!)


You will probably have to replace the whole reel cord. Depending on your model, on each side, there is a bar in the middle that will slide off, then the 2 halfs will come apart. They will only slide in one direction. If an older model, there are s ... Electrolux Lux 5500 Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0775 seconds