Having problems with your Electrolux Guardian Bagged Canister Vacuum ?

Bad bag sensor

\015 Need to replace electrolux bag sensor...can I do it myself? Vacuum keeps turning off everytime I reset and switch on\015

Answers :

Yes it is very simple to take apart and replace. for screws on the bag door and then it is only 3 wires to pull off of old switch
Repair Help & Product Troubleshooting for Electrolux Guardian Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bad bag sensor


Yes it is very simple to take apart and replace. for screws on the bag door and then it is only 3 wires to pull off of old switch ... Electrolux Guardian Bagged Canister Vacuum

Series6500SR starts then stops-bag full light on-remove hose and it will run until Ipartially block the intake with my hand to simulate the hose. Bad sensor? how do Iopen this baby up? Can you send me parts?


There is an adjuster for the size of the dirt particles you are vacuuming on the top of the vacuum. Inside this adjuster moves an "O" ring up and down in a tube to adjust vacuum flow. The "O" ring is held in place by a plastic flange which is thin a ... Electrolux Epic 6500 Vacuum

My Windsor Sensor XP12 says the bag is full when it's not. I have removed the hose, brush, and filter and cleaned everything. I can put a bag on without the cover and it works great. However, when I add the bag to the front cover and close the latch the right way, it does not work. I'm thinking that the cover is not seating the bag correctly over the hole, but I can't figure out how to fix it. Any suggestions?


... Windsor SR12 Sensor Bagged Upright Vacuum

How do I clean the bag? I loaned it to someone that had 4 dogs! Needless to say the bag was very dirty, full of dog hair and smells really bad. I emptied the bag out but still cannot get all the hair out and wondered about how to clean the bag. Can I wash it? Thanks so much, Cindy


Yes you can wash it if it is from textile material, hand wash it i recomand, but not to sure if u can get all the hair out, but at least it will smell nice.\015\012\015\012A new bag isnt't to expensive either, depends on the model.\015\012\015\ ... Vacuums

Electrolux Epic 6500SR Full Bag sensor working, Does not Reset properly


The problem was a sticking switch that was not being reset. The vacuum on/off switch mechanism is comprised of two switches. One is the main switch that turns the vacuum on and off. The second is a shut off switch that gets tripped when the full b ... Electrolux Epic 6500 Vacuum

Cannister vacuum cleaner bag full sensor faulty.


... Electrolux Vacuums

Dirt sensor The dirt sensor on windtunnel supreme doesn't work anymore. It is a bagged windtunnel. The sensor remains red.


The sensor remains red. ... Hoover Windtunnel Supreme U5280-900 Upright Vacuum

Hi there, I have an excellent Electrolux (but older) Diplomat LX model which stops when the bag is supposedly full. It''s not full however, but merely 1/4 to 1/3 full. I'd like to reduce the "sensitivity" of the sensor or turn it off altogether. I don't run my vacuum with a full bag, but there's a limit. Please tell me how to address this problem. Thanks very much. Pierre


... Electrolux Vacuums

Windsor Sensor XP18 brush - Windsor SR12 Sensor Bagged Upright Vacuum


... Windsor SR12 Sensor Bagged Upright Vacuum

My vacuum windsor sensor 12 is not working. I have relaced the bag, the sensor, the roller, the cord and the air filter but is not working. can you help me?


... Windsor SR12 Sensor Bagged Upright Vacuum

No power to sensor SR 12. I also have cleaned rollers and filters and bags. I have reset the handle. When I hit the power the check brush and full bag lights flash once. That is the only power that is getting through.The unit was in storage for a bit and got wet but its been drying off for a couple months. Is there something I can check or replace. Its a great Vac.


... Windsor SR12 Sensor Bagged Upright Vacuum

We understand that your problem is: I currently own and use on a regular basis the Kenmore Progressive upright bagged vacuum. Model number 116.35923500. The headlight flickers and the intelliclean light stays red. Ive tried cleaning the intelliclean sensors, changed the bag, and cleaned off the agitator. Is this a power issue? Should I take it to the store? Any suggestions would be greatly appreciated


Welcome to fixya\012\012Hello\012\012 \012\012I have a solution for this ... Kenmore Progressive 35922 Bagged Upright Vacuum

My windsor sensor xp12 wont turn on - Windsor SR12 Sensor Bagged Upright Vacuum


... Windsor SR12 Sensor Bagged Upright Vacuum

Windsor sensor says bag is full when its not


Are you vacuuming up fine particals like pet dander or just large amounts of regular dust? Also when was the last time you replaced your filters? \015\012\015\012Just some sugestions. ... Windsor SR12 Sensor Bagged Upright Vacuum

Bag Full Sensor


Opening The Unit:\015\012Remove the hose, open the door, and remove the bag. Making sure that the door is open wide enough, pull the rubber strip on each side of the canister toward the opening until they are completely removed. With a little s ... Electrolux Epic 6500 Vacuum

Bag full switch is bad


I assume this is an Electrolux Canister with long narrow body and a dial control on top for adjusting the bag fill level.. Please confirm model and name on canister, as in LE, Ambassador, Renaissance, etc. If this is a plastic bodied unit with ... Vacuums

Dirt sensor red light doesn't come on - Eureka Smartvac 4870 Bagged Upright Vacuum


Your either real clean or its just the bulb burnt out.....or the sensor..if u have a waranty,I would call the maker,but if it still sucks,then Thats a minor thing.Its up to you,if you want them to replace it ... Eureka Smartvac 4870 Bagged Upright Vacuum

WIndtunnel TurboPower U5400-900 sensor light flashing even though I just changed bag


They do this as a matter of course. its a poorly designed vacuum. Hoover doesnt exist any more, it is actually a dirt devil\015\012after years in the vac repair business, i reccommend that you look at panasonic the next time ... Hoover U5420-900 Bagged Upright Vacuum

Eureka 4467AV overheats and shuts down after about 3 or 4 minutes of operation. I pulled all the filters to assure no blocked air flow. I assume the motor is not getting enough cooling air but i can't figure out why. checked bag for blockages as well as hoses. could the thermal protection have gone bad?


... Eureka 4467AV Upright Vacuum

Will an electrolux vacuum work without the bag sensor


... Electrolux Guardian Bagged Canister Vacuum

When using the vacum it is giving off a bad smell. we do have a dog but i haver changed the bag and changed the filter


If it is due to the dog, it is common.\015\012Take some cotton balls, put some of your favorite cologne or perfume on them and **** them into the cleaner.\015\012You can also spray around the inside of the bag area and the hose with Lysol. ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

My hoover really smell bad, changing the bag and washing out the cylinder have not stopped it


Are you smelling a burnt rubber smell? If you are, you need to replace your belt. You can get hoover replacement belts here:http://www.vacbelts.com/index.htm ... Hoover Vacuums

I have a dirt devil featherlite plus and all of the sudden it started pushing hard and smells hot. I cleaned the roller, changed the bag, checked the belt. The belt is a little wore, but not bad.


If it is pushing hard then you still have a belt problem. It may not be broken but the belt is stretched out too long and will not turn the roller brush fast enough to make it push easy. ... Dirt Devil M085500 Featherlite Plus Bagged Upright Vacuum

Need to replace vacuum door - Windsor SR12 Sensor Bagged Upright Vacuum


I pried up the back of the cover holding the height adjustment wheel and was able to snap the cover axle with the cover installed into place. ... Windsor SR12 Sensor Bagged Upright Vacuum

My Kenmore canister vacuum smells bad while in operation. Replacing the bag does no good. I removed the HEPA filter and it smelled fine. How do I correct this problem??


... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0272 seconds