Having problems with your Electrolux Guardian Bagged Canister Vacuum ?

A sock is stuck in the nozzle. won't come out . how do you take it appart?


Answers :

Remove the power head from the wand. Turn it upside down on a table or counter. There are 5 screws to remove to take the head off. There are
\015\0123 on the long part just in front of the brush roller and 2 more on each corner of the short part. Once you have the hood off you will be able to remore your sock, then put back on the hood.
Repair Help & Product Troubleshooting for Electrolux Guardian Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

A sock is stuck in the nozzle. won't come out . how do you take it appart?


Remove the power head from the wand. Turn it upside down on a table or counter. There are 5 screws to remove to take the head off. There are \015\0123 on the long part just in front of the brush roller and 2 more on each corner of the short par ... Electrolux Guardian Bagged Canister Vacuum

Cable stuck in machine (sphera 20). How do I take apart to release cable please? I cannot see any visible screws to take the machine apart. Cable will not retract or come out of machine


... Bosch Vacuums

Cord stuck wont come out


Click on this link for fixhttp://www.youtube.com/watch?v=wO_dqcAxB7A ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Water wont come out when handle pressed to do floor or out of nozzle for upholstery cleaning smells hot when trying to get it to work could this be a belt


Yes it most likely is the belt ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

How do i take the clear veiw window off of my bissell proheat carpet cleaner to clean it? I've removed the 2 screws on either side but it still wont come off.


There are 2 screws at the lower front of the clear panel. Remove both of these then lift up the panel carefully and make sure that the rubber gasket at the top of the panel is not lost. This may take a little force if you have not done this before. A ... Bissell 8910 ProHeat Clear View Upright Vacuum

Sock stuck in hose midway. Unable to getit out with wire or brrom handle. Is there a way to take hose apart at either end.


If the sock is midway, taking either or both ends apart won't help. Take it to a vacuum repair shop and ask them to try to unplug it. You may need to buy a new hose. ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

Water wont come out the nozzles - Hoover F5411 SteamVac Jr. Canister Vacuum


Its plugged up somewhere along the hose or not connected correctly ... Hoover F5411 SteamVac Jr. Canister Vacuum

A baby sock was sucked up and stuck where i can't see it in my regina electrikbroom cleaner - 11.4 amp. i have tried to get it out and now i have to take it apart i think and can't get the housing apart - what should i do?


... Regina ElectrikBroom RG100 Vacuum

No suction i have been using mine for like a year or so. today i went to use it and then no suction. the water comes out but it wont **** it up. I haven't had any problems till now. I cleaned the little red filter but still nothing. I dont wanna take it apart with out knowing what im looking for.


I had exactly the same problem with my five-year old my Bissell 7920, and it's probably a broken pump belt.  See page 19 of your instruction manual for how to replace.  The Bissel ProHeat belt accessory pack costs $3.99 and you get a pump b ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I have got metal numatic tubes that are stuck but wont come apart


Actually there is a solution. \015\012\015\012If you try and pull the tubes out it wont work as its friction fit. However if you move them from side to side a little, keep wobbling and they will eventually loosen. This will work unless the tube ... Hoover Vacuums

My cigarette injector nozzle on my Top-O-Matic keeps coming off. Why and how do I fix it? With glue? I put the tobacco in, and my empty cigarette tube on the nozzle, then use the hand crank to push the tobacco into the tube and the NOZZLE is coming off with the tube and the tobacco isn't filling the tubes. please email me back a response [email protected]


... Hoover H3030 FloorMate SpinScrub 500 Upright Wet/Dry Vacuum

Sock stuck in the vacuum


My fan changing guide will lead you through the process of taking the vacuum apart to get to the sock (if it is still in there)...\015\012\015\012 ... Kirby G4 Bagged Upright Vacuum

Stuck sock i have a sock stuck in the handle right where it curves from the hose...i tried a wire hangar but it doesn't budge...does the handle detach from the hose?


Don't put a hanger in there.... Call your local Aerus Service Center and they can remove it for you . If they tear the hose its their responsibility to replace it. If you tear it you are looking at $119.99tx at least. ... Electrolux Lux 5500 Canister Vacuum

Thermax motor to the nozzle/ power head wont engage when I pug in


... Thermax AF1 Canister Vacuum

THE BRUSH WONT SPIN AND THE SOLUTION WONT COME OUT


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Dyson dc25 hose wont come off wand


Tap it all round with the handle of screwdriver to loosen any dust that is stopping it from pressing in. ... Dyson DC25 Animal Bagless Upright Vacuum

How do you take off the hose head of the epic electrolux 8000 ?


THIS link is for the manual it will give you full instructions ..ENJOY...http://www.totalvac.com/manuals/electrolux_manual_Epic8000.pdf ... Vacuums

My Model 2961 Eureka wont take power now?


Hi,Anytime that you smell that electrical burning smell on a vacuum cleaner, this is the motor going bad. There are two distinctive burning smells in fixing vacuum cleaners, the electrical burning smell which is the motor, and a rubber ... Eureka 2961AVZ Bagless Upright Vacuum

Water wont come out to shampoo , but comes out furniture tool


You need to replace the pump belt. Here are the belts you need:Bissell Proheat Belts ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I sucked up an infant sock through the hose of my Hoover upright vacuum. The sock is stuck about half way down the hose. Can the hose be disconnected from the vacuum?


... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Dyson dc17 hose will not come out/ handle wont release from machine. i've pulled the metal rod up all the way and the handle still won't come away from the machine so i can't use the hose and attachments. anyone know what the problem might be?


Hi there, it is possible that you have a blockage in the wand/hose assembly which is making this difficult to remove. If you are able to remove it to check for this, please contact our Helpline on 1866MYDYSON so that one of our advisors c ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a bissell 92002 proheat steam cleaner and for some reason it wont spray anymore or ****... the moter goes and it dont smell or anything but the water just wont come out


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell 8920 proheat x2 brushes not turning i only noticed this after i finished cleaning.. or kinda cleaning because of the brushes ntot turning.. water comes out fine suction is fine but its not scrubbing so its not as clean as it could be. manual part works well water coming out hot. I did take it apart and cleaned off all the hairs in hopes maybe that was it.. put it together still nothing.. No idea how the belts should look onit and i cant find a picture or a video showing how belts look o


Hello,\015\012\015\012Here's a link to a very helpful video that shows you step by step on how to access and replace the belt on your machine. When the brushes stop spinning, but the rest of the machine works fine, this is a tell-tale ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Dyson Animal I sucked up a part of sock didn't get sucked up turned it off and pulled out sock but beater brush won't come back on.


Happened to me too. there is a reset somewhere, i got mine working again. try the Dyson website, sorry ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

How do i take apart the dyson,Theyre is something stuck in the hose extension. Is theyre anyway to take it off. The bottom part works . however theyre is no scution threw the hose


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0640 seconds