Having problems with your Electrolux UltraLux 2000 Bagged Canister Vacuum ?

Vacum won't ****

\015 Electrolux vacume cleaner won't ****....i put in a new bag.. motor runs great. hose is not plugged\015

Answers :

Do you have good suction right out of the canister without the hose attached? If so, AND your hose isn't plugged, you must have a pretty good sized hole somewhere in the hose. If you don't have suction at the canister, pull the filter cover off the top-back of the machine and remove the filter. This is where all of the air that the machine pulls in is exhausted. If something is plugged here, it will greatly reduce your suction. If you still haven't found the problem, you could have a problem with the fan assembly on the motor. But usually this is accompanied by some noise from the motor, but not always. Good Luck!!
Repair Help & Product Troubleshooting for Electrolux UltraLux 2000 Bagged Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vacume wont **** opened it up see nothing wrong HELP

If no suction usuallly means a clog, either in the hose and the dirt inlet by the brush roll. Sometimes if the belt is stretched, it won't turn the brush roll under load and it would seem like there is no suction. ... Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum

Brush on vacum wont make contact with rug, no pick up

If you take off the brush then reorientate the ends of the brush this will adjust height ends have a block depending on orientation they will set brush height This is common for many brush assemblies and should work for dirt devil ... Dirt Devil Vacuums

Vacume. motor wont spin

Most likely the carbon brushes are burnt out and need replacing. However - I wish I knew how to put this politely - if you don't know enough about electric motors to have checked for this already, you may not know enough to do the job safely yourself ... Vacuums

Dewalt 2gallon corded/cordless vacume...unsed one time brand new wont turn on. motor and switch both tested and work...any ideas

Check the battery contacts... a common problem on this model. they are easily bent and prone to corrosion. ... Dewalt Cordless/Corded Wet/Dry Vac 2 Gallon Vacuum

Taski bora 12 comercial canister vacum wont turn on

... Vacuums

My Kenmore Progressive Vacum canister wont turn on how do I remove the cover to check the fuse without breaking the cover?

... Kenmore Vacuums

My brushes wont turn once the vacum is on the carpet.

If they are turning when they're off the carpet, then you have the brush height setting set too low. There should be a dial somewhere near the brushes, some say things like "high" to "low" or "high pile" to "low pile." Turn it one notch towards hig ... Dirt Devil Vacuums

Changed belt in hoover windtunnel t-series not beater bar wont spin when vacumming

... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Wont **** up anything - Fantom Vacums Cyclone XT Upright Vacuum

That\015\012 type of vac is notorious for stopping up where the 90 degree turn is. \015\012You may need to access it from the vac head by removing the beater bar \015\012or take it apart where ever you can access the turns and hoses. ... Fantom Vacums Cyclone XT Upright Vacuum

The vacume turns on but wont pick up anything. I've emptied the bag and filter.

Its probably clog check the hose disconnect ... Kenmore 25512/ 25513 Progressive Canister Vacuum

My electrolux ultra active vacum cleaner wont work, its not even a year old, it will start then stop again and flash E

... Electrolux Vacuums

My dyson animal just cuts out mid vacuming ,the motor gets quiet hot ,and wont start again for an hour or so when i expect the motor cools down .all filters cleaned no blockages etc.. any suggestions?????

This is a feature so that the motor does not burn up check all tubes ... Vacuums

My kenmore vacum wont start

Hello, I'm sorry, but please post additional info such as any symptoms prior to not working, will it make noise, does it do anything. It can possibly be your fuse, but we need more info provided to be able to help you.Thank you ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Vacum wont power on - Bissell PowerForce Helix Bagless Upright Vacuum, Gray/Blue, 12B1

Hey Troy, sorry to hear about the no power. Here's a quick link to troubleshooting steps to assist you.\015\012http://www.bissell.com/FAQDetail.aspx?id=145 ... Bissell PowerForce Helix Bagless Upright Vacuum, Gray/Blue, 12B1

Fantom twister wont work light is on - Fantom Vacums FM780 Twister 700LX Upright Vacuum

When you say, "just stopped", did the MOTOR stop operating and there's no sound from it at all? Or, is the motor still working or sounds like it does, and it stopped vacumning?\015\012\015\012If the MOTOR stopped, most likely there is a ... Fantom Vacums FM780 Twister 700LX Upright Vacuum

Dyson Vacume dco7

If you have a warrenty put it to use! luckily i registered for the two year warrenty because i had a feeling something would go wrong i have constant bad luck with appliances ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Got nEw bElts for mach7 anD thE v bElt Wont turn it seems slack

... Vacuums

Hello, my names Travis. I was contacting you in concern of my Kenmore Quick Clean 12AMP Vacum Cleaner. My girlfriend took the bottom off the vacum and removed the belt because the vacum wasnt picking up. I know have a new belt i just dont know where to put it on the vacum to reinstall it

Look for grooves on the motor shaft and on the brush shaft. ... Kenmore Quick Clean 30012 Vacuum

Miele vacum motor dead

Would need more info to really isolate problem but you either need new cord reel, speed control board, or new motor. maybe all three. either way a make and model number would help ... Miele Vacuums

My Dirt Devil Model 088520 has a brush assembly that wont spin. How can I either change the bearing or free it up somehow? I have been searching for a new brush assembly part number 2860145000 but it

Try this link > http://dirtdevil.com/parts/category/brushrolls-uprights/ ... Dirt Devil Vacuums

Wont make calls wont receive calls wont send or receive sms

Hi. Can you tell me what brand and make is the mobile phone? ... Vacuums

Vacume did not come with screws to hold handle to Vacume need the screws handle falls off vacume hits the floor [email protected] Model # 3041 Type - B2 The answer is simple, send the screws please this will fix the problem. Thanks Dr.Tracy Massie Dr.Tracy Massie Harvard;Dr/PHD; Chief Officer of Internal Medicine;Lead Surgeon Dr. Child Disorders; Princeton Dr. / PhD.; Chief Medical Officer; Lead Councilor

... Eureka 3041BZ Upright Vacuum

The cleaning head of the vacume does not lock into position when I pick up the vacume, therefore when I raise the vacume th cleaning head just lays down.

The mechanism that locks the head into place is broke. Prob a plastic tab that broke off from so much use. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0329 seconds