Having problems with your Electrolux Vacuums ?

Cannister vacuum cleaner bag full sensor faulty.

\015 Electrolux C104H cannister vacuum cleaner. I am searching a service manual to fix this product myself. I appear to have a faulty bag full sensor. I have replaced the bag but this didn't solve it. I've bypassed and tested the bag full pressure sensor, but it is working as expected as tested with a continuity tester. It reads -2.5V with the bag door closed under normal pressure. It reads -1.7V with the bag door closed but a bag full overpressure condition present. It appears that either the power supply for the pressure sensor or the sensing circuit, both in the wand circuit is faulty.\015

Answers :

Repair Help & Product Troubleshooting for Electrolux Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cannister vacuum cleaner bag full sensor faulty.

... Electrolux Vacuums

Hi there, I have an excellent Electrolux (but older) Diplomat LX model which stops when the bag is supposedly full. It''s not full however, but merely 1/4 to 1/3 full. I'd like to reduce the "sensitivity" of the sensor or turn it off altogether. I don't run my vacuum with a full bag, but there's a limit. Please tell me how to address this problem. Thanks very much. Pierre

... Electrolux Vacuums

Electrolux Epic 6500SR Full Bag sensor working, Does not Reset properly

The problem was a sticking switch that was not being reset. The vacuum on/off switch mechanism is comprised of two switches. One is the main switch that turns the vacuum on and off. The second is a shut off switch that gets tripped when the full b ... Electrolux Epic 6500 Vacuum

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!

... Miele Vacuums

Hi My vacuum cleaner loses suction half way through the room and the bag is only about 10% full, I bought it in Oct 2007 and I am very disappointed withy it as the bags are very expensive and I have to replace them too often. Flora

... Panasonic Vacuums

Motor quit working. i was vacuuming and all seemed fine. then the motor went really low. when I opened it I noticed that the bag was not attached and the cannister had filled up with stuff and the filter was full. the vacuum will not run now.

My friend, the dirt you sucked up went right into the motor and it burned up. I am very sorry to tell you this. It is probably not worth repairing unless you are able to replace it yourself.\015\012\015\012In addition to not being able ... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

Sebo upright vacuum cleaner - Bag full or clog light on constantly when using as an upright but not when using detachment pipe. Bag changed and no sign of blockage. Is this a common fault or does it need to be taken apart by an authorised repairer?

Hello,\015\012\015\012I have actually written an in depth trouble shooting guide on how to find the clog in your Sebo. Since this light is coming on only when you have the wand inserted into the vacuum and are vacuuming the floor, this i ... Vacuums

My Oreck XL vacuum cleaner disposable bag does not stay attached. I had my husband put it on and again it came off. The cloth bag is always full of dust and suction is lost. What is the solution?

... Oreck XL Ultra Bagged Upright Vacuum

Red "bag is full" indicator shows even though new bag has been put in and vacuum cleaner wont pick up. Also floor adjustment does not adjust. This is for a powerforce model 3522 series

The red light tell you that it is sensing a full bag. But a clog in the hose or the inlet down by the brush roll will also do this. ... Vacuums

My almost brand new AEG Electrolux Ultraone vacuum cleaner has started making whining noise. Bag is not full. Any suggestions?

... Electrolux Vacuums

After replacing the bag, vacuum cleaner won't start

... Electrolux Vacuums

Vacuum cleaner does not start after getting warm, bag, that was full is changed, lights run across dispaly at top when I try to start it, cannot find my manual, can I download a manual for Excellio z 5240. Is there a fuse of something that has bo be reset?

... Electrolux Vacuums

Morphy Richards Pets vacuum cleaner, less than one year old. Not sucking, overheating, claims bag is full when it is new. I have looked for blockages but the hose is clear. Can't find anywhere in Aberdeen to repair it

Discovered I had a 3 year warranty on it so got a replacement. Thanks for your helpful advice! ;) ... Morphy Richards Vacuums

Instruction required for the removal of a full dust bag from Miele S5211 Model Vacuum Cleaner

Sure thing, the best thing to do is to have a look at the manual I have found here for you. The part you are looking for is on page 25 of the manual, complete with pictures and everything. Please make sure you rate my answer 4 thumbs up ... Miele Vacuums

Why my vacuum cleaner intermittently starts and stips while cleaning The dirt bag is not full.

The most likely cause would be a short circuit in the cord. Let the machine sit running in one place without moving it, and wiggle the cord to see if this is the problem. If it is, the cord will need replacement. ... Hoover Vacuums

I have a Z345 Electrolux cylinder vacuum cleaner, from the 1970s probably, but not used much. I have lost the guide. I forgot to change the bag before it was full. Smoke started to come out - smelling of burnt paper, not rubber. So switched off. It did not blow the fuse, and may be OK. I wish to inspect it. How do I open it up? Alos I have an air filter and a motor filter for it. I have often changed the air filter on the top. How do I get at the motor filter, if there is one? Than

Good day! OK you have to is replaced the bag and that's it.And don't forget to change the bag again to avoid that problem.Thank you ... Electrolux Guardian Bagged Canister Vacuum

Henry hoover vacuum cleaner keeps cutting out intermitently. I have checked all connections which are OK, problem is not with bag as is empty. Faulty motor??

... Hoover Vacuums

Somehow I have endd up with a cannister type vacuum cleaner and all I know about it is that it says model:VC-H3301. All I need to know is how to open the container full of dust and dirt o I can empty it. Can someone help?

Here is some info on that vacuum that may help you. it tells who sold it and what brand and where to get filters.\015\012\015\012http://www.fixed4fr ... Vacuums

We own an ElecktaPure Exclusive Edition EP-4000 cannister vacuum cleaner and we are having a heck of a time trying to find replacement bags for it. We could not find the original part number of a suitable replacement part number. Can you help?

... ElektraPure Vacuums

Full bag system works properly, but doesn't reset easily

Either there is something wrong with your switch. Which it doesnt sound like it. Take it to your dealer or call another one it sounds like the control valve needs to be replaced. I am a dealer 1-866-966-9350. ... Electrolux Lux 7000 Bagged Canister Vacuum

Repair my Electrolux 2100 cannister vacuum cleaner

On my 6500, I just disconnected the air line from the switch and now the vaccuum won't sense the bag pressure; I just have to check the bag myself now. ... Electrolux Epic 6500 Vacuum

While vacuuming the red light for the bag of the vacuum came on and the vacuum stopped. The bag was no where near full so I replaced it with a new bag - same problem. It vaccumes for a minute or then stops with bag light on. It is the correct bag for the machine - so what's the problem?

I'm assuming this is the Epic 6500 or similar model.\015\012Detach the hose, turn vacuum on. If it runs, place palm of hand against inport hole. If it shuts off the problem is with either the control valve setting or the control valve assembl ... Electrolux Vacuums

Won't start. My son was using the vacuum & Didn't change the bag. The vacuum was making the full bag smell, but the light was't on & it didn't stop. I stopped him, changed the bag, checked the filter, closed the compartments & turned on the vacuum. Nothing happened. I checked to be sure that it was plugged in, that wasn't the problem. I've let the vacuum "rest" for several days, It still won't start. Any suggestions?

There is a reset button at the back of the powerhead. The user manual can be downloaded from the electrolux website, although I didn't find it very useful. There was some info on how to change the powerhead drive belt. ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Need Hoover cannister vacuum floor brush & filter bags

Yes attachment are available just bring your wand into your local vacuum store to insure the proper fit ... Vacuums

My Grandson bought a Kirby (2009 Model) for his wife. They have since divorced and I have the vacuum cleaner without instruction book or bags. I have ordered bags but can't understand how to place bag on vacuum. The bags came with a black ring and I don't know what to do with that either. Please explain this to me. Thanks

You can order one from Ebay. Price varies, but expect to pay around $10.\015\012http://shop.e ... Kirby Generation 3 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1406 seconds