Having problems with your Eureka 2961AVZ Bagless Upright Vacuum ?

Kicking out debris

\015 This vac kicks out the back almost as much as it sucks in. I have to vacumn where I just vacumned. HELP\015

Answers :

Your vacuum will kick back dirt if there is a clog of anykind, or if the filters are dirty. First check the suction lines for any clogs, if none are found, take out your dirt cup, and take off the filters. Normally there is a foam prefilter covering a paper filter - replace both filters. The reason this happens, is that the filters allow the air flow at a specific rate, creating the suction and they cyclonic action you see when you are picking up debris. I hope this helps.
Repair Help & Product Troubleshooting for Eureka 2961AVZ Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Envirovac kicks debris back at my feet and is loud


It sounds like you may have build up in the fan chamber of this machine. If dirt gets building up on the fan it can cause a loud noise and reduce the suction to the floor tool. The motor is serviceable and can be cleaned. It could also have a moto ... Eureka High Filtration s Mighty Mite Enviro Vac Vacuum

Kicking out debris


Your vacuum will kick back dirt if there is a clog of anykind, or if the filters are dirty. First check the suction lines for any clogs, if none are found, take out your dirt cup, and take off the filters. Normally there is a foam prefilter covering ... Eureka 2961AVZ Bagless Upright Vacuum

I have a vx550cc that keeps kicking in and out quickly, then shuts down for a few seconds and starts up kicking in and out again. There is lots of suction at all the outlets and sweeps. The dirt bucket has been emptied and the filter cleaned. Al the LED lights light up when the motor kicks out, then back to one green when it starts back up. This unit has worked great for four years with no problems.


... Broan-NuTone VX475 Bagged Central System Vacuum

My Eureka Boss Widetrack leaves debris behind while sweeping. I have the setting for carpet and debris is left behind on the floor.


Check for blockages in the brush bar compartment and hoses ... Vacuums

My filter queen just had the motor rebuilt last year and was basically a brand new unit when I got it back. It is not picking anything up now when I vacuum. The beater bar on the carpet attachment is turning fine and when I take all the attachments off the hose I can feel the suction being created like it should be picking up debris just fine. I have emptied the canister even when it did not have much in it; however, it still will not pick anything up off the carpet. It picks up debris tempo


It sounds as if you have a clog inside the "Power Nozzel". They mention that there are "no user serviceable parts within the Majestic® Power Nozzle" My advice would be to see if you can see a clog with in reachable distance and try to remove the ... Filter Queen Vacuums

I have a new Euro-Pro shark model S3101. Used it one time and while I was doing my tile floor in my kitchen I reached under a cabnet to clean and hit the floor kick kind of hard and broke the head off of the shark. I have only the T shaped end on the shark now with the cleaning head broken off and looks unrepairable. I did kind of hit the floor kick hard but the plastic broke like glass. Can I put a new head on the remaining piece or is it repairable? thanks Angie


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Pro ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

On the DC07, the entire cyclone assembly must be removed to empty the dust, debris, etc. collected when vacuuming. On the top of the cyclone is a "trigger" that you lift with your finger to release the bottom catch, which allows a clear flap to open on the "clear bin," thus letting all the debris fall out. My problem is when you lift the finger trigger, it does not release the catch on the bottom. Since the catch won't release, I cannot remove the entire clear bin either from the cyclone.Any sug


Beofre you go to the extent of buying a replacement canister, you can remove the top and using a straightened coat hanger type thing open that bottom lid. Then maybe you can clean the rim and possibly add some silicone spry to loosen things up. Here' ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Model UH60010, Series X12.0, Mfg code K09A. While attempting to use the hose and the extensions to clean shelves, my wife reported no suction. I removed the brush roller and the plastic piece just below where the hose opening is located and saw a "flapper" door that was closed and had some debris sort of jamming it. I removed the debris, but the door requires extreme pressure to open to permit the dirt, etc to moved up thru the opening , through the hose, etc. I thught maybe that somehow tg


Hello,Check to make sure\015\012the dirt canister is empty. If dirt canister is full, then you will \015\012experience\015\012reduced suction. Empty dirt receptacle.\015\012 Could\015\012 be a clogged hose - ... Vacuums

My Dyson DC25 got stuck and wouldn't return to the upright position, I figured out that one side had jumped the track and gotten stuck in the square hole below the track. I did not want to break the plastic to force it back, so I removed the screw on the right side that was holding the kick stand on and removed the kick stand, also a spring thing came out. Problem is, now I have no idea how to re-install the kickstand. Can't find a technical manual or video anywhere, it can't be very difficul


... Dyson DC25 All Floors Bagless Upright Vacuum

Roomba goes in a circle moves about 5 inches and then turns in a circle again. It won't dock or go any farther than a few inches before turning in a circle again. The roomba has been cleaned inside and out. All hair and debri as been taken out of the wheels and brushes. i opened the case and cleared all the debri and i dusted the sensors in the front. Not sure what to do now.


... iRobot Roomba 550 Vacuum

EUREKA Bagless altima shooting out debris and not picking it up


Did u clean the filter? if u get a new one i would suggest a kirby. bu get a self-propelled model. THEY LAST FOREVER!!! ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Roomba won't pick up debris


I had this problem until I wiped the dirt sensor, which you will find under the rollers. ... Vacuums

IRobot 537 not picking up debris


... iRobot Roomba Discovery SE Bagless Robotic Vacuum

My Eureka Endeavor power paw is not working, there is no debris in it and the belt is secured. Why isnt it working


... Vacuums

Bottom flap to empty debris fell off


... Dyson DC25 All Floors Bagless Upright Vacuum

Dirt keeps kicking out


... Oreck XL3600 Bagged Upright Vacuum

Debris in front of foam filter


When that happened to me it was because the cup got full or was loose. I am now seeing the cup seal, located on the body above the cup, is not sealing and my filter is loaded. That might be a clue. ... Eureka 5892AVZ Bagless Upright Cyclonic Vacuum

My Dyson Absolute Animal is picking up, but there is debris ontop of filter after each use.....everything is cleaned and unclogged?


Hi Karen,I'm sorry to hear you're concerned about your DC17 Animal. We'd appreciate the opportunity to run through some troubleshooting over the phone with you to determine the cause of this issue. You can reach us on 1-866-693-9766 - alterna ... Dyson Vacuums

Sucked up some debris with Kirby, now the motor is not running right.


1) see the diagram attached.2) clean it3) test the belt for broken or crack4) motor can be faulty by enough pressure in the bearing and winding overheating repair or replace. ... Vacuums

My vacuum is picking up very little. No debris is


I have the exact same problem. The beater seems to turn just fine and the dirt is getting picked up, on it just sits in the hose. I don't think it's the best because it seems find, but who knows? Please help. ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Debris around the motor shaft


Remove sole plate then you can get to the belt ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Spinning debris in cup


If the 2 stage filters inside the bin chamber have not been washed then they will need to be - they sound like they are clogged or somewhere there is dirt which is blocking up the system. Also check the side part duster to ensure that the airways are ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Debris getting stuck in vacuum hose


Check that the filters are completely clean. If there are clogged they would have to be washed and then dried to room temp (or a low temp tumble dryer, put the filters into a pillow case with a towel and install into the machine) Tip the bissell back ... Bissell 3102-0 EasyVac Upright Vacuum

Debris gets caught in hose and does not empty into canister


... Kenmore Quick Clean 30012 Vacuum

Eureka Altima 2961 When shut off it leaves pile of debris on carp


Plugged up ... Eureka 2961AVZ Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0125 seconds