Having problems with your Eureka 2961AVZ Bagless Upright Vacuum ?

Eureka Altima 2961 When shut off it leaves pile of debris on carp

\015 Seems to vacuum fine but when I shut it off, it leave a big pile of debris behind it?\015

Answers :

Plugged up
Repair Help & Product Troubleshooting for Eureka 2961AVZ Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Eureka Altima 2961 When shut off it leaves pile of debris on carp


Plugged up ... Eureka 2961AVZ Bagless Upright Vacuum

EUREKA Bagless altima shooting out debris and not picking it up


Did u clean the filter? if u get a new one i would suggest a kirby. bu get a self-propelled model. THEY LAST FOREVER!!! ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

My Eureka Boss Widetrack leaves debris behind while sweeping. I have the setting for carpet and debris is left behind on the floor.


Check for blockages in the brush bar compartment and hoses ... Vacuums

Brush just keeps blasting debris about? - Eureka Altima Upright Vacuum Model 2996AVS Vacuum


The hose or channel between the brush housing and the suction portion is blocked ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Every time i shut the vacuum off it leaves a pile of dirt on the floorthe floor


... Dyson DC28 Animal Bagless Upright Vacuum

Eureka Altima Vacuum Cleaner w/Power Paw


The way I resolved the problem was to remove the cover at the end of the power paw. Then remove the so side black covers for the shaft. Remove any debris and hair and then put back together. This solved my problem. ... Eureka Vacuums

How to change belt in eureka altima vacuum - Eureka Altima Upright Vacuum Model 2996AVS Vacuum


Here is the belt you need to replace and the manual which has instructions:Eureka Altima Belts ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

I HAVE A EUREKA ALTIMA AND CANT CHANGE BELT - Eureka Altima Upright Vacuum Model 2996AVS Vacuum


The hood will come off if you loosen two screws at the front on top of the hood by the brush bar bit that is slightly raised. Then there's a screw to the left hand side of the upright either below the hose or duster area. Once all screws are undone, ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Eureka Altima I have a Eureka Altima vacuum and can't get the dust cup out.


The dust cup has a small gray tray that appears to be part of the cup, but is not. I made the same mistake also and almost broke the stupid thing trying to get it out. Simply push the lock to the left to unlock. Gently lift the dust cup and not the g ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Eureka altima model 2993 how to change belt - Eureka Altima Upright Vacuum Model 2996AVS Vacuum


... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Eureka Altima Spitting dirt back out


Your intake is clogged at the bottom and your filters are dirty not letting it create suction.is the dirt cup full ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

My eureka enviro vac shut off and wont turn back on it was clogged but does not smell burnt . is there a reset or some kind of shut off when it gets clogged?


Same thing happened to me. I checked the owner's manual and it turns out the Eureka Envirovac has a built-in thermal cut-off switch. So anytime the motor gets too hot, it just shuts down. Most of the time this is because it gets plugged or the fil ... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

I have a eureka multicycle, it shuts off during use. It works for 5-10min then it shuts off and will not turn back on until it sits for sevaral hours.


... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

Eureka IMA Vacuum - brush not turning - Eureka Altima Upright Vacuum Model 2996AVS Vacuum


Your belt is probably stretched or broken. Here is a link to the belts you need and to the manual which has instructions:Eureka Altima Replacement Belts ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

When switching the vacuum (DC17 Animal) over to the hard surface setting (so the beater brush is not spinning), the vacuum shuts off. I cleaned the dust bin and checked the filter. I also cleared the beater brush of hair or debris that was wrapped around it. It still shuts off. Ideas? Thanks.


The drive belt has probably broken. You can get a replacement belt here:Dyson DC17 Belt ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Manual for eureka altima 2961 vacumn - Eureka 2961AVZ Bagless Upright Vacuum


Here you are, Please vote and rate me if this helps.\015\012http://www.eureka.com/service/manuals/80244.pdf ... Eureka 2961AVZ Bagless Upright Vacuum

How to change belt on eureka vacuum 2996 - Eureka Altima Upright Vacuum Model 2996AVS Vacuum


The information you're looking for can be found on page 8 of the manual via this link: http://www.eureka.com/service/manuals/80244.pdf ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

My Eureka Endeavor power paw is not working, there is no debris in it and the belt is secured. Why isnt it working


... Vacuums

Why does the eureka whirlwind electronic plus vac keep shutting off


... Vacuums

How do I change the belt on Eureka Altima 12 v


Here is\015\012a link to the owners manual which has instructions and a link to the\015\012belt you need.Eureka Altima Owner's Guide ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Eureka Altima (yellow)


I found it is easiest to clear the hose with a plumbers zip it strip . Harbor freight has them pretty cheep ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

How do I to change the belt on an eureka altima 12?


The belt is on the bottom right (looking at it from the front). the Eureka website does have the manual for download, http://www.eureka.com/service/manuals/8024 ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

I would like to disassemble my eureka altima to clean brushes


The Altima line has 2 screws on the hood (part where the knob is that says high carpet and low carpet) that you remove with a philips head screwdriver then you just lift the hood of the vacuum ... Eureka 402A Bagless Upright Vacuum

My Eureka Airspeed vacuum keeps shutting off after about 5 min...It takes for about 3 days to vacuum because it will not turn back on for several hours...and it is not clogged. What is the problem


... Vacuums

Eureka vac cv3291 won't shut off


... Eureka Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0442 seconds