Having problems with your Eureka 3276AZ Pet Lover Bagless Upright Vacuum ?

How to open bagless vacuum

\015 How do I empty the canister\015

Answers :

Repair Help & Product Troubleshooting for Eureka 3276AZ Pet Lover Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Piccolo 2 bagless vacuum - Can't find out how to open dust container


... Vacuums

I have a Kenmore 116.36932 (upright-bagless vacuum) that the motor protector by-pass valve has opened. I've clean out the area between the agitator brush where the flexible extension hose starts. There was some blockage there. I checked the rest of the system (extenstion hose, back filter area, pipe area to canister and area to side filter. I took the 2 filters out and the by-pass valve is still open. Where else could there be a blockage that I can take apart to clean and put back together


... Vacuums

We have the Kenmore progressive direct drive (bagless) and have had it for about 3 years. We have taken good care of it, and paid quite a bit for it hoping that it would last for a good long time. It has started making a noise that seems to be an overflow air type of noise coming out of a bottom air outlet opening for when the air flow is blocked. We have looked into clogs, changed filters, and the whole works, to no avail! Quite Frustrating since I love this purple vacuum! The machine started


There has to be a clog or block somewhere - if the motor works, it should work did you try a wire coat hanger to go up in further where you cannot see?Bets regardsCk ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

How do i open to emty - Dyson DC07 Bagless Upright Cyclonic Vacuum


Go to this site and it will allow you to save the user manual it downloads in PDF format.\015\012\015\012On page 6 I believe it shows how to empty and clean out.\015\012\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

How to open bagless vacuum


... Eureka 3276AZ Pet Lover Bagless Upright Vacuum

Bissell 35962 Cleanview Bagless Revolution Upright Vacuum hose is clogged with sock where hose meets handle attachment. Attempted to use broom handle to push back through suction opening. Sock is compacted. Any home repair advice?


If you have access to a small sink "snake" used to clear clogs in sinks, you might be able to use it to "snag" the sock and pull it out.\015\012Needs to be a metal sewer snake so that you can tug on it if and when it snags the sock. ... Bissell 35962 Cleanview Bagless Revolution UprightVacuum

I can not open my dyson canister to empty it - Dyson DC07 Bagless Upright Cyclonic Vacuum


If you take the bin off of the unit and try to pull the release trigger and it feel vry lose then you will find that the connector rod inside the cyclone has broken you will need to replace the cyclone unit as the rod comes complete with the cyclone ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Eureka the boss upright bagless vacuum. how do i open it to get to the belt area? the brush seems stuck. it wont move


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=801547\015\012Generic problem for all Vacuums\015\012Eureka the boss upright bagless\015\012 ... Vacuums

How do I open my dyson cylinder - Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum


Hi its Darran at Dyson.If you are referring to the cyclone top and bin assembly, once removed from the machine, there is a button at the base of the handle that has Dyson written on it that you press and pull the cyclone top and bin apart ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

Trying to replace belt on hoover convertible bagless upright u8188900. belt replace # 38528-049. i have opened vacuum and put belt back on, but it will not get tight enough around the motor gear and the brush spool to be able to activate. am i missing something? mike


... Hoover Vacuums

The belt seems to be broken and I can' find a way to open the Maxima bagless vacuum


Check for hood screws on the outer edge of the upper and bottom housing ... Eureka 4700A Maxima Bagless Upright Vacuum

Can't open it to empty - Dyson DC07 Bagless Upright Cyclonic Vacuum


Hi is this because you dont know how to do it or is it because you know how but its not working? ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I cant open it - Eureka 431A Optima Bagless Upright Vacuum


Before doing anything, make sure that the vacuum is unplugged from the outlet. After that, you are now ready to open your vacuum. Here are the steps to do so:a) First, remove the dust cap by pressing the "cup release" button on the top rear rig ... Eureka 431A Optima Bagless Upright Vacuum

How to open docking station - iRobot Roomba 4210 Bagless Robotic Vacuum


... iRobot Roomba 4210 Bagless Robotic Vacuum

How to open up the wand - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


Lift up the red circular slotted tab and pull up on the large red knob-looking hose end. when you pull it up it will extend and then you can pull the whole arm off to use it. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Can't open trash bin - Dyson DC07 Bagless Upright Cyclonic Vacuum


Call dyson customer care \012\0121-866-693-9766 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

When we turn on the vacuum, the canister falls open. The clips holding the canister in place do not seem to hold the canister tightly which I'm sure that it did in the past. The clips do not look bent, but every time we turn on the vacuum the intense pressure blows the canister open only remaining attached the the rest of the vacuum by one clip


Check filter and make sure it is kept clean at regular intervals. Possibly worn out clip retainers on cannister side due to excessive pressure build up. Do not force closure unless pressure is back to normal. May crack cannister or damage unit beyond ... Hayden Industries SuperVac 6000 Central System Vacuum

When I sart to run my bagless vacuum, it runs for a second and then shuts off. I replaced the belt and the filter. The repairman told me that on bagless vaccuums, the motor and bearings get clogged w


Take the brush roller off and on the ends are the bearing caps.try to take those off and clean the bearings ,carpet strands and hair will cause that.after you do that make sure the roller turns freely if not then the bearings might be bad and if that ... Vacuums

Hi, I have a Miele s247i vacuume cleaner- My electric coard does not roll back, How do I open the vacuume lid / housing to fix or replace the spring? do you have instruction manual on how to open the cover?


... Vacuums

Pelacing hoover bagless nano vacuum belt - Bissell 3576 CleanView II Bagless Upright Vacuum


... Bissell 3576 CleanView II Bagless Upright Vacuum

My Ergospace Vacuum took some apple juice in and now it makes strange noice and even threw out some sparks. Is there anything I can do my self or is it over with this vacuum cleaner? I opened 6 screws, but I still can't open the motor cover. Are there some hidden screws?


Liquid plus electrical parts always ends up with the electrical parts losing. Juices, although they will dry, will leave behind a sticky residue. You'll need to replace at least the motor, but due to the other electrical components, probably be bet ... Electrolux EL4100A Ergospace Cannister Vacuum

On my Air Vac model AV425A Central Vacuum System, I discovered the circuit breaker opened. When I close it, the vacuum motor goes on. It doesn't matter which position the on/off switch is on, it runs until I open the circuit breaker again.


... M&S Systems ZX7000 Bagged Central System Vacuum

Need technical help for my miele s2180 momentum canister vacuum .Bought a display open box at fure shop..Came with a filter bag..there are no tears in the bag...Perhaps they put the wrong bag..Anyway after 30 minutes of use..The motor stopped working ..so I opened up the unit only to see,.the dirt was everywhere inside the vacuum...only a little was in the bag itself..can you hepl..Dave


... Vacuums

Unbeknownst to me, someone took the bag out of my Kenmore Progressive vacuum and failed to replace it. I have been vacuuming without a bag for months, and today the vacuum stopped sucking. When I opened up the front to replace the bag, tons of dirt and dust came pouring out. I thoroughly cleaned the vacuum, put in a new bag, but still no sucking power. Just dust coming from the rear vents where one of the filters is. Is the vacuum ruined, or is it a simple solution of buying a new filter?


Sounds like you need to buy a new motor. All that grit and dust will ruin a motor and I'm surprised it lasted as long as it did.\015\012This is where a vacuum that won't run without a bag would have been nice. (Aerus for one) ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I have an Ecectrolux Epic canister vacuum. As soon as it starts sucking, the vacuum cuts off. I put a new filter and bag in, but it doesn't seem to help. If I open the front where the bag goes, take the bag out and depress the safety button the vacuum will run. Need some help or direction. Thank you


Try this.\015\012Disconnect hose. Turn machine on and place hand over intake. If it shuts off immediately, first try turning dial on top of machine so largest dot matches up with arrow. Turn on and place hand over intake again. If it still ... Electrolux Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0569 seconds