Having problems with your Eureka 437AZ Bagless Upright Vacuum ?

Main Vac No go

\015 The main vac motor will not operate. The sweeper motor is ok, I have found a gizmo attached to the black wire going to the moter to be open. I suspect this is a thermal trip of some sort. How can I get a new one?\015

Answers :

Hello jb1720.. Here is a link to the users manual... they do not identify the internal electrical components within your vacuum but they do provide contact information ( phone numbers etc). In all probability, you are correct in your assessment that you have an open thermal fuse ( probably non-resettable) in series with your electrical supply line. If you have a local appliance repair place near you, I would take the part with you and see if they have a replacement readily available ( which they probably will).. That may be the fastes way to get one.. Or.. you can use the contact info above to speak with a rep from Eureka.. Hope this helps you..
Repair Help & Product Troubleshooting for Eureka 437AZ Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Central vac our central vac will not work unless the main vac in the garage is switched on manualy.... its sucking fine but i have to switch it off at the main switch in the garage after i have used it normaly i just plug in the hose and vac away and it switches itself off we have just had cable installed with a fisher guy in the walls do you think that would be the problem thanks a lot


It is possible that the low voltage wiring that controls your central vacuum has been damaged during the cable work. You can check to see if the low voltage relay is working by shorting the two terminals together at the unit. Just disconnect the two ... M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

Shop Vac Can I **** water with a 4.5 12 gallon Shop Vac into the main cannister or is there another connection? DO you use the same one for both wet and dry??


You **** up water the same way as dirt. It's designed this way, hence the name wet/dry. Just be sure not to get the water in the very top of the unit where the motor sucks the air for cooling ventilation, if water gets in there it can burn up the mot ... Shop Vac 925-13 Canister Wet/Dry Vacuum

My vac's hose works but the main machine stops picking up dust and stuff after about a minute or so. Thn I have to take the hose of and clean the stuff from the main unit. My machine is 6 yrs. old


... Beam Industries 2775 Serenity Plus Central System Vacuum

I think I need to replace the main battery in my small floor vac - the one that can be hand held like a dust buster or work like a small floor vac. I need to know how to remove the battery and replace it with what kind of new battery..


I see my sense of humor is not appreciated...it was only a joke. Anyway, here is what you do: First, slide the battery cover off the bottom of the hand held unit. Remove the battery from the motor housing by pressing the tab on connector “A&rdq ... Vacuums

My electrolux central vac outlets work on the main


Here's a great article about locating a clog in your vacuum: http://voices.yahoo.com/troubleshooting-electrolux-central-va ... Electrolux Central Vacuum

Main Vac No go


Hello jb1720.. Here is a link to the users manual... they do not identify the internal electrical components within your vacuum but they do provide contact information ( phone numbers etc). In all probability, you are correct in your assessment that ... Eureka 437AZ Bagless Upright Vacuum

I own a Hoover Steam Vac V2 deep cleaner with Auto Rinse feature. The Model Number is not available ex: was on the bottom of the machine and the sticker is completely worn off the machine. I am having a problem with the bottle you fill with detergent ex: this bottle is seperate from the main clean water tank. THE PROBLEM: The little plastic part that goes in the bottom of the bottle has an "O" ring ex: cone shaped with a spring.....it keeps falling out. Can you supply a part number for this


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=641300\015\012Generic problem for all Vacuums\015\012I own a Hoover Steam\015\012Posted by w_brennan on ... Vacuums

Need help to replace main motor on my dyson d17 vac


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Nutone cv 353 central vac no power on main unit or when hose is installled in wall?


... Broan-NuTone CV353 Central Vacuum

Sears vac mod 11627514700 main mot. will not start replaced board fuse and switch


... Kenmore Vacuums

My central vac is in the basement, I am getting suction in the basement, but no suction on the main floor and the second floor. How do I know if somehting is blocking it or if there is a hole?


That means that you have a clog in the lines where the basement inlets are connected to. They can be tough to get out, you might need to call a professional. ... Electrolux Central Vacuum

Over heating? My 10 gallon 4HP shop vac has started shutting off after about 30 sec. after I turn it on to use. It smells real hot after I shut it off. I have changed the filter and the bag, which did not solve the problem. Any suggestions on what the problem could be? It's only about 31/2 years old and I really don't use it all that much, mainly for getting up dust and cob-webs from my garage.


It sounds like you need to replace the motor in it . thank you for using fixya ... Shop Vac ShopVac 3 HP 2 Stage 10 Gallon--Automotive Wet/Dry Vacuum Vacuum

Hoover steam vac won't suction water. It will with the hand tool, but not the main part. I feel hot air blowing out of the bottom.


... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

My main power breaker for the house, shuts off after I have used the Electrolux Centralux vac for a short period of time - why does this happen?


This is usually an indication that the motor is going bad. Motors in central vacuum systems are very easy to replace. Most motors can be purchased online. ... Electrolux Centralux Vacuum

My built-in Electrolux vac is about 10 years old and I want to clean and oil the main suction motor. At which points do I oil the motor and will 3-in-one oil work or is there a special lubricant. John


Do not oil the motor as it is not required, nor is there any place to put oil. the carbon brushes should be replaced though. carefully remove one brush and bring it to a vacuum repair facility. they should be able to match it up. there is a # on the ... Electrolux Vacuums

Aquavac runs for short time then cuts out blowing the RCD . Have rewired mains cable thinking a broken or loose wire... still same problem. Have also noticed that a lot of sparks etc coming from the motor brushes. Vac approx 10-15yrs old.Aquavac is model 6310B


... Vacuums

Is there a trick to removing the hose from the main tub so I can remove the filter bag on a wet/dry shop vac with detachable blower Model BLB550?


... Vacuums

Vax powa 4000 wet and dry - no suction Both power and pump switches light up. Pump makes clicking noise. Vac motor only powers up briefley when in switched on cindition and mains plug is being inserted into socket.


... Vacuums

Brushes do not spin on my steam vac


Take the brush block out and see if the brushes turn of, if not replace the brush block. Otherwise it is the turbine(#23) that has to be replaced, sometimes you can take the turbine apart and clean it. The top cover has to come off, turn it over, t ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Brushes do not spin on my steam vac


We were having the same problem with the brushes not spinning. How I fixed it:I Removed the brush assembly by gently pulling on both sides of the assembly. I took a wide slotted screwdriver and inserted it into the slot (hole) that tur ... Hoover F7222-900 SteamVac Upright Vacuum

My henry vac switch is dead.


You will need to remove the top cover of the vaccum by removing the 4 screws underneath.The you need to test with a multimeter if you have 240 volt power to the bottom of the switch. If you haven,t power there you will need to check the plug connecti ... Henry Numatic "" Canister Vacuum

Shop Vac 12 wet dry canister


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=19255&thid=245090\015\012Shop Vac 12 wet dry canister\015\012Posted by Fa Fa on Nov 05, 2007\015\012I'm not certa ... Shop Vac 584-06-00 Canister Wet/Dry Vacuum

Hoover u5781-900, motor shuts off (intermittent)when you shake vac or make jerky movements.If you move vac to up right position the vac starts right up.When you giggle vac, motor starts and stops no mater if you just started up or vac for ran for 45 min. Thanks Lucy C.


Lucy\015\012you have a bad connection somewhere in the unit\015\012this is a fire hazard and you should not use this until its been fixed\015\012could be a pinched wire or broken connections ... Vacuums

I have a 5.5 HP 8 gallon Stanley Shop Vac with the cartridge filter. The book says I can use the cartridge filter which is a kind of paper to use for wet vac. It did not come with the foam filter for wet vac so I am wondering if I use it for wet vac will the cartridge break up?


... Vacuums

How to attach hose to shop vac hang up mini - Shop Vac Shop-Vac& Mini Hang Up Wet/Dry Vac Vacuum


... Shop Vac Shop-Vac& Mini Hang Up Wet/Dry Vac Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0277 seconds