Having problems with your Eureka AirSpeed Bagless Zuum ?

Airspeed eureka vacuum gets hot and shuts down


Answers :

Repair Help & Product Troubleshooting for Eureka AirSpeed Bagless Zuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Airspeed eureka vacuum gets hot and shuts down


... Eureka AirSpeed Bagless Zuum

Eureka airspeed zuum. Vacuum shuts off after getting warm and will not turn on for hours


... Vacuums

The handle for my Eureka 5993 AVZ was getting very hot when used. Finally, the wires around the switch melted and now the vacuum will not work. What is wrong? Is the switch bad? The wires only melted in the immediate vicinity of the three-prong switch. Nothing else appears to be wrong; the vacuum worked fine when it was running - except for the handle getting hot. Thank you!


Try cleaning all...\015\012if have sam paoblem need replaced main motor.... ... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

My Eureka Airspeed vacuum keeps shutting off after about 5 min...It takes for about 3 days to vacuum because it will not turn back on for several hours...and it is not clogged. What is the problem


... Vacuums

While vacuuming it gets hot and shuts down


It's probably just overheating. You have to take the vacuum apart and clean it thoroughly. There is probably a "plug" of dirt/hair/gunk clogging a hose.I have had cheap vacuums that last years as long as I clean them regularly. ... Vacuums

Eureka 4870: when using hose, brush still spins, vacuum gets hot and smells like it's burning.


... Eureka Smartvac 4870 Bagged Upright Vacuum

I have a tristar vacuum that shuts down when it gets hot?


... Tristar TTV Turbo Tiger Handheld Vacuum

My riccar vacuum runs for about 2 minutes then shuts off and when it is on it does not pick up anything it gets very hot quickly


You have a clogg and there is a reset button in rear near left wheel. ... Riccar R100 Vacuum

Vacuum does not have as much power and is getting hot and shutting down after only ten minuets of use. does the filter need to be changed along with the bags to provide the best results, if so how often does the filter need to be changed?


... Miele s558 Silver Moon Vacuum

The handle for my Eureka 5893 AVZ was getting very hot. Finally, the wires around the switch melted and the vacuum will not work. What is wrong? Is the switch bad? Nothing else appears to be wrong.


Had exactly the same problem with my upright Eureka Model 5893\015\012bagless. It almost melted the handle! Ordered a switch after talking\015\012to several repair men. Talked to Eureka, too, and they were absolutely\015\012no help. Cheap wiring ... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

Vacuum shuts down aftwer a few minutes gets hot


... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

We have a Eureka built in vacuum system model cv800B. The unit is about 15 years old. It runs for about 5 minutes then shuts down. If you wait atleast 10 minutes you get another 5 of run time. Any help would be appreciated. Steven


... Vacuums

It gets hot then shuts off. - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


Most problems with over heating is coased by blockages in the pipes, the main one is behind the brushbar take the sole plate off and there's a suction pipe that is normoly the one that's blocked ,hope this helps you...... ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Not clogged, dirt emptied, but gets hot and shuts off


Hi Cyndi.\015\012\015\012Try this site for help has it service manuals, http://dysonmanuals.llc.nu/ ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Eureka 2981bvz bagless belt pully is getting too hot and burning through belt


Check the brush roll, if one end has overheated and is locked up so it won't turn, then you need to replace the brush roll. ... Eureka 2971AV EZ Kleen Bagless Upright Vacuum

I purchased a brand new Eureka Pet vacuum, sorry don't know exact name but it the one that has the self cleaning duster on it. Last night I used the vacuum on my carpet, it was working fine until I accidently sucked up the corner of a scarf that was hanging off a couch. I shut the vacuum off, pulled out the scarf and and resumed vacuuming. Much to my dismay the suction on the vacuum had ceased. Can you tell me if there is a reset button on the vacuum? The vacuum does not appear to be damage


If the motor is running, there should be suction. Possible problems depend on whether it's a canister or upright and are:\015\012A clog in the hose, UR or canister. Detach hose. Drop small coin in one end and lift hose causing it to roll out ... Eureka Vacuums

Owners manual for eureka airspeed 12 amp - Eureka 12 Amp Capture Vacuum Upright Vacuum


... Eureka 12 Amp Capture Vacuum Upright Vacuum

I have a central vacuum system. When I disconnect the hose from a wall outlet the central canister does not shut down dispite my turning off the vacuum at the handle of the hose. The only way I can get the system to shut down is to pull the plug at the canister. What gives? Rob


What I'm hearing is the canister(Not the Powerhead) portion of the unit is running all the time unless you unplug it. this problem could be caused by a short in one of your low voltage lines running through the house. To determine that just unplug on ... Vacuums

Shutting off my vacuum has been shutting off in middle of use and i dont know why its like its over heating and i cant use it again for almost an hour is there a solution to this? or do i need to get a new vacuum?


It has a built-in temperature sensor which prevents it to be damaged from overheating. That's why it shuts down. It just needs to be opened up and cleaned thoroughly. Start with the hose if it has one and let someone who is handy with electric applia ... Vacuums

Hot cord the cord on my vacuum cleaner has been getting very hot the heat is from one end to the other incuding the plug and also where the cord exits the back of the canister please help I love this vacuum cleaner it has been faithful to me for over 15 years!


Likely after all these years that the motor is starting to go bad and draw more amps thasn it should. a new motor at a vac dealer is your best bet. it was likely made by panasonic, so a new panasonic is your best bet, and less $$$than the kenmore for ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Miele Cat & Dog vacuum gets VERY hot and is VERY loud. Hose has no restrictions and I have changed the dust compartment (motor) filter and the exhaust filter. It still gets hot when I run it with the top open and all filters removed, so I'm guessing the problem is with the motor. Should I be going into the motor compartment? If so, what am I looking for?


Hi\015\012\015\012The fact that it gets very hot could be due to a number of issues.,but the fact that it started making a very loud noise at the same time suggests that there might be more problems maybe brushes etc.\015\012\ ... Miele S514 Solaris Bagged Canister Vacuum

I purchased a Eureka C4910 last year and have a question that I am hoping you can answer. There are two motor actions with this vacuum, 1) the vacuum suction, and 2) the beater bar. The action of the beater bar is that motor is supposed to automatically shut off when the handle is in the complete vertical position assuming the vacuum is stationary, but then turn on when the handle is tilted toward the floor, assuming the vacuum is moving back and forth. The beater bar motor turn-on mechan


Good day!Normally when the motor is easily moved back and forth means that it have a proper lubrication,proper alignment and no clogs.When the motor and the belt is OK the problem could be on electrical wiring and switch ... Eureka C4910 Bagged Upright Vacuum

How do i remove screen on eureka airspeed vacuum model as5200


... Eureka Vacuums

Eureka airspeed 12 amp vacuum no power


... Vacuums

I have a Eureka Maxima, this was a gift to me, but I have to say it is the worst vacuum I have ever used. Not only do I have a problem with the suction and the filter getting clogged, but it overheats - it takes me all day to vacuum my house, because the darn thing overheats after every room. Besides for tossing it off a cliff and buying a better vacuum, what can I do?


Get yourself a dyson ... Eureka Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0827 seconds