Having problems with your Eureka Altima Upright Vacuum Model 2996AVS Vacuum ?

Cleaning I cant take the cup out to empty it


Answers :

Don't bother emptying it. It just clogs, brush won't turn, won't even vacuum up a staple on low pile - office-type carpet. The filters clog, the cup clogs, and frankly, your time is worth more than the $50-75 to replace this vacuum.
Repair Help & Product Troubleshooting for Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cleaning I cant take the cup out to empty it


Don't bother emptying it. It just clogs, brush won't turn, won't even vacuum up a staple on low pile - office-type carpet. The filters clog, the cup clogs, and frankly, your time is worth more than the $50-75 to replace this vacuum. ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

I have had my Bissell 6591-X for 2 years. I hate it! No matter what I do all the fuzz, hair, whatever fills up around the upper filter before it even starts to deposit in the cup. It has done this ever since I bought it. No matter how much I take it apart, clean it, clean filters, empty the cup, nothing does any good. I spill more dirt onto the vacuum and floor than ever gets in the cup. I will never buy another Bissell.


Sure your not over filling it ? ... Bissell Vacuums

Our Bissell Cleanview II 3576M does a great job except that the filter cup below the dirt cup gets full very fast and the dirt cup barely has anything in it. To clean the whole house, I have to empty the dirt cup and clean the filter several times. It didn't use to work this way. It seems like something is missing, a gasket or seal maybe? I don't think dirt, hair and debris should be going straight to the lower cup and bypassing the upper. I looked at the user guide but can't see why it's happen


Contact Bissell Direct for a parts diagram and support at \015\012\015\012http://uk.bissell.com/EmailUs.aspx\015\012 ... Bissell 3576 CleanView II Bagless Upright Vacuum

Bissell 8920 proheat x2 brushes not turning i only noticed this after i finished cleaning.. or kinda cleaning because of the brushes ntot turning.. water comes out fine suction is fine but its not scrubbing so its not as clean as it could be. manual part works well water coming out hot. I did take it apart and cleaned off all the hairs in hopes maybe that was it.. put it together still nothing.. No idea how the belts should look onit and i cant find a picture or a video showing how belts look o


Hello,\015\012\015\012Here's a link to a very helpful video that shows you step by step on how to access and replace the belt on your machine. When the brushes stop spinning, but the rest of the machine works fine, this is a tell-tale ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Cant replace dust boxtook it out to empty as my cleaning girl always does and cant replace no matter how i try


May I get the make and model # so I may help you the right way. ... Kenmore Vacuums

I have a Bissel proheat 7901 carpet cleaner and it is not sucking the water up. Normally when I clean the water gets sucked back up and I have to empty the dirty tank. Now no water is in the tank when I am done cleaning. Please help I cannot afford to take it to the shop.


I'm not sure if this will help but I had the same problem and was about ready to pull my hair out. I ended up taking the fill tank off and if you look inside where the red overflow flap is you will find a small screened opening. I found that mine w ... Vacuums

I want to take the fan impellar off the motor to clean it. I cant seem to get the metal housing off of the motor. Do you have to take the nut off the impellar If so how do you stop the shaft from turning thank you.


Very simply you dont take the fan out of the motor. it was not made to be removed or cleaned because its not supposed o get dirty if your using good bags in the vacuum. the best you can do is blow it out with an air hose. ... Electrolux Epic 6500 Vacuum

Lost Suction This is my second hoover steamvac and i am having the same problem with my new one as i did with the old one that i tossed out. I have used it about 12 times and it worked great the first 6 times... Now i'll empty a full tank of water and only half will get sucked back up. I have tried taking it apart and cleaning and also the rubber seal had some gaps so i sealed those thinking that it was leaking air from there...can anyone help? I am so close to chucking this one and buying somet


Usually when there is no suction, one cause is the lid to the recovery tank is not on all of the way in the back. Also if you have that foam filter on the underneath side of the recovery tank lid, it needs to have a 1/4 in or so gap from the top of ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Tried to take roller brush out to clean it's housing, cant get one side back in without trying to force it.


The roller brush fits snug in the housing, however, if you had it out, check to make sure the end caps of the brush shaft are pushed all the way on. These just slide on the roller bar shaft and if something got under them, they would not be able to ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Just bought this a month and a half ago - used 3 to 4 times and it is making a loud humming noise like something is stuck. Filter is still good and cup is cleaned each time. Wanting to take it back to store and exchange it.


Is there any thing caught in the roller brush? Carpet string, plant leaf,Coin?\015\012\015\012Try removing the suction hose and putting a broomstick through it to unclog any thing you may not be able to see.\015\012\015\012At ... Vacuums

How do i clean the two little top parts above the bottom empty dirt cup


Hi there, inside the dirt chamber you should be able to twist and remove both of the silver what look like arrowheads and you should be able to get up inside the top with a water hose to clean out the upper area there. Allow for the unit ... Dirt Devil Reaction Twin Cyclone Upright Vacuum

My indesit is70cs is blowing out cold air instead of hot it is taking hours to dry the clothes. I have cleaned all filters and the water container does not need emptying ????


Could be element heater or thermostat/ likely thermostat......cut out ... Vacuums

The belt does not appear broken, but the beater bar is not turning, and there is little suction. The debris cup is empty and the filter is clean.


Clean both ends of roller .hair ect.get wrapped around down where the axle is ... Vacuums

My Reliable T730A Canister Steam Vacuum is not working. The red (empty) light stays on even though its full and it doesn't produce any steam. I doubt that the water is getting down into the heating chamber. How easy is it to take apart and clean or can I just blow compressed air through it? Any help most appreciated. Steve [email protected]


You can probably just blow it out with the air compressor. If you have a air pressure regulator on the air compressor then I would turn it down to about 30-40 psi. Then try to blow out the line. ... Reliable T730A Canister Steam Vacuum

IRobot Roomba 560 Thumping, Says Clean Brushes, No Dirt in Cup


... iRobot Roomba 560 Robotic Vacuum

Cant get self cleaning duster out


... Eureka Capture Upright Vacuum Vacuum

I've cleaned a few areas and now the blue nozzle part with the dirt needs to be emptied. I do not have an instruction manual and can't figure out how to open or detach the blue nozzle part to empty it & clean it out.


Release the handle under by the front wheels. It will then pull out. Once you pull it out,on the frame there is a diagram showing out it comes apart. ... Sharper Image SI570 Steam Wizard Handheld Wet/Dry Vacuum

I have adyson dc04 the cylinder is stuck cant get off to clean it out


... Dyson DC04 HEPA Bagless Upright Cyclonic Vacuum

I have a Bissell Steam Cleaner that is not sucking up the water when cleaning. I used a full container of water and when it was empty I emptied out the water, only to find very little dirty water in it. I noticed the window, as i used it, seemed like it wasnt sucking up the water. I took the plastic cover off to clean it (it didnt look very dirty in the first place), an i noticed that the grey plastic flap was on but not moving up or down. I thought there may be dirt in it that prevented it from


... Bissell Vacuums

Sweeper belt Hey , i own a fantom thunder sweeper and recently my belt keeps slipping off, i've disassembled it and put it back on a hundred times but it keeps doing it after a few minutes of cleaning , Am i missing a part to hold it on or somthing else wrong i've cleaned it and checked all the ports just cant figure it out and cant find any info online thanks for your time tina


Greetings from GoVacuum.com,Have you replaced the belt with a new one yet? You may want to try replacing the belt, as with flat belts like the Fantom Thunder, they do stretch out 4 -5 inches after time. We in fact recommended replacing ... Fantom Vacums XT450K Upright Vacuum

We used our Hoover SteamVac F6207-900 for the first time today and it did not suction at all. Please help. It emptied all of the clean water/detergent as I cleaned the carpet, but no dirty water came up into the empty tank. Thanks!


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=639624\015\012Generic problem for all Vacuums\015\012We used our Hoover SteamVac\015\012Posted by medgl ... Vacuums

Keurig b200 problem; When brewing with cup in unit water will pass into cup and it seems when k cup is full the grinds puch up through the top and water overflows. i pulled out the k cup holder and cleaned so their is nothing that is obstructed included the piercing pin. brewed [product does come through but does not seem to allow it to come through fast enough or if it supposed to be pressurized it is losing its seal on the top of the k cup


... Vacuums

Need user manual for Farberware Milennium FSU236. How much coffee for 12 cups, 24 cups and 36 cups of coffee? How long will it take to brew 36 cups?


HelloOK, i am still looking for the specific manual for you model, but, at the link below you will be able to have a loo at a similar unit in capacity. Click ... Vacuums

Cannot remove dirt cup for emptying


It has a release button some where , you need to find it...(my wife had same issue...i left her to find it :)..\015\012\015\012hope it helps...keep the hope :) ... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

Hi, There is a high pitched whirring sound coming from lower part of the vacuum. When I tilt it toward me (while standing in the normal vacuuming stance) the sound sometimes lessens for a minute or so. I have tried the following things: -cleaned the two sponge filters -emptied the dirt receptacle -removed the roller and cleaned it -cleaned the brushes -the belt is not ragged and does not seem floppy -checked all of the airways for clogs (including removing the wheel base) Can you help?


Your looking for some dirt stuck in some thing you didn't check yet. with the roller out and the belt out of the way run it to see if it still makes the noise. if it does then you looking at the impeller or the motor bearing themselfs those bearin ... Bissell 3750 Lift Off Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0769 seconds