Having problems with your Eureka Altima Upright Vacuum Model 2996AVS Vacuum ?

Spinning debris in cup

\015 My debris is not spinning in the cup and there is no suction, and the hoses are getting clogged\015

Answers :

If the 2 stage filters inside the bin chamber have not been washed then they will need to be - they sound like they are clogged or somewhere there is dirt which is blocking up the system. Also check the side part duster to ensure that the airways are not clogged with dirt.

When you turn the machine on, have a look to see if the moving brush is actually spinning. Then switch off and remove the base plate to see if anything is clogged in the main dirt channel which is usually located on the left or right hand side - where the dirt goes in from the floor.

This model is based on an Electrolux model in the UK which can be notorious for clogging dust. Check the hoses at the bottom where they come from the main dust bin and the air ways to check no dust is stuck.
Repair Help & Product Troubleshooting for Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Spinning debris in cup

If the 2 stage filters inside the bin chamber have not been washed then they will need to be - they sound like they are clogged or somewhere there is dirt which is blocking up the system. Also check the side part duster to ensure that the airways are ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Our Bissell Cleanview II 3576M does a great job except that the filter cup below the dirt cup gets full very fast and the dirt cup barely has anything in it. To clean the whole house, I have to empty the dirt cup and clean the filter several times. It didn't use to work this way. It seems like something is missing, a gasket or seal maybe? I don't think dirt, hair and debris should be going straight to the lower cup and bypassing the upper. I looked at the user guide but can't see why it's happen

Contact Bissell Direct for a parts diagram and support at \015\012\015\012http://uk.bissell.com/EmailUs.aspx\015\012 ... Bissell 3576 CleanView II Bagless Upright Vacuum

My Rainbow SE vacuum was working fine until I ran over the edge of a rug and it went in to the nozzle. I immediately switched the vacuum off and proceeded to move the rug. When I tried to turn the Rainbow back on the brush was no longer spinning. I've tried the reset button and checking the nozzle for any debris, there are none. The brush just won't spin.

Hello lilbutmunch1,\015\012The brush is motor/belt driven so you probably either broke the belt or it shifted off the motor or brush shaft. I suggest you unplug it,flip it over and look for screws that hold the baseplate together.. remove those ... Rainbow E series Canister Wet/Dry Vacuum

Air flow indicator stays activated after filter has been cleaned. Brush spins, but very little suction. Dirt doesn't spin in cup.

Your vacuum is clogged. Check all of the air pathways, hoses, etc. The most common places to check are anywhere there's a joint in the airways, and also directly behind the brushroll. \015\012\015\012-R ... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

Miele White Star SEB 204, powerhead stopped spinning. brushes are clear of debris, belt (#3854940) is not broken. Could belt be stretched so that brush head does not spin?

Yes, most likely the belt has stretch. Flat belts do this after a short time and need to be replaced when problems start with the brush roll not wanting to turn. Also check the brush roll, make sure that the ends turn freely, if not, then replace i ... Miele Vacuums

Hoover Elite Deluxe rewind... Air flow indicator stays activated, after filter has been cleaned. Brushes spin, but very little suction. Dirt is not spinning in cup

... Hoover Vacuums

I have a bissell powerforce bagless turbo. The problem is the brush bar is not spinning. I have cleaned out all the debris on the brush itself, and taken it apart to make sure nothing is blocking the

Sorry to hear you're having difficulty with your vacuum. You may want to have a Qualified Technician at a BISSELL Authorized Service Center inspect your vacuum. Here's a quick link to locating a Service Center. ... Bissell Vacuums

Have a Hoover Steamvac F7410-900, the brushes don't spin anymore. Can hear the motor running. There is no visible debris and the lint screen is clean. Please HELP! I miss my steam cleaner. Thanx!

Check to see if you can turn the brushes by hand, if not your bearings need service in your turbine assembly.Check aslo for proper suction at the instake standpipe under the lower tank. If it is the turbine, take it to a repair shop. ... Vacuums

The belt does not appear broken, but the beater bar is not turning, and there is little suction. The debris cup is empty and the filter is clean.

Clean both ends of roller .hair ect.get wrapped around down where the axle is ... Vacuums

When switching the vacuum (DC17 Animal) over to the hard surface setting (so the beater brush is not spinning), the vacuum shuts off. I cleaned the dust bin and checked the filter. I also cleared the beater brush of hair or debris that was wrapped around it. It still shuts off. Ideas? Thanks.

The drive belt has probably broken. You can get a replacement belt here:Dyson DC17 Belt ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I got some dust or debris possibly sucked into moter from a broken bag. Now moter spins and whines at a loud pitch. What would be the best approach to take if it can be fixed by myself? Is there a downloadable schematic avialable for free on the web?

... Lindhaus HF6 Bagged Canister Vacuum

Help hi there. i have a hoover savvy u8172-900 vaccum. the hose has great suction, but there is limited suction on the main unit and the brush does not spin when i try to use the product. we have cleared the brush of any debris and have also installed a new bag. a few days ago, we disconnected the hose to make sure there was not any foreign bodies stuck in the unit...nothing seems to help. any advise?

As the hose fits into the base (if i am correct) the power at the base should be fine, make sure the base is clean and free from blockage,\015\012you say the brush doesn't spin, has the belt broken, if so replace it, (very cheap) and only a couple of ... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

My Eureka Endeavor power paw is not working, there is no debris in it and the belt is secured. Why isnt it working

... Vacuums

Cleaned the brush bar but still not spinning DC14 Dyson

The belt is broke. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Dyson dc07 slow spinning brush

... Dyson DC07 Bagless Upright Cyclonic Vacuum

Roomba 565 side brush motor does not spin.

... Vacuums

The roller brush on my Dyson DC 14 Animal won't spin.

... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Debris in front of foam filter

When that happened to me it was because the cup got full or was loose. I am now seeing the cup seal, located on the body above the cup, is not sealing and my filter is loaded. That might be a clue. ... Eureka 5892AVZ Bagless Upright Cyclonic Vacuum

Brush is not spinning, vacuum is not sucking.

... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

My vacuum is picking up very little. No debris is

I have the exact same problem. The beater seems to turn just fine and the dirt is getting picked up, on it just sits in the hose. I don't think it's the best because it seems find, but who knows? Please help. ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

IRobot Roomba 560 Thumping, Says Clean Brushes, No Dirt in Cup

... iRobot Roomba 560 Robotic Vacuum

Keurig b200 problem; When brewing with cup in unit water will pass into cup and it seems when k cup is full the grinds puch up through the top and water overflows. i pulled out the k cup holder and cleaned so their is nothing that is obstructed included the piercing pin. brewed [product does come through but does not seem to allow it to come through fast enough or if it supposed to be pressurized it is losing its seal on the top of the k cup

... Vacuums

Shark Euro-pro EP621 Bagless Upright Vacuum. Q regarding the brush not spinning / after troubleshooting and taking actions listed below, it now spinning for a few secs, but then stopping. Already removed hair, strings, etc. Checked that belt is aligned properly, checked that small wheel that turns belt is working (spins fine when belt removed. Oiled the turning parts a bit, that made it spin better, but still stops. It turns about 3-4 seconds then stops. If I switch it off and on again, I get ag

... Euro-Pro EP621 Bagless Upright Vacuum

I have a Eureka 5902AVZ and the brushroll does not work. when i remove the belt, which is not torn nor worn out, the motor spins perfectly fine. Though when i put the brushroll back into place, it shows that the motor is trying to spin, but with resistance. it seems the brushroll will not spin if locked into place, because there is no attachment on the left side of the brushroll that will allow it to spin freely with the belt. am I missing some parts or is there something else wrong?

Hi and welcome to Fixya. I am Kelly. \015\012\015\012You have correctly identified the problem as the brush roll itself. \015\012\015\012There is a bearing under each end cap of the brush roll. You can gain access to the ... Eureka 5902AVZ Bagless Upright Vacuum

Need user manual for Farberware Milennium FSU236. How much coffee for 12 cups, 24 cups and 36 cups of coffee? How long will it take to brew 36 cups?

HelloOK, i am still looking for the specific manual for you model, but, at the link below you will be able to have a loo at a similar unit in capacity. Click ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0368 seconds