Having problems with your Eureka Atlantis 2595A Upright Wet/Dry Vacuum ?

EEureka Atlantis 2595A Upright Wet/Dry

\015 When I put the water in the canister and put it on the cleaner the water leaks out on the floor.\015

Answers :

I have an Eureka Atlantis Deep Steam Extractor and it does the same thing. It's not new but it hasn't been used much. The only thing the booksays\015\012is to put the tank in until it snaps into place. (Like we didn'ttry\015\012that.) Apparently it's a bad design. The seal on mine looks fine.
\015\012
\015\012If I was doing the floor I'd just keep going but I'm trying to do my couches and I don't need a huge puddle on the floor.
1st possible solution,use clr to clean out lines,2nd check and see if the valve is not connecting as it used to,3rd see if valve on machine is not stable
Repair Help & Product Troubleshooting for Eureka Atlantis 2595A Upright Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

EEureka Atlantis 2595A Upright Wet/Dry


I have an Eureka Atlantis Deep Steam Extractor and it does the same thing. It's not new but it hasn't been used much. The only thing the booksays\015\012is to put the tank in until it snaps into place. (Like we didn'ttry\01 ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

Eureka steam extractor brushes not working - Eureka Atlantis 2595A Upright Wet/Dry Vacuum


... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

Shampoo leaks from a despenser - Eureka Atlantis 2595A Upright Wet/Dry Vacuum


... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

The spray does not work - Eureka Atlantis 2595A Upright Wet/Dry Vacuum


... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

Oreck lx power scrubber won't spreay - Oreck XL M900A Upright WetDry Vacuum


... Oreck XL M900A Upright WetDry Vacuum

How do you empty the vacum - Wagan Cordless WetDry Vacuum Cleaner Upright Vacuum


There is a button at the back of the snout, on top. Press there and bend the snout forward. \015\012\015\012--W/D-- ... Wagan Cordless WetDry Vacuum Cleaner Upright Vacuum

Eureka Atlantis 2591A Upright Steam Vacuum


If it drips out while the tank is off the machine it couldbe the spring load mechanism in the cap. try soaking it in hot water for a few minutes to swell the rubber then with a pen push the spring plate up and down to lubricate the rubber. then try ... Eureka Atlantis 2591A Upright Steam Vacuum

Need user's manual - Eureka Atlantis 2591A Upright Steam Vacuum


GO TO THIS LINK TO DOWNLOAD MANUALhttp://www.eureka.com/en-US/Customer-Service/Guides-and-Manuals/ ... Eureka Atlantis 2591A Upright Steam Vacuum

Leaking under tank - Oreck XL M900A Upright WetDry Vacuum


... Oreck XL M900A Upright WetDry Vacuum

No suction or spray - Eureka Atlantis Steam Cleaner


I got the machine working. I think because it hadn't been used for awhile that the seals were dried out. I wet them and let it sit for awhile and then I could push the containers all the way in and seated them properly. Then it started working no ... Eureka Atlantis 2591A Upright Steam Vacuum

Vacuum won't **** in upright position, but there is suction from the hose in the upright position


Theres a knob that switches it from floors to carpet turn the to floors.please leave feedback ... Vacuums

Dyson DC25 upright not standing upright


Hi its Darran at Dyson. So that we can help resolve, please contact our Helpline on 0800 298 0298 (UK) or 1866MYDYSON (US). It sounds as though your stabiliser has come out of place and one of our advisors should be able to help you pop ... Dyson DC25 Vacuum

My Dyson upright suddenly won't stay in the upright position. It appears that a little rubber piece has fallen out of position.


- Stand behind the vacuum cleaner and look at the right-hand side wheel\015\012- Remove the AI PIPE (it has two purple buttons that you push together to lift it up and out - it looks like a Tuba)\015\012- Lay the handle down and look for ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Kirby G4 Bagged Upright Vacuum When in upright position it automatically switches off.


Make sure that everything is latched and closed, also make sure it is even on the floor (also "lock" anything that needs to be-i had the same prob, so many things to check!) ... Kirby G4 Bagged Upright Vacuum

Oreck Upright Hi Redev, I'm not sure what model I have (about 6 years old...upright, looks like the one in the picture). I changed the belt (which was torn) and then the next time I used it, it cut off on me. Now if won't turn on at all. (I turn the switch on and off and nothing happens as if it is not plugged in but it is!). I noticed at the top where the power cord enters the handle, it is all frayed. Could the electrical wires have detached? Anything you think I should check before taking it


The cord could be bad and will ahve to be replaced. It would have to have a problem inside the handle or down by the motor. ... Oreck XL2600 Vacuum

When using my vacum upright its very low in suction, it used to be so powerfull that it lifted my carpet slightly....when using the tools section its as strong as it should be please help, ive cleaned it out but still loss of suction in upright position, from mrs richmond


Check the following items:\015\012\015\012* The bag and connection - change it if it's full\015\012\015\012* Turn the vacuum over and inspect the beater bar area for any clogging. You may have to remove the bottom plate to ... Vacuums

My steam VAC upright wont **** up water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The most common and simple problem with these involves the recovery tank. Take it off, remove the cover and check to be sure it fits snugly. All tabs must be locked front AND back. If this machine has tools you have to hook up in order to use you ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover Z 400 collapsible vacuum won't lock in the upright position. I pull the pin to change from a cannister to an upright, but the unit won't lock into position


This just happened to me. i took the vacuum completely apart and found that there is a locking plastic "tooth". this had snapped off but still it the track. the damage was bad but i was able to wash of all the lube off it and used a 2 part epoxy glue ... Hoover F5858-910 SteamVac Vacuum

Too much play in upright part of my Hoover upright wind tunnel


No. The handle release pedal is snapped into the bottom base assembly. Look underneath to check for cracks or damage in this area. this is the most likely issue. If it is, then the base will need to be repalced. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Oreck upright hard to push - Oreck XL2000 Bagged Upright Vacuum


If hard to push, only a few things to check:\015\012\015\012(1) Rear wheels will get hair or thread wrapped around axles, dust, etc. and be hard to turn. Make sure each wheel turns easily.\015\012\015\012(2) Small wheels on ne ... Oreck XL2000 Bagged Upright Vacuum

Loss of suction when using upright. Suction remains for samll tools no suction when in upright position makes funny noise but ok when not used in that position kindest regards louis


U can remove the flexi pipe by pressing the inset button,it may be bit stiff if it had not being removed before.may be something is stuck at the bottom,also remove u bend where most of the stuff get stuck. i just posted how i fixed the suction and ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

After using my attachments I have a hard time getting suction when using upright again - how do I get the suction on my upright? It's a Hoover blue widepath Tempo~ thank you


It may be clogged underneath the vacuum where the roller is. Take the bottom plate off and look into the intake port. There may be some blocking the port. ... Hoover Tempo Widepath Upright Vacuum - Blue

I Have a hoover purepower 1800w upright vacuum cleaner that works perfectly except for it wont stand upright anymore. Any advice


Not sure what model of Hoover you have, you may need a new handle release. ... Vacuums

HOW DO I CHANGE THE MOTOR ON A DYSON UPRIGHT - Dyson DC07 Bagless Upright Cyclonic Vacuum


Go to www.dysonmedic.com then scroll to the bottom of the page and click on DC07 motor replacement. You will find very detailed illustrated guidance. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My bissell proheat upright steam cleaner is spraying out through the attachments just fine, but will not spray to the floor when using upright. we've taken it apart to find that there is no water at all going through one of the hoses, but it appears the hose is connected behind the on/off and heat switches, we can't seem to figure out how to get in there to replace that hose....any suggestions on how to access this?? just curious how you would get in to replace the hose, we know it is the hose..


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0418 seconds