Having problems with your Eureka Boss? SmartVac 4870MZ Bagged Upright Vacuum ?

Vacum runs well but the

\015 Vacum runs great but the roller brush don't turn even after replacing the motor.\015

Answers :

Repair Help & Product Troubleshooting for Eureka Boss? SmartVac 4870MZ Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My honda gx390 pressure washer is not starting. It is backfireing through the carb. Will run if I pull enough sputters them might kick in and run then will die. I have cleaned the carb & float bowl and changed the oit so it is up to leavel and seem to have spark but could be better spark. It was running (allthough not well ran out of gas and then I filled it up and this is what I have. Thanks for any help.

... Vacuums

Cleaned and running well, taken downstairs, put to work my 530 has developed a distinct knock. about 1/2 second speed as going along. does not happen if brushes removed. machine runs for a few mins th

Click the link below :----http://wikisolutions.blogspot.in/2012/02/get-free-answers.html ... iRobot Roomba 530 Robotic Vacuum

I bought a Eurika upright vacum (the boss whirlwind lite) it is pretty new, keeps shutting off before i am done vacuming, and the hose doesnt **** very well!!!

Your model mite have a divice that turns the motor off if it heats up if so take it to a repair shop and have them look at it ... Vacuums

When i start the vacum the brushes trun for about 3-5 seconds then stops. the vacum still runs,its just the brushes stop turning, what should i do?

If your machine has no power or interrupted power, please check the following:\012 \012- Make sure the power cord is plugged into a functioning outlet to check for power.- The handle may not be installed properly, causing a ... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

I have a 5.5 hp craftsman 20 litre wet Dry vacum . I have lost the manual. & have 2 questions 1) how do I change to wet vacum from dry? Also could i use the wet mode with some water in it and let it run while I am sanding dry wall to catch the dust in the water in the container? Thanks

# 1 myou just take the bag out make sure ytou sponge filter is in place athe top and turn it on the power switch just turns on ,machine ther is no wet dry switch just an empty bagless cannister is all you need make sure the ball outlet in vacumn is w ... Vacuums

The vacum will run until the hose is inserted and then the motor shuts off. The vacum switch must be hooked up incorrectly. Do you have a schematic?

Before trying to take it apart, check the hose for a blockage. Disconnect the hose at both ends, drop a coin in one end, lift that end of hose allowing coin to drop through. If it doesn't come through, there's a clog. You should be able to clear i ... Electrolux C101 Bagged Canister Vacuum

My wife and I own 6 IRobots: 1 Scuba 1 Dirt Dog 4 House cleaning vacume models All of them are not working, so I decided to try and solve the problems with two of them: One is a dirt dog and the other a house cleaning vacume Rumba. Given: Battery is fully charged Reaction: I start both of them. They run for about 2 to 3 seconds They come to an abrupt stop as if there is a rock in the gears. Help

Both of them have identical issues? Can you please provide the actual part number of them? It should be on the bottom or inside the battery area somewhere.ThanksTim ... iRobot 1100 Dirt Dog Bagless Robotic Vacuum

I have the same problem as steve967 The dyson dc16 is fully charged, runs well for 5-10 seconds and shuts down. I wait for a second or 2 and it runs again for 5-10 seconds. This will continue for numerous cycles, until I am finished cleaning. I have cleaned all the filters, and the power is good, The system will just not stay on. It is just over 2 years old. A friend of mine had the same problem with his Dyson DC16 after just a couple of months and has replaced his Dyson with a Black N De

Dear Michael_Stad,I am going to sound like a broken record but here is my same answer to another person with the same problem.I have I had the same problem with my Dyson DC16, where it only runs for a few\015\012seconds at a t ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

I have a Electrolux , EL6988 Canister Vacum, howeveer the brushes and motor will not run when turned on. I have take the plates and cleaned around the brushes, but it will not come one. The vacum comes on but the motorized bushes do not activate. Thanks I have lost my owners manual, and have looked for the reset button and can't find or know where it is located. Any suggestions.

I need the molded wire harness inside the plastic wand ( one of the prongs is broke off) What is the part # or where can I buy it? Model EL6988 ... Electrolux UltraLux 2000 Bagged Canister Vacuum

My Bissell BS3920F upright (similar to the 10N6F) has been working wonderfully for the past 3 years but suddenly seems to not pick up dog hair as well as it used to. It has been pulled apart by my husband to ensure nothing is blocking the hoses etc and when running the suction seems to be there. It seems to grab the dog hair and leave it in a straight line directly under the unit without picking it up. I then disconnect the hose and use to hose to pick up the dog hair. This works well but obviou

Check to see if your brush is not worn down, they do wear with age - compare the length of the bristles with a new one. Replace the brush ir there is a significant difference in bristle lengths. Also check the flexible ben ... Bissell Vacuums

Hi. I have a Kirby from back in the early 90s (model G3D). Never had major issues with it. Can't remember the last time I had maintenance/tune up done. It's just sounding different when I run it the last few times...almost like it's louder and kind of echo-ey. Still suctioning well, but something's not right and I don't want to run it until I know if anything's up. Any suggestions? I'd like to try and figure this one out on my own with your help. Thanks in advance for your help. Marci

Check the belt. this is a strong vaccume and even without the belt it will still have a decent amount of suction. If the belt is not tight or intact it can let the motor turn faster which will sound louder. other than that check all the hoses for hol ... Kirby Ultimate G Bagged Upright Vacuum

I have a power drive baggless vacuum cleaner...it runs well, but suddenly it seems to have lost most of the suction coming through the hose and floor area. When I remove the dirt container, the suction below it seems strong. I have had it to repair twice--they have tuned it up and replaced all filters and belt. It still does not pick up well when I vacuum or use the hose. Can you help ?

There is something stopping it up,you will have to dissasemble the unit to find the blockage,this is the most likely problem. ... Hoover U6660-900 WindTunnel Bagless Upright Vacuum

I was vacuming and it stopped running. will not

Either you have a break inside the power cord or the wires have come loose on the motor. ... Eureka 4700A Maxima Bagless Upright Vacuum

It stopped running while vacuming and would not start again

The most likely problem is the cord end is broken, it is cheap to replace if you do it yourself. if it is a plorized plug ( one blade is bigger than the other ) pay close attention what side the wires go to and match them on the new one. ... Vacuums

My dyson animal is hard to push on carpet - the beater bar is still operational. When I turn off the beater bar and run the vacuum on hardwood the beater bar stops moving, but it still ''rolls'' on the hardwood - it doesn't pull up like it used to. It also seems to not be picking up as well as it used to, although no blockages are present and the filter is clean.

... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I bout this vacume in mid December 07 and about February-March it started not picking up the dust on the floor. So in early April I bout a new filter and it still wasn't picking up the way it had in the beginning. I've taken it a part several times and cleaned it out with it being plugged at the bottom hose with dust bunnies. Well I just took it back to Walmart where I purchased it and I failed to keep the reciet they could not do any thing about the sweeper. I went back to the sweepers and re

Pull the hose out of the holder, is there suction there. If not, then there is a clog in the hose. If there is suction, then check the dirt outlet by the brush roll. Also if the belt is slipping, it may appear to not have as much suction, belts wi ... Dirt Devil Vacuums

After lending to my sister for some drywall sanding. She was removing popcorn from a popcorn ceiling, the vacum now runs much louder and as though it is clogged.

Try changing the filter. ... Fein 9-55-13 Turbo II Bagged Canister Vacuum

Vacume is a mach 4 cyclonic, it runs for about 8 minutes and then it shuts itself off? any idea?

The only thing I can think of from your additional comments is when it warms up something expands and it loses continuity of the circuit. Most likely the switch or the breaker. Another thing to check is if it has a hepa filter it may be clogged ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Thermal senser on the side of the vacuum motor there is a little thermal senser that has rust all inside of it ,my ? is will that cause the motor to shut down ,could the rust in the senser causing it to cut off ,cause the vacuum runs well then cuts off

If it is going bad, it will cause the motor to shut down, replace it then you will know if that is the problem or a problem with the motor itself. ... Vacuums

My Hoover U6430-900: the motor seems to be running fine, the brushes turn fairly well, no blockages but no air is moving through it at all? Is it likely the fan and is this something I can replace myself?

Keep looking it must plugged somewhere ... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

I can't get the vacume to run for more than 15 minutes before it shuts down presumably do to overload. But I don't get the warning light and I clean it out regularly. I have to let it sit for hours until it resets and I can finish the job

Sounds like you have a blockage. Check your attachment hose by dropping something through it, if it is all clear, then check your duct hose, this is the hose at the base of the cleaner. Many times this will clog and you might have suctionat your ho ... Vacuums

Unit is 3 years old and isn't picking up like it used to. Have to vacume over the same spot several time to get everything up and then it doesn't do it well.

OK. I'm not familiar with this particular vacuum, but I think you've said enough for me to give you some clues. Suction is one thing - air flow is another. If you've got good suction against your hand, then the problem is low air flow, and that's alm ... Kenmore 25614 / 25615 Progressive Bagged Canister Vacuum

Kenmore progressive bagless no suction however brush runs well .

Remove all the filters and clean themon the bottom you have what is called an intake hose.you will see it as it comes up from the bottom and up on the backside.it connects to a fitting take the screw out and pull the hose away from the back.take a co ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

My Roomba Discovery will not do our carpet. It is a medium pile tan carpet so it should be OK but it runs for a little while then shuts down and beeps. It does not try to restart.It works well on floors. I have recently done a full tear down and cleaned the drives and brush transmission.

... Roomba Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0349 seconds