Having problems with your Eureka Capture Upright Vacuum Vacuum ?

We have the Eureka Capture and it seems the vacumm got hot and stopped, now it won't run. Is there a reset button?


Answers :

If you go to this URL:\015\012
\015\012http://www.ereplacementparts.com/eureka-8853avz-upright-vacuum-parts-c-108750_108773_109342.html\015\012
\015\012you will see that item #25 is listed as a circuit protector. You can locate it on the exploded view drawing as to where it is on the unit.\015\012This is what you want to find and see if you can reset it.\015\012
\015\012If you find my solution to be helpful, I would appreciate a Thumbs Up.\015\012
\015\012Paul
Repair Help & Product Troubleshooting for Eureka Capture Upright Vacuum Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We have the Eureka Capture and it seems the vacumm got hot and stopped, now it won't run. Is there a reset button?


If you go to this URL:\015\012\015\012http://www.ereplacementparts.com/eureka-8853avz-upright-vacuum-parts-c-108750_108773_109342.html\015\012\015\012you will see that item #25 is listed as a circuit protector. You can locate it on the e ... Eureka Capture Upright Vacuum Vacuum

Is there an reset button on the craftsman 16 gal it was running and stopped. i had some crud in the air filter and removed that but it still wont run thanks Dave


Do you put the foam filter over the paper filter ... Craftsman 17765 Canister Wet/Dry Vacuum

I have a DC14. About a wk ago it was making loud sound and bar stopped turning. i unclogged everything....now the suction works great. However, the bar still wont turn. The belt inside is still intact and isnt loose. Several solutions suggested resetting the "Red" button...i have searched the vacuum over and over. there is NO red or any other color reset button. The bar is set down perfectly in there, the cover plate is installed properly. What other problems could there be? Or do i just need to


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Eureka capture model 8803 type AVV...runs for 10 minutes then stops. will not re-start for a long time.


This could be a few issues. First it could be the thremel swith located inside, or it could be the carbon brushes also located inside. If you are a do it yourselfer you can purchess the carbon brushes from any vacuum repair shop. The thermal switch s ... Eureka 12 Amp Capture Vacuum Upright Vacuum

The motor in the power head ran at a higher pitch for a for 8 to 10 seconds then stopped. If I push the reset button the powerhead may or may not start or it may start and run for a few seconds. The brush is not caught.


Did you check the belt? A broken belt results in lower strain on the motor, causing it to run faster resulting in the faster speed and higher pitch. This could result in overheating, which will cause the motor to shut off.\015\012If this isn' ... Electrolux C101 Bagged Canister Vacuum

We have a EZT vacuum model 6508C. It started running hot yesterday. Today it will not turn on at all. Is there a reset button?


... Vacuums

I have a Eureka Whirlwind lite ''The Boss'' and it stopped in mid-vacuum. Does it have a reset button?


... Vacuums

Just stopped running. Is there a reset button


I think there is one at the very bottom...try that little black colored one at the the side facing you, when operating, near the very bottom of the unit..I lost my manual too, so that would be a guess since it looks like a reset button. ... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

My cleaner ( Oreck 40th Anniversary, XL2 Ultra) several years old, and I love it. My questin, is there a reset button? Vacuum just quit....no noise, sputtering, smell, nothing, just stopped while running cleaner. New bag, new belt. Any ideas?


... Oreck Vacuums

The Eureka Capture was running when all of a sudden it stopped. Does it have a fuse?


... Eureka Capture Upright Vacuum Vacuum

My dyson dc44 just stopped running in the middle of vacuuming, I checked the battery, cleaned the head, I emptied the bin. Is there a reset button anywhere for this machine?


... Dyson DC44 Animal Cordless Vacuum

Kenmore 116.23513301 Motor runs, but the brush will not rotate. Every time I hit the overload reset button, it will rotate for about a second then stop. I replaced the belt and cleaned around the brush, but the brush still will not rotate. Any help you can give me would be greatly appreciated.


If the motor on the power brush is running the belt is bad, if the motor on the power brush only runs when you push the overload, the overload is bad. ... Kenmore 22812 Bagged Canister Vacuum

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T


... Rainbow E series Canister Wet/Dry Vacuum

New battery!, roomba runs for 5 - 10 seconds, stops, starts running, stops, runs, stops, then beeps and low battery flashes. Have taken battery out, held start button 20 seconds, replaced battery and directly connect to charger, 72 hours min., still same problem.


... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Reset button for Eureka 431 bagless upright???Where is it?!


If the red light is one the says "check brushroll" then you have to take it apart to find out what the problem is. It might be that the roll has too much stuff rapped around it so you have to take it out and clean. It could also be the rubber belt is ... Eureka 431A Optima Bagless Upright Vacuum

Press the power button on - good got a green light (new battery) press the clean button - got a green light iRobot runs for a couple of seconds and stops, then starts, then stops. After two or three times I now have a red light on for the Status. All of the wheels seem to be clean. I used compressed air to clean the underside. But still have the start stop problem.


How many times does the red light blink before it pauses? ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Have a hoover windtunnel platinum. I have changed the bag ( hepa Q bag) but the bag light wont reset. so the vaccum wont turn on. I have unpluged it and let it set for a while with the new bag in and repluged it in. I have checked the brushes and it is all clean but it will not reset. This only the second bag so it is a new machine I should not be having problems. Is there some sore of reset button I can hit.


... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

I have a hoover windtunnel platinum. I have changed the bag ( hepa Q bag) but the bag light wont reset. so the vaccum wont turn on. I have unpluged it and let it set for a while with the new bag in and repluged it in. I have checked the brushes and it is all clean but it will not reset. This only the second bag so it is a new machine I should not be having problems. Is there some sore of reset button I can hit.


... Hoover Company Wind Tunnel U53019 Upright Vacuum

My Miele S748 will not run the overheat light and reset light on but can not find a reset button


... Miele Vacuums

I have a Beam serenity plus SP800A vacuum, the red light went on and the bristles stopped turning when I vacuumed up my bathroom rug. what does the reset button look like. Or does this model have a reset button. how do I turn off the red light so that the bristles start turning again?


... Beam Industries 2775 Serenity Plus Central System Vacuum

Dyson DC 24 brushbar motor stops working , every so often , I press the reset button then it works for a while and stops again till I press reset again.


Hi there, it's Jack at Dyson.DC24 is equipped with a safety device which shuts off the brush bar if something jams it - for example, a shoelace or a rug fringe. From what you've described, it sounds like there may be something in the cleaner ... Dyson Ball DC24 Bagless Upright Vacuum

I need to know if it has a reset button. we had a power outage and it has stopped working since than. cant find a button to reset it.


Vacuum cleaners do not have reset buttons instead it would have a thermal protection breaker integrated within the motor if the motor overloads it will shut off but will start again as it cools down.Check to make sure the outlet has power in it first ... Vacuums

Roomba Stops I've had a Roomba for about 2 months. Lately, it runs for about 45 secs, then stops, makes a two-tone (descending) sound, and flashes the CLEAN button while the STATUS button is red. I've emptied the dustbin on it. Can you help? I am seeing the same problem on my roomba today. I cleaned all that I could., the brushes, the pins on the sides and all that and it still gives the same problem..Any other fix?


Run your roomba through a self diagnostic test. I have posted the link below. Tell me your findings.\015\012\015\012\015\012http://mysite.verizon.net/gsplews/Diagnositic-Tests_Proc.v.0.5.htm ... iRobot Roomba 4210 Bagless Robotic Vacuum

Roomba Stops I've had a Roomba for about 2 months. Lately, it runs for about 45 secs, then stops, makes a two-tone (descending) sound, and flashes the CLEAN button while the STATUS button is red. I've emptied the dustbin on it. Can you help?


I just fixed mine by cleaning the shaft that the spinning brushes is on. I used an eyeglass screw driver to tke out the screw. it is running great now. I didn't realize my brushes werent spinning at the time of my post. Cleaning this part seemed ... iRobot Roomba 4210 Bagless Robotic Vacuum

It appears my eureka capture runs backwards - Eureka Capture Upright Vacuum Vacuum


... Eureka Capture Upright Vacuum Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0567 seconds