Having problems with your Eureka Deluxe Enviro Steamer Vacuum ?

I have a eureka big shot steamer that doesn't seem to get hot

\015 I don't have a manual to check for troubleshooting so I have no idea where to start. The body seams to be getting warm but nothing happens when I push the trigger. Any ideas\015

Answers :

Look for model number on machine and try this link http://www.eureka.com/servlet/ListParts
Repair Help & Product Troubleshooting for Eureka Deluxe Enviro Steamer Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a eureka big shot steamer that doesn't seem to get hot


Look for model number on machine and try this link http://www.eureka.com/servlet/ListParts ... Eureka Deluxe Enviro Steamer Vacuum

I have the Eureka Big Shot Envira Steamer. It get...


... Eureka Deluxe Enviro Steamer Vacuum

My Eureka Deluxe Enviro Steamer doesn't steam, I had no directions with it so I'm not sure how much water to put in it. It comes out the bottom before it heats up sometimes.It never seems to get hot enough. Hope you can help


You will need to pour two measures of water using the measuring cup or 12 oz of water. The reason why water comes out of the bottom is because the floor cloth is too wet or you had too much water in the tank\015\012\015\012Cl ... Eureka Deluxe Enviro Steamer Vacuum

Eureka hot shot steamer - Eureka 350A Handheld Steam Vacuum


... Eureka 350A Handheld Steam Vacuum

Eureka big shot steamer wont spray


... Eureka Vacuums

The steam in my handheld steam shot does not seem to be very hot therefore the surfaces, specially cloth ones do not get clean properly. What should I do?


If it steams it is as hot as it is going to get. Water steams at 212 degrees F at sea level so the only way to increase that heat is to pressurize that steam to a higher density than sea level which is about 32lbs per sq. in. Your steamer has no meth ... Bissell Vacuums

My Domotec handy steamer bought from Lakeland is not producing any steam. Have only used it a few times. makes a big noise and gets hot but no steam. I don't want to hold trigger too long in case something blows. In past steam has been quick to come out as soon as red light goes off. Any ideas?


... Domotec Vacuums

The handle for my Eureka 5993 AVZ was getting very hot when used. Finally, the wires around the switch melted and now the vacuum will not work. What is wrong? Is the switch bad? The wires only melted in the immediate vicinity of the three-prong switch. Nothing else appears to be wrong; the vacuum worked fine when it was running - except for the handle getting hot. Thank you!


Try cleaning all...\015\012if have sam paoblem need replaced main motor.... ... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

Eureka TRUE HEPA Whirlwind Bagless same problem seems...roller just stopped...took everything apart and turned it on just in time to see belt melt...I was able to get the end caps off both sides at first and now can't seem to get the one side. Really love this vacuum! Don't want to have to part with it!


If you are able to remove one end cap, the brush roller shaft can be removed and the other bearing is exposed for examination and removal of the hair that probably is clogging it. After cleaning and reassembly the brush roller should rotate freely. C ... Eureka 2961AVZ Bagless Upright Vacuum

I have a GXCFD GE Smartwater hot, cold water dispensor, everything works but the hot water, doesnt light up, or get hot. any suggestions


If there is no hot water coming out from your instant hot-water dispenser, check the following to find out the prolem and fix it :\015\0121.Power: Under-the-counter hot water dispensers are plugged into a standard wall socket that suppli ... GE Vacuums

My shark professional steamer plug gets extremely hot. Is that normal?


No it should not get hot undo the plug and check if the wirers are conected tight one of the main causes is loose wires, have you tried a differant outlet. ... Vacuums

Eureka 2981bvz bagless belt pully is getting too hot and burning through belt


Check the brush roll, if one end has overheated and is locked up so it won't turn, then you need to replace the brush roll. ... Eureka 2971AV EZ Kleen Bagless Upright Vacuum

I have a Eureka Altima vacuum cleaner that doesn't pick up very well. The suction seems fine but the brush roller doesn't seem to pick up from the top of the carpet. When you lower the height of the vacuum the belt rubs and smells horribly. How can I get the vacuum to pick up better?


That means that you need to replace the belt. Here is the belt you need to replace and the manual which has instructions:Eureka Altima ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Model#F5858-910 hoover steam vac,silver ,spin and scrub. It doesnt seem to spray cleaner it seems to stream it now. what could be wrong? I cant get to end of where it sprays to see if something is blocking it . otherwise it works great. I have it about 8 yrs. always worked good until recently


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Dco7 animal does not seem to be self adjusting the height. Beater bar is turning fine but doesnt seem to be getting into the carpet. Terry [email protected]


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Tobi Platinum clothes steamer gets hot at the handle making it too hot to hold and steam with??


We had the same problem but discovered it was because the steam hose had come adrift from it's fitting inside the handle. Dismantling the handle, re-attach the hose, re-assemble the handle and use some tie grips to hold the very poor design together ... Vacuums

Eureka 4870: when using hose, brush still spins, vacuum gets hot and smells like it's burning.


... Eureka Smartvac 4870 Bagged Upright Vacuum

Scunci steamer get hot but will not release steam


... Scunci 52000 Handheld Steam Vacuum

Shark steamer will not steam....gets hot but no steam


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have Optima, 12amp Eureka vacuum, Model 431, AXZ type and the extension hose for cleaning corners and edges --the plastic part that the attachments fit into has a piece broken off and tools don;t fit anymore. It looks like the hose attachment can be replaced--can it be and if so--where can I get a new hose attachment. It seems it is cheaply made of plastic and really shouldn't have broken a piece off.


... Eureka 431A Optima Bagless Upright Vacuum

Eureka the boss upright bagless vacuum. how do i open it to get to the belt area? the brush seems stuck. it wont move


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=801547\015\012Generic problem for all Vacuums\015\012Eureka the boss upright bagless\015\012 ... Vacuums

I have a eureka power paw that keeps breaking belts. there doesnt seem to be a part that keeps the belt in place


My belt keeps breaking too, but worse is that I can't find out the size for replacing. Who knows the size I need for the Eureka Power Paw? ... Eureka Vacuums

Manual scuncci steamer gets hot but no steam comes out


Scunci International 2200 Byberry Road, Hatboro PA 19040.Please refer to your product name and model number when contacting consumer service. They will give you repair or replacement info. ... Scunci 52001 Handheld Steam Vacuum

The engine seems to be accelerating and getting hot and no vacuuming happens


Everything you say points to there being a blockage somewhere. The motor's not moving any air, so it goes faster. Without any cooling air it gets hot. And, of course, with no air moving there's no suction. Find the blockage and clear it, and everythi ... Eureka Vacuums

The Eureka Environ Steamer won't heat up. It feels lukewarm and no steam is emmitted. It worked perfectly the first 3 times I used it but now, nothing! There is water in the tank, and the electrical outlet is working. The green light is lit on the unit, but it doesn't get warm.


... Eureka Enviro Steamer 310 Stick Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0968 seconds