Having problems with your Eureka Enviro Steamer 310 Stick Vacuum ?
Steamer #410 has cord problem
\015 The ele cord only works when you move the cord around at the unit and you have special star with pin screws so we can't check the wires ,I work at lowes and have sold this 410 steamer to my wife and she loves it ,she uses it on all our floor tiles she can move the cord at unit and it will heat up then stop again only to have to move the cord again.do I sent it back or can we fix it with this special screw driver or allan wranch thanks Larry Laughery\015
U can send it back or u can fix it urself its a simple fix all u have to do is check the power cord going in u can cut about an inch n reattach it and it should work good luck
Repair Help & Product Troubleshooting for Eureka Enviro Steamer 310 Stick Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Steamer #410 has cord problem
U can send it back or u can fix it urself its a simple fix all u have to do is check the power cord going in u can cut about an inch n reattach it and it should work good luck ... Eureka Enviro Steamer 310 Stick Vacuum
Miele vacuum Sometimes when I hit the auto roll up cord button or even move the cord, the power vacuum goes off. I move the cord again and it comes back on. I took it apart and looked at the connection from the cord to the auto roller. These are the electrical slip on type connections and are still in good shape. There are no bends in the cord. I air dusted everthing inside, put it together (with no extra parts!). Good news..it powered up so I did not break it, but it still has the same problem.
Hoover UH70120 WindTunnel TSeries problems with the cord. im a tech savy guy and have been trying to fix a cord after it was pulled to far out and now wont auto retract, but just cant find a way to pull the cord rewind mechanism out to work on it. Any advice
You will probably have to replace the cord winding mechanism. I have never had any luck trying to repair one. Cord retracters are great when they work but it seems like they always go bad before too long. On many units you can't even replace the cord ... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner
Meile Solaris. Power cord connection faulty. Unit powers on/off when cord is being retracted/pulled out. Maybe a break in wire close to connection point in vacuum. Or, the connection point itself is loose? The problem likely resulted from trying to use vacuum at furthest extent of cord.
Cord reel likely needs to be tightened. requirs disassembly and large washers installed to keep reel connections tight. Jim ... Vacuums
I have a durabrand food steamer model number FS1146R (ASDA spec code: 195/121). it is white a the bottom with a timer and has two clear plastic steamer compartments. The problem I have is that the handle on top of the lid has broken off. My husband has repair it a couple of times but can't do it anymore. Is there any chance I can purcase a lid as the rest of the steamer is still in good working order. How much would the lid cost? Many thanks Barbara Waller
Problem with cord rewinding mechanism on my Nilfisk King!Whilst repairing broken cord(successfully)the metal coil thats part of that mechanism sprang out!Can someone out there tell me how to put it back together again PLEASE.I would so like my cord to be able to retract again
A small thin antenna cord on my radio got sucked up, and I immediately turned my vacuum off and easily puled out the small cord, Afterward the brush on the vacuu would notrotate.. The belt is not broken on the vacuum is not broken. My husband cannot figure out what the problem is
Hi Susan. There may still be a piece of the cord in the brush roller bearing. Check the ends of the brush and have a look. If its clear the belt is probably strethed. An easy way to test this is to turn on machine a put you hand against brush, if it ... Riccar 8955 Upright Vacuum
Hey guys ! I have (or my wife has) A KENMORE whispertone 116. When my wife is cleaning with it it will suddenly stops.She then wiggles/pulls on the cord and it starts again and the stops.I pulled the cord all the way out and it is fine.So its inside.I dont relish the thought of playing with that reel but thats probably where the problem is (you think ??) My first challenge is how to seperate thw tp and bottem half peices???
It definitely sounds like the cord winder is the problem. I can tell you how to take the machine apart, but it's just about impossible to rebuild that winder. When you take the winder apart the spring blows apart, and it's very dangerous. I won't be ... Vacuums
Cord problem My cord just caught on fire while I was vaccuuming the floor. I was wondering who I could get a hold of to get this fixed as soon as possible. I have the G6 mode..
Here is the contact information off of the Kirby company website. They can advise you regarding the Kirby authorized service center nearest to you. \015\012\015\012\015\012 - Contact Us By Phone\015\012United States and Canada: 1-800-494-8586 \01 ... Kirby G6 Bagged Upright Vacuum
My electrolux ambassador power wand quit working. I replaced the switch that shuts it off when the roller stops, but it wasn't the problem. The on/off switch is fine, the motor is fine. We have traced the problem to the wires inside the canister by opening the inside cover to the bag container. We see the power cords going into the canister but we're not able to get to anything. We can't find any screws to undo that would open it up in order to follow the wires deep into the canister. We've bypa
... Electrolux Vacuums
I have a Kenmore 12.0 amp vacuum whispertone , Mode number 2531290, serial number DE3992905. The cord retract is not working, and the cord is half way out, I can not seem to figure out out to open the cansiter so I can see what the problem is.
... Kenmore 24212 Whispertone Bagged Canister Vacuum
The retractable cord is stuck all the way out and will not go back in. Is there a simple way to fix this "disaster"??? without taking vacuum apart that is. And this is not my exact vacuum but I figure the cord problem would go for all of them. Ours is a ORANGE HEPA 360 Kenmore Whisper Belt 12 amp with PowerMate Model # 116.29219800
... Kenmore 27915 Bagged Canister Vacuum
Hi I have two identical Miele Monte Verde's and they have the same problem. Both developed an electrical problem where the machine only works at a certain place in the cord, and better if there i
Have someone check the cords end to end each side with a meter to see if one is broken inside (broken wire inside the cord) ... Vacuums
My Kenmore 7520 canister vacuum has a problem with the retractable cord. It has jammed and does not come out or retract. It jammed half way through the retracting action. Cannot pull it out or retract. Would like to know how to open the canister to take a look for the problem. Thank you
I have a Morplan Vitesse 1600w steamer. When switched on the steamer doesn't heat up, only a red light flashes on the steam level lights. Any idea what could be the problem?
Check the water lvel in the steamer, if there is water then take the unit to a repair shop for a checkup. ... Vacuums
No power. I was getting intermittent power with my miele s558 midsize canister, but it was predicated with me fiddling with the retractable cord to get it to come on and then not move the canister while I was vacuuming. Now I can get no power. I have taken it apart and can see no issues with connectors, cord, casings, etc. It all looks fine. It is about 5 years old and I have had no problems with it.
... Miele S558 Red Velvet Bagged Canister Vacuum
Lately, my Kirby Ultimate G has been acting funny. When I push it forward, it's fine, but when I pull it backward on the carpet, the light on the front flickers and the power flutters off an on. I thought it might be the rollers, so tonight I turned the machine over and pulled out the hair that was wrapped around the roller. However, that did not fix the problem. I should probably backtrack a little bit. In the past, I have had problems with the vacuum running over its own power cord.
The cord will need to be replaced with a cord made for the machine, as it has a non-standard plug. The cord cover is held in place with a # 20 Torx screw. Remove the screw and push the cover gently from behind to unlatch it. The handle must also be r ... Kirby Ultimate G Bagged Upright Vacuum
I have a problem with a miele s524 canister vacuum. While the motor is running and you pull out the power cord for more length it shuts off.
S524 vacuum was vacuuming the floor under the a chair wand everything was floor level it stopped running checked all connections everything was connected no blockages etc help !!!! ... Miele S524 Mercury Bagged Canister Vacuum
Royal 3050 cord retractor problem
... Royal Procision 3050 Bagged Canister Vacuum
My vacuum Miele HS01 Model S314i (prod.2003) doesn't work becouse of loosing electric contact between cord and motor. How can I solve this problem?
... Miele Red Star Bagged Canister Vacuum
Power cord reel problem with a kenmore canister vacuum whisperti
Pull the cord all the way out and see if it's contaminated with anything sticky. Also check the guide rollers that the cord rides in and see if they are rolling smoothly and without resistance - they may also need cleaning. If so, clean it off an ... Kenmore Progressive 20912 Bagged Canister Vacuum
Can,t make my rewind cord-rewind --How do you take the back off???????.SOOOOO------I can check the problem----need respond ASAP!!!!!!!!
This is a tricky job and will require a new winder mechanism. Take it to a repair shop and ask for a quote. ... Vacuums
I have a problem with my Shark Euro Pro Electric Flatiron. I purchased it a few years ago and can't locate my manual to find out what to do. The steamer button doesn't want to press down all the way so just a little steam comes out instead of the full one like it should. Please help!
I just purchased and electric percolator. I plug it in to see if it worked. It percolated but never shut off. The electric cord and pot look brand new. On the bottom it is stamped US patent 1999329 108-115 volts 425 watts. Percolator No 201. It says there is a fuse inside. Could this be the problem? I haven't used and electric percolator and do no t know what to expect.
The fuse would not be the problem as it would cause the percolator to not work at all.The patent expired in 2007 and wasn't renewed so the company is likely out of business meaning no parts.Is there a removable panel somewhere?If there is,would you o ... Vacuums
Wiring diagram for Model #11635922500 - KENMORE Upright vac I took the cover off of the vacuum to repair the power cord and must have pulled a wire out of its wire nut by the sweeper bar. If I had a diagram it would be no problem to replace. The bad has four short gray wires coming out of it. It is one of the gray wires that has come loose.
... Kenmore Vacuums