Having problems with your Eureka Powerline 6852 Canister Vacuum ?

Eureka electric hose

\015 Hello,I have a Eureka model 6826. The hose is electric. The hose split near next to the plastic connector. Is there a way to remove the plastic head disconnect the wires and then close it all up again? There doesn't seem to be a way to open it. ThanksRoger Hargrove\015

Answers :

Repair Help & Product Troubleshooting for Eureka Powerline 6852 Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Eureka electric hose


... Eureka Powerline 6852 Canister Vacuum

Electrical connection to Eureka Powerhead.


... Eureka Vacuums

Replacing wheel Hoover spirit vacuumm - Hoover Spirit Canister Vacuum Cleaner Non Electric Hose Canister Vac Cleaner Non Electric Hose


... Hoover Spirit Canister Vacuum Cleaner Non Electric Hose Canister Vac Cleaner Non Electric Hose

On a filter queen 360 vaccum the electrical connection from the hose to the wand was loose and over time the electrical arcing burned up the female conector piece. Is there any way I can replace this without having to buy a new hose! Where would I find this female conector piece.


I am having the same problem On a filter queen 360 vaccum the electrical connection from the hose to the wand was loose and over time the electrical arcing burned up the female conector piece. This sounds to me like a manufac ... Filter Queen Vacuums

My Dyson DC20 motorhead vacuum has a blocked hose - how can I unclog this? I think there is a sock caught up by the handle. The hose has electrical wires running through it so I cannot cut the hose.


Usually a plugged hose can be cleared using a broom handle, if you can force the blockage through, if not as previously suggested a coat hanger attached to the broom handle (duck tape will do) straighten out hanger so it can be used like a cork screw ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

My Hoover Steamvac Widepath will NOT pickup the water after dispensing. I checked the hose inside the cleaner, there was a cut in the hose so I put electrical tape and completely sealed the cut. Still will NOT pick up water. I can't find any other problems with the hose. Any suggestions?


HelloHere are some suggestions you might want to follow to solve this problemFirst double check if there are other cuts in the hose or any sort of blockage or clogging in the hose and be sure to remove any form of debris ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

Electrolux Oxygen 3 Model EL7020 with a bag and HEPA. I have a body only,and problem is-I can't turn it on.I read in a Manual,it possible only when electric hose connected to the body, . so I have to buy a hose, what is relatively expensive. Does anybody knows,how to check this vac without a hose? Thanks.


\015\012You can get a replacement hose here http://evacuum ... Electrolux Oxygen 3 Upright Vacuum Cleaner - EL5035 Vacuum

I have Optima, 12amp Eureka vacuum, Model 431, AXZ type and the extension hose for cleaning corners and edges --the plastic part that the attachments fit into has a piece broken off and tools don;t fit anymore. It looks like the hose attachment can be replaced--can it be and if so--where can I get a new hose attachment. It seems it is cheaply made of plastic and really shouldn't have broken a piece off.


... Eureka 431A Optima Bagless Upright Vacuum

I have the eureka bagless capture. The main hose is what I am interested in. I cracked the end of the hose where I would attach other parts such as the slim attachment for corners and to get inside the pillows in my chair, The part that I broke is on the very end of the hose. I had the plastic part clogged with some hair and during the process of getting it cleaned out, the part that I am speaking about is broken. Can you help me. I thank you, Mo moss


Change the hose part try a company called cds they r in the midlands but they courier parts\015\012out 2u dont have their no 2 hand u will need the model number try the\015\012web marting ... Eureka Uno 2998AZ Bagless Upright Vacuum

DC07 DYSON REPLACEMENT HOSE. HOW DO YOU REMOVE IT FROM THE HANDLE. I have a kenmore whispertone 8540 canister vaccum. The electrical wires (3) to power the beater are embedded in the hose, in a spiral fashion. The yokes that hold the hose on both ends (and attach to the beater on one end and the unit on the other) have no screws or pressure latches; i don't want to use brute force as i may damage the attachment device inside the yoke. If someone can tell me the trick to get these yokes off each


Should be a pry off dot on the underside revealing a screw ... Vacuums

I have the Eureka The Boss Power PLus Model # 4703 Type A. When using the detached hose and wand it works OK; however, when using the Vacuum with the hose attached it doesn't work well at all.


... Vacuums

WE NEED A HOSE RACK FOR A EUREKA CENRTAL VAC 36FT.HOSE IS ONE AVAILABLE OR WILL ANY GENERIC HOSE HOLDER BE SUFFICIENT. [email protected]


Any shop or store that sells central systems will have hose hangers, any one should work. ... Vacuums

Eureka air extreme hose assembly replacement - Eureka Smartvac 4870 Bagged Upright Vacuum


... Eureka Smartvac 4870 Bagged Upright Vacuum

I have a Eureka Boss Power Plus and the beater bar is rolling, the belt is turning, but after vacuuming up around the litter box (not a lot of litter), when I turn the vacuum off, the litter, or even household dirt, falls out. When I hold the vacuum back to turn it off so that it doesn't fall on the floor, it's sitting in the cubby where the wheels are. The bag is empty, the hose is not plugged, the hose is securely fitted on both ends of the unit. This vacuum was purchased in July and is being


Even though the brush is spinning, you probably need to replace the belt because it is s ... Eureka Vacuums

My eureka smartvac 4870 has no suction at hose or floor. all hoses are clear, filters clean and properly installed. bag not full and properly installed


Your eureka has no suction kuz the vacum hose needs cleaning ... Eureka Smartvac 4870 Bagged Upright Vacuum

Clogged hose on Eureka boss - Eureka Boss 7601 Bagged Upright Vacuum


... Eureka Boss 7601 Bagged Upright Vacuum

I'm using a Eureka maxima 12 amp vacuum and where the hose is connected to the vacuum by a screw that part is broken where do I find a replacement hose that includes the clear plastic part that I can attatch to the vacuum?


... Eureka 4700A Maxima Bagless Upright Vacuum

Eureka Boss 2270 hose clogged - Eureka Boss 7601 Bagged Upright Vacuum


... Eureka Boss 7601 Bagged Upright Vacuum

My Eureka 4870 has no suction on the floor or hose setting, white air blows out the front filter. Further, the roller does not move when on the floor setting. The belt is in good condition and I cannot find any blockage in the hoses. Any ideas?


Suction problems on the Eureka 4870: after cleaning all accessible piping; cleaning the motor filter; changing the bag and replacing hepa filter the final problem was found. Removal of the motor cover revealed that the rubber gasket that fits over th ... Eureka Smartvac 4870 Bagged Upright Vacuum

I have a eureka cv2301b central vac system that turns on and works when the system is plugged in but when operating the hose and head inside the house you cannot shut off the system even if you unplug the hose from the wall... Whats going on


... Eureka CV2301 Bagged Central System Vacuum

Something is stuck in my hose on the eureka boss smartvac, can i dtach plastic hose on side


Yes, there are a few screws that need to come out to do so, u can also use a coat hanger to loosen it up and turn it on, the vac will **** the loose dirt into the bag/canister ... Eureka Smartvac 4870 Bagged Upright Vacuum

My electrolux oxygen canister cuts on and off. I have to open and close the vacuum, or take the base of the hose off and then re-insert. I have to do all these things before it will start up again. I sometimes shake the hose around, then it will come back on. If I try to dust with the dust brush (like a lamp shade or shelf) and the suction pulls against the object, the vacuum goes off for awhile. Sometimes I'll have to reset the vacuum by unplugging the electric cord. I never get to finis


Maybe you should have taken it back to that shop, it appartently isn't fixed. I would have replace that board, don't believe in modifing, you usually end up with other problems, like you have. One thing to check is maybe you have a partial clog in ... Vacuums

I have an Eureka Enviro Vac, I have replaced the filter, cleaned the hose and it still won't pick anything up. The brush is turning and there is suction in the hose. What else can I check?


... Eureka Vacuums

How to replace hose assembly on eureka 4870 - Eureka Smartvac 4870 Bagged Upright Vacuum


... Eureka Smartvac 4870 Bagged Upright Vacuum

INSTRUCTION MANUAL FOR EUREKA LIGHTSPEED 100 - Eureka 2 Type Dcf4-Dcf18 Upright Vacuum Cleaner Hepa Pleated Washable Filter W/activated Charcoal Whirlwind Mighty Mite Maxima Boss Power Plus Pet Pal Lightforce 300 Lightspeed 100 General Electric Ge 63073 4700 5500


... Eureka 2 Type Dcf4-Dcf18 Upright Vacuum Cleaner Hepa Pleated Washable Filter W/activated Charcoal Whirlwind Mighty Mite Maxima Boss Power Plus Pet Pal Lightforce 300 Lightspeed 100 General Electric Ge 63073 4700 5500
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0360 seconds