Having problems with your Eureka Smartvac 4870 Bagged Upright Vacuum ?

How do you replace the handle release pedal - Eureka Smartvac 4870 Bagged Upright Vacuum


Answers :

The handle release is just snapped into the bottom base. To take it out you will need to take a flat screw driver and pry the old one out. Then take the new one and pop it into place.
Repair Help & Product Troubleshooting for Eureka Smartvac 4870 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you replace the handle release pedal - Eureka Smartvac 4870 Bagged Upright Vacuum


The handle release is just snapped into the bottom base. To take it out you will need to take a flat screw driver and pry the old one out. Then take the new one and pop it into place. ... Eureka Smartvac 4870 Bagged Upright Vacuum

Replace handle release buttom Eureka 4870 - Eureka Smartvac 4870 Bagged Upright Vacuum


... Eureka Smartvac 4870 Bagged Upright Vacuum

The handle release lever (Part N. 38434-021) on my Hoover WindTunnel upright vacuum (uses Y bags) broke. How do I install the replacement release lever (pedal) that I purchased?


You can buy Hoover Handle Release Lever 38434-021 at \015\012http://partsreadyonline.com/item.php?ItemID=798 ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

How to replace belt on a eureka boss vacuum - Eureka 4870SZX BOSS SMARTVAC PET LOVER Bagged Upright Vacuum


If you look on the base plate you should see a diagram of how to do it,but if yours don't have a diagram then remove the screws from the base plate it should be three or four they have arrows next to them. take the base plate off and remove the brush ... Eureka 4870SZX BOSS SMARTVAC PET LOVER Bagged Upright Vacuum

VACUUM REPAIR I have a Hoover Savvy upright, windtunnel, bag/bagless vacuum (model U8150-900). The Handle Release Foot Pedal - Part #38434026 broke soon after purchase but I finally found a source to replace this item. The problem is that now that I have the repair part I cannot figure out how to remove the old pedal and install the new one. The housing appears to be one piece of solid plastic. Any ideas, PLEASE! Peter


There are 2 tabs that stick out on the release, they fit in slots, so from the top look down and you can see them, using a flatblade screwdriver that will fit in there, push the side in to release it, which isn't easy, but it can be done. When you g ... Vacuums

How do I replace belt on Eureka smart vac? - Eureka Smartvac 4870 Bagged Upright Vacuum


... Eureka Smartvac 4870 Bagged Upright Vacuum

How to replace hose assembly on eureka 4870 - Eureka Smartvac 4870 Bagged Upright Vacuum


... Eureka Smartvac 4870 Bagged Upright Vacuum

The handle release pedal broke on my Eureka Smartvac. The spring is still in tact. I have a replacement pedal, but cannot figure out how to install it. Any suggestions?


... Eureka Smartvac 4870 Bagged Upright Vacuum

Eureka air extreme hose assembly replacement - Eureka Smartvac 4870 Bagged Upright Vacuum


... Eureka Smartvac 4870 Bagged Upright Vacuum

Eureka model 4870 g2 belt replacement - Eureka Smartvac 4870 Bagged Upright Vacuum


... Eureka Smartvac 4870 Bagged Upright Vacuum

I have a Kenmore vacuum cleaner model #116.34720. The problem I am having is that if you are rolling the vacuum around, the base will drop without pressing on the handle release pedal. This often results in a bunch of dirt being dumped back out. The manual doesn't show anything about adjusting the handle release pedal so it holds the handle and base in an upright position better. Any help is greatly appreciated! Thanks in advance!


... Vacuums

Replaced belt but isn't tight to turn roller - Eureka Smartvac 4870 Bagged Upright Vacuum


Are you sure that you have the right replacement belt? Here is a link to the belt you should have and the manual:Eureka 4870 Belt ... Eureka Smartvac 4870 Bagged Upright Vacuum

Replace power cord - Eureka Smartvac 4870 Bagged Upright Vacuum


... Eureka Smartvac 4870 Bagged Upright Vacuum

Foot latch is broken. need to replace with new one. how does one access to remove the foot pedal latch. By foot latch, I mean the foot lever that releases the upright to lower the handle and begin vacuuming.


It is accessed from the bottom underneath by the rear wheel. However, If there are and cracks on the pedal release socket area then the base will need replacement. parts are little cost but the unit needs to be completely disassembled. ... Hoover U6446-900 WindTunnel Bagged Upright Vacuum

How to replace the handle release lever - Hoover U6446-900 WindTunnel Bagged Upright Vacuum


... Hoover U6446-900 WindTunnel Bagged Upright Vacuum

I am replacing a foot pedal on an upright Sharp vacuum cleaner-EC-TU2607. I have the broken foot pedal removed from vacuum cleaner proper but it is the removal of the broken pedal from its spring load that has me puzzled. I applied some pulling effort on the pin that holds the spring in place but there doesn't seem to be any give. Is that the correct approach or is there something else that one should be doing first to release some of the resistance by the pin or spring? Thanks!


... Sharp Twin Energy EC-TU2607 Vacuum

How to replace handle release pedal on dirt devil kinetix self propelled vacuum cleaner. I need to remove the broken pedal and replace it with the new one.


... Dirt Devil Reaction Twin Cyclone Upright Vacuum

Thermal switch on eureka vacuum 4870 - Eureka Smartvac 4870 Bagged Upright Vacuum


... Eureka Smartvac 4870 Bagged Upright Vacuum

Eureka vacuum won't turn on - Eureka 4870SZX BOSS SMARTVAC PET LOVER Bagged Upright Vacuum


... Eureka 4870SZX BOSS SMARTVAC PET LOVER Bagged Upright Vacuum

How to replace handle release pedal on dirt devil kinetix self propelled vacuum cleaner. I need to remove the broken pedal and replace it with the new one.


... Dirt Devil Reaction Twin Cyclone Upright Vacuum

How to replace handle release pedal on eureka envirovac model3041


... Vacuums

Handle release pedal replacement on Dirt Devil Reaction vacuum


... Dirt Devil Reaction Twin Cyclone Upright Vacuum

Belt replacement for eureka boss 7606 - Eureka 7606 Bagged Upright Vacuum


... Eureka 7606 Bagged Upright Vacuum

What causes my eureka boss vac to smell bad - Eureka Smartvac 4870 Bagged Upright Vacuum


Clean it out with lemom juice ... Eureka Smartvac 4870 Bagged Upright Vacuum

Eureka 4870 will not power on - Eureka Smartvac 4870 Bagged Upright Vacuum


It is probably a thermal issue ... Eureka Smartvac 4870 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1525 seconds