Having problems with your Eureka Smartvac 4870 Bagged Upright Vacuum ?

Why doesn't the Eureka the boss won't vacuum ,only with hose


Answers :

Repair Help & Product Troubleshooting for Eureka Smartvac 4870 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Eureka Boss Power Plus and the beater bar is rolling, the belt is turning, but after vacuuming up around the litter box (not a lot of litter), when I turn the vacuum off, the litter, or even household dirt, falls out. When I hold the vacuum back to turn it off so that it doesn't fall on the floor, it's sitting in the cubby where the wheels are. The bag is empty, the hose is not plugged, the hose is securely fitted on both ends of the unit. This vacuum was purchased in July and is being


Even though the brush is spinning, you probably need to replace the belt because it is s ... Eureka Vacuums

Clogged hose on Eureka boss - Eureka Boss 7601 Bagged Upright Vacuum


... Eureka Boss 7601 Bagged Upright Vacuum

Eureka Boss 2270 hose clogged - Eureka Boss 7601 Bagged Upright Vacuum


... Eureka Boss 7601 Bagged Upright Vacuum

I have a Eureka 4800 series the Boss upright with a bag and Hepa filter. I love it! I was just vacuuming with the hose part and all was well and then suddenly the lower brush came on and a "burning" smell followed. Thought it was the belt so my husband was going to put on the new belt which I had on hand! When he turned it over, the "bar" that holds the belt looks as though it "shot through" the plastic side of the housing on the vacuum. There is melted plastic on the outside of the vacuum and o


I had the same problem. Take out the old belt if possible. Remove the 4 screws inside the filter and the 3 on the front of that housing. pull out the foam around the motor. carefully pull out the suction tube that is press fit against the motor. ... Eureka 4874 Bagged Upright Vacuum

I have the Eureka The Boss Power PLus Model # 4703 Type A. When using the detached hose and wand it works OK; however, when using the Vacuum with the hose attached it doesn't work well at all.


... Vacuums

I have a Eureka "The Boss" vacuum that doesnt seem to be sucking up as much as it should and did in the past when vacuuming on carpet and hard floor surfaces.


I have a Eureka "The Boss" vacuum that doesn’t seem to be sucking up as much as it should and did in the past when vacuuming on carpet and hard floor surfaces.\015\012 \015\012I woul ... Vacuums

My home has a central vacuum system hook-up but no vacuum installed. My friend upgraded his central system and gave me his Eureka Mega Boss central vacuum system and the accessories, including the pow


The power head requires 120 Volts. Some hoses have a receptacle in the handle for the power head plug, and the hose has a cord at the wall inlet end that plugs into a receptacle. Some hoses have a plug at the wall inlet end that plugs into a 120Volt ... Eureka 1810 Central System Vacuum

Why doesn't the Eureka the boss won't vacuum ,only with hose


... Eureka Smartvac 4870 Bagged Upright Vacuum

Eureka the boss upright bagless vacuum. how do i open it to get to the belt area? the brush seems stuck. it wont move


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=801547\015\012Generic problem for all Vacuums\015\012Eureka the boss upright bagless\015\012 ... Vacuums

I have a eureka the boss vacuum it wont pick up. I cleaned out the tubes the belt is good. the tubes are clear. What else can I do?The bag is only 1/4 full


... Eureka Vacuums

Eureka The Boss Power PLus Model # 4703 Type A Ser #: 0728007324 Adapter that goes between the hose and the vacuum body is held on two tabs (screws). The screw tabs have broken off. Where can one obtain a replacement adapter?


... Eureka Power Plus 4703D Bagless Upright Vacuum

How to replace belt on a eureka boss vacuum - Eureka 4870SZX BOSS SMARTVAC PET LOVER Bagged Upright Vacuum


If you look on the base plate you should see a diagram of how to do it,but if yours don't have a diagram then remove the screws from the base plate it should be three or four they have arrows next to them. take the base plate off and remove the brush ... Eureka 4870SZX BOSS SMARTVAC PET LOVER Bagged Upright Vacuum

EUREKA BAGLESS VACUUM CLEANER (THE BOSS) IS CLOGGED UP .


... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum

I'm using a Eureka maxima 12 amp vacuum and where the hose is connected to the vacuum by a screw that part is broken where do I find a replacement hose that includes the clear plastic part that I can attatch to the vacuum?


... Eureka 4700A Maxima Bagless Upright Vacuum

Eureka 4331 (Boss Lite) vacuum doesn't pick up dirt anymore


... Eureka Lite 4331 Bagged Upright Vacuum

Eureka boss 4870 overheating - Eureka 5849A Boss Bagless Upright Cyclonic Vacuum


... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum

Replace Filter on Eureka The Boss super Lite - Eureka Boss SuperLite Bagless Upright Vacuum, 405AVacuum


... Eureka Boss SuperLite Bagless Upright Vacuum, 405AVacuum

Eureka Boss 12 amp Belt change - Eureka Mega Boss 4460DT Vacuum


... Eureka Mega Boss 4460DT Vacuum

Manual for eureka mega boss - Eureka Mega Boss 4460DT Vacuum


... Eureka Mega Boss 4460DT Vacuum

Eureka the boss pro 2272 type av bags - Eureka 5849A Boss Bagless Upright Cyclonic Vacuum


... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum

Eureka vacuum won't turn on - Eureka 4870SZX BOSS SMARTVAC PET LOVER Bagged Upright Vacuum


... Eureka 4870SZX BOSS SMARTVAC PET LOVER Bagged Upright Vacuum

Eureka the boss 285 model manuel - Eureka Boss Superbroom Bagless VacuumStick Vacuum


... Eureka Boss Superbroom Bagless VacuumStick Vacuum

Eureka Boss central vac wont turn on?


... Vacuums

How to change belt 4870MZ Eureka Smart Boss Vacuum


... Vacuums

I have Optima, 12amp Eureka vacuum, Model 431, AXZ type and the extension hose for cleaning corners and edges --the plastic part that the attachments fit into has a piece broken off and tools don;t fit anymore. It looks like the hose attachment can be replaced--can it be and if so--where can I get a new hose attachment. It seems it is cheaply made of plastic and really shouldn't have broken a piece off.


... Eureka 431A Optima Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1139 seconds