Having problems with your Eureka Whirlwind LiteSpeed 5843 Upright Vacuum ?

Can I wash filter?

\015 Can I clean filter?\015

Answers :

Repair Help & Product Troubleshooting for Eureka Whirlwind LiteSpeed 5843 Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

HEPA Filter My vacuum came with a sponge over the filter and the directions said I could wash the filter. Do the directions mean to wash the black sponge or the actual filter? Is the sponge part of the filter or is it trash? Filter F27 Dirt Devil Purpose Cleaner for Pets Upright Bagless Vacuum Model #1LY2108-000

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=618630&thid=730623\015\012HEPA Filter\015\012Posted by jenski66 on Jul 02, 2008\015\012My vacuum came with a spon ... Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum

Just had my dc24 for 6 weeks - decided to wash filters - do the filters stay in their plastic covers? They were a bit dirty but no visible dirt came out when i washed them 9in their plastic casings). Surely they will take ages to dry.

Hi there,\015\012\015\012To confirm, the filters do stay in their plastic casing when you wash them.\015\012\015\012You may find it helpful to refer to this Dyson video guide, which demonstrates each step in the filter wash pr ... Dyson Ball DC24 Bagless Upright Vacuum

I have a bissell vacuum model 3760-2 and it smells terrible when it is in use (like wet pet hair). I have emptied and washed the main collection "tank" and unscrewed the filter and washed the flexible filter but it still smell horrible. Any suggestions?

The filter if its dirty in gives bad smell.Also if it gets worn out or very old it gives bad smell.Many other users too have noticed this bad smell.Replacing the filter helped many other users too.\015\012The worst part being smell of the filte ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

The filter gives red light.Does this mean the filter must be washed or changed. How should it be washed, what does ''washable'' mean here?

Red light normally denoted filter is blocked. If it is a washable filter then wash it. If it liiks like a paper type filter, replace it. Washing it will make it clog up even more. ... Electrolux Oxygen Z5540 Pet Lover Vacuum

I had used Dyson DC08 to **** out a wet car carpet. A few days later when using the V/C, there was a burning smell. Subsequently I washed the flexible hose, changed the pre-filter and post filter , but I wrongly put the pre-filter in the spot for the post filter. When the V/C was next used, there was again a burning smell and sparks. The filters were switched, but the V/C would not re-start. What shall I do?

Hi there,We'd strongly recommend against using your Dyson to pick up water. If you haven't already got in contact with us directly, I'd encourage you to do so. One of our experts will be happy to recommend the best course of action. You c ... Dyson DC08 Cylinder Bagless Canister Cyclonic Vacuum

My electrolux vacuum cleaner twinclean cyclonic 13MXXL Reach stopped working..lights on filter clean started flashing. I washed the filters...anything else I need to do. I'm waiting for the filters to dry. Thanks .Erika

... Electrolux Vacuums

Hello- my motor filter is becoming clogged every time i use it. i have removed and washed it--I thought maybe i didn't have the lid closed tight enough but for some reason dirt is pouring into the filter, it seems that some of the dirt suctioned is actually being pulled into the filter intead of the canister

One way or another, dirty air is by-passing the cyclone. My best guess is that when you emptied the clear bin, a seal has dropped out (or become displaced) and the base of the clear bin is no longer sealing properly against the bottom of the cy ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a sta rite (pentair) cristal high rate sand filter model T-200-BP-1....its leaking water thru the top of the valve, where the valve cover screws on the valve body assembly. it leaks water out where they go together around the screws. Also when i vacuum it, everything that i vacuum gets washed back in the pool when its on the filter position. Also the backwash leaks when its turned 2 the filter position, does it supposed to do that?...the only way i have gotten it to stop is to put a seper

... Vacuums

I have a nearly 9 year old Electrolux Excellio Z5228 vacuum cleaner. It has recently started cutting out during operation. I cleaned the micro filter (between bag & motor) via brush & hitting against wall & seems / looks quite clean. I washed the gore filter (output from motor to clean the exhaust air) as per instructions, then let to dry. It was very clogged but now very clean. The vacuum clearner still cuts out often. Even after a long rest (say overnight) it still won't start, then ano

... Electrolux Vacuums

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK. Mine is so loud I can't use it very long-high pitch screech. Can this be fixed or does the whole vacuum need to be replaced? It still cleans gr

Sounds like a bad motor. Could be either foot motor or main motor either way cost will be more than half of the unit. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

Can cloth filter be washed in washing machine

... Eureka CV1801 Bagged Vacuum

Filter compartment on the front of the vacuum keeps getting very hot and coming off. Do I wash that filter? Or can it get clogged?

... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK.

Sounds like a bad motor bearing. If it is, then you would have to replace it. Could be the brush roll, did you check the ends to make sure they turn easily? ... Vacuums

It seems to be blowing dirt around not suking but when removing the attachment to clean stairs etc the pipe works fine have washed filteR ? SLIM UPRIGHT DC ALLERGY 18. Have cleaned out filter emptied cylinder taken any bits of cotton or hairs from brushes..........

... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Panasonic MCE6003 vacuum cleaner. I regretfully leant it to a neighbour and it came back full of dog hair and keeps cutting out. I cleaned out the dust container and the main filter but it still kept cutting out after 5 minutes. I decided to unscrew the part with the motor and wash the filter inside.It was all going well until a large rubber washer bit, a piece that looks like the thermostat and a little white button attached to two black wires fell out and now I have no idea how to put

... Panasonic Vacuums

I guess i washed the filter - Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum

... Dirt Devil 12 Amp HEPA Filter Vacuum Vacuum

I just bought this vacuum at a second hand store. My girlfriend told me to grab it as it such a quailty product. How ever I can't find a model number or anything else. I need a manual please. Does it take bags? Do I need to replace the filter or just wash the one I have? It is black and silver, cannister. It also says big gary's vacuum system warehouse in surry British Columbia, Canada. It also says to use filter pow-r-nozzle 96. I have no idea of the year.

I suggest you google what you know. I dont think anyone here can suggest where you can get a manual for a machine you dont even know the name of.\015\012\015\012You ask about a bag ... I dont know ... is there one in it now? You ask abo ... Vacuums

The hose to my Dyson Dc24 has no suction. There is suction from the exhaust when I move the cyclone bin. I have removed, washed and replaced filters. The valve next to the top filter keeps flapping. I've checked for blockages and can't find anything.

... Dyson Ball DC24 Bagless Upright Vacuum

The instructions for the filter says to wash the filter and I do not have the manual anything else I need to do to it

No, maybe clean the brushroll. they also state that you don't have to change the hepa filter, you will need to do that every 2 years. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Can i wash the filter on my shark roadster

... Euro-Pro Shark Roadster Vacuum HEPA Filter

Can i wash the filter housed in the cylinda

This is a common question asked of almost every vacuum tech. In most cases yes it can be washed. For best results if it is fibre or paper, dont wash it get a can of compressed air like you would use for a computer and blow it out. if it is any othe ... Vacuums

Can any of the filters for this vacuum be washed?

... Hoover U57009RM Vacuum

How do I wash the filter for my Hoover upright.

Hello,Here is link to a website that has a users manual for your model. When you get to the site, click on where it says U6630900. Download manual and keep for future reference. Here you'll see how to clean the filter.Hope this helps. ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

How do I wash a washable filter

... Vacuums

Cleaner cuts out after 10-15 minutes, have washed both filters.

There will be safety relay(OLR) check the settings and increase the settings then chack the operation. ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0325 seconds