Having problems with your Euro-Flex SC60 Canister Steam Cleaner ?

Why does the button on extension tube for euroflex sc60 comes off when in use?

\015 Buttons on the extension tubes comes off when cleaning the floor\015

Answers :

Repair Help & Product Troubleshooting for Euro-Flex SC60 Canister Steam Cleaner

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Why does the button on extension tube for euroflex sc60 comes off when in use?

... Euro-Flex SC60 Canister Steam Cleaner

My cigarette injector nozzle on my Top-O-Matic keeps coming off. Why and how do I fix it? With glue? I put the tobacco in, and my empty cigarette tube on the nozzle, then use the hand crank to push the tobacco into the tube and the NOZZLE is coming off with the tube and the tobacco isn't filling the tubes. please email me back a response [email protected]

... Hoover H3030 FloorMate SpinScrub 500 Upright Wet/Dry Vacuum

My infinity vac NV29 seems to have an extension wand stuck down in then tube and I am not able to get it out. We rented our winter home and evidently they found some type of extension that did not belong to it. Is there a way to take the handle apart in order to remove it? I am not able to use it with the handle and have to use the one on top of the canister, which is extremly difficult for me since I am disabled. Thank you.

... Euro-Pro Vacuums

REMOTE CONTROL IS MALFUNCTIONING & NOT TURNING ON CUSHION - Hello. I bought a used (by near new) Shiatsu+ Massaging Cushion from Ebay. When I installed it today the remote control was faulty. When you push the Power button, the blue light comes on, but none of the other buttons work. When you push the Power button again to turn it off, it clicks & turns itself back on again. So it's running but nothing is happening in the massage cushion. I did see a card in the box saying "For the Shiatsu

Before you use this cushion you MUST first 'unlock' the rollers which are held in place by a screw which MUST be removed or the unit will self destruct. The manufacturer provides a hex wrench to remove the shipping screw and a large label on th ... Vacuums

Hose extension tube will not fully go down after use (the hard tube seems to be stopped). Have lost manual - is there a way of taking hose base out to check for blockage. It is a DysonDC15 bought October 06

Keep ur tube, wand very straight. then there should be two side buttons, press them and the tube SHOULD gently slide down.\015\012\015\012Ive expierienced the same problem! ... Dyson Vacuums

I have an older Fantom Fury Vacuum. When I turn on the power button my vacuum does not come on. The outlet works well with other appliances. I have used it already today and when moving to another room it would not come on. What is wrong?

... Vacuums

While using, steam stopped coming out in force at the port levels in the head. Suddenly started high pitch whining, pressed button just above connection site and end flew off with great force pouring water onto floor and carpet. Unplugged immediately for safety and unable to get it to deliver steam force again. Less than one year old and used only 8-10 times only in walk areas where there is no carpet with distilled water. Please, advise, cannot find booklet. Thanks So Much, Beverly Crumme

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head...Euro ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Iam trying to use the upolhstery piece. Iam squeezing the button and no cleaner is coming out. Iam using by hoover steam vac deluxe spin.

Confirm that the hose is correctly connected to the clean water supply. If so, then remove it and, with the trigger operated on the hose, try to blow into the water feed connector. If you cannot pass air, the feed tube in the hose is clogged and must ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I just bought my edmark steam brush but didn't able to watch the guy selling it. Does the iron board really not coming hot? do I need to keep on pressing the steam button while using it? please somebody answer me/ thanks

... Vacuums

I have a rainbow e series vacuum cleaner that quit working while vacuuming and will not come back on. I know there is a reset button on the wand sweeper but I was not using that attachment when it sh

<p>If you have the <a rel='nofollow' href="http://www.rainvac.com/rainbow-vacuum-parts">eSERIES</a> single speed model, then it could be the <a rel='nofollow' href="http://www.rainvac.com/motor-rainbow-120v-e">motor</a> ... Rainbow E series Canister Wet/Dry Vacuum

Dyson dco7 when using the extension arm the tube sends to **** down towars the vacuum hardly any suction

Clck this link for instructions how to unblock the tube in your dc07 you can also use broom handlehttp://www.youtube.com/watch?v=US78z540kFw ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Henry hoover Automatic rewind of cable not working. Cable will only come out a few feet then jams. Currently using an extension lead. Any advice on how to free cable much appreciated.

Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=26736&thid=552936\015\012Henry Hoover\015\012Posted by modbod on Apr 28, 2008\015\012Automatic rewind cable not wor ... Henry Numatic "" Canister Vacuum

Electrolux Upright Versatility vacumm cleaner- When I use the CARPET power button, the roller does not work. Red wording lights up that says 'Check Rollerbrush'. How do I reset or fix the rollerbrush? thanks! I have guests coming and I really need to vacumm!

... Electrolux 1910 Bagless Upright Vacuum

Vaccum was being used and suddenly stopped. checked the filter, circuit breaker, and pressed restart button. still does not come on

To test the vacuum motor and circuit card, detach low voltage wires from vacuum. Using insulated needle-nose pliers, place points of pliers in each wiring connector. This should start and run the motor as long as the pliers are in place. If it doe ... Electrolux Central Vacuum

I have purchased a vaccum cleaner (Swift) from Nandilath G Mart, Kaimanam, Trivandrum on 08 Jan 2010 vide invoice No. TVM-27308 dated 08 Jan 2010. On the same day, inspection at my home , it is found that the extension tube piece packed in a plythene cover is cracked vertically, and cannot be used. Request instruct the concerned to replace the damaged part. Joy Babu.B, C-85, ISRO Staff Quarters, Pallithura-PO, Trivandrum-695586 Tele: 9495409241.

Contributors to this site offer advice only. We cannot act on your behalf. Suggest you contact your supplier direct. Good luck! ... Vacuums

My shark steamer has stopped working after a year of having it (I have already replaced one, I'm a idiot!). My problem; however, is that it will steam, but the steam stops traveling through the actual "mop" part. I plugged it in, wait seconds and start pumping, but the steam builds up until it's hard to pump. I had to press the button really hard for the bottom to come off and it shot off like a rocket! I tried to stick something through the tubing, but it did nothing. What am I doing wrong? I

\012\012\012Hi,Here\012is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it\012may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Just got a Polti Vaporetto 1020 from someone and cannot get it to work. One yellow light lit up and was on for a few minutes then turned off...and there is nothing...flip the switch on the handle, nothing...flipped other yellow button, nothing...any suggestions? or where I might get directions on how to use it? didn't come with manual. Many thanks. best, pat

... Polti Vaporetto 2400 Canister Steam Vacuum

While using my mop yesterday, it stopped letting steam come out. Tonight I plugged it up again and you could hear it trying to steam. I push the button in to release the square frame and it pushed out a burst of steam and pushed the head off. Put it back together and it still will not let steam out. No matter how much water is in it.

\012Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Ste ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Over heats and shuts off, wont start again untill it cools off. can maybe vacuum one room before overheating. cyclone tubes are all clean, all hoses & lines are clear. this vacuum is fairly new, not used much. cant find a reset button. is the moter dirty of something?

The electric motor has a thermal switch and is self-resetting so there is no re-set switch. Make sure the air filter for the exhaust is clean. Also make sure that the height adjustment is not too low causing strain on the motor. Always bring the heig ... Dirt Devil Reaction Twin Cyclone Upright Vacuum

My Keurig pauses for about 3 min. befor it brews. Also , when i press the button for the largest serving, it only gives the smallest. It takes about 6 min. to fill a large mug because of the small amount of water and the delay in brewing. When I use the basket with my own coffee, only water comes out. What can I do? Mary Jo Greaver

... Vacuums

HI, I have a Kenmore 25813 and it seems like there is an intermittent short. When I have the extension wand on and the power floor attachment on, when it rotate the wand the light cuts out and so does the power floor attachment, when I twist it back it comes on again. I don't have this problem if I remove the wand and just use the crevice tool with the hose. Any idea where the short might be and can I fix it myself? Thanks. Gary

This is common you may have a short in the contacts from the handle to the wand or a break in the cord that goes into the powerhead ... Kenmore 25812 / 25813 Progressive Bagged Canister Vacuum

Delux Steam Mop not producing steam. Motor comes on , but , no steam . This is the first time I have tried to use it. The instructions mention "Priming the mop like a steam iron" , but , there is no buttons etc. to push for priming.

... Vacuums

The wand release button has broken. Therefore, the wand does not lock into place which results in swivelling of the handle and sometimes the handle coming off while using the vacuum cleaner. Can this wand release be readily repaired?

... Euro-Pro NV31 Infinity Vacuum

This is the first time I'm using my Mr Coffee Frappe maker and after plugging in the machine and pushing the power button, nothing happens. Should the red light come on right away?

Yes you should get some kind of power indicated that power is on the machine i would first check the circuit breaker and then assure that you have power coming out of the outlet after which you could then use a multimeter to folow where you do have p ... Vacuums

My Electrolux upright (3500 series) just quit. I was using it, all seemed fine, then the power cut out (I actually thought the plug had come out of the outlet but that wasn't it, and the outlet is good). Reset button is out, I can't make it stay in. Is it toast?

... Electrolux Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0594 seconds