Having problems with your Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray ?

Replacement power supply is impossible to find... Even techworld the original manufacturer does not have it listed.

Answers :

If you look at the original power supply, there should be a label with the following details included:
\015\012Output voltage
\015\012Maximum output current
\015\012The polarity of the output connector (which bit is positive and which negative).
\015\012If you take this info to an electronics retailer, e.g. Maplins in the UK or Radio Shack in the US, they should be able to sell you a universal power supply that can be configured to match.
Repair Help & Product Troubleshooting for Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replacement power supply is impossible to find... Even techworld the original manufacturer does not have it listed.

If you look at the original power supply, there should be a label with the following details included:\015\012\015\012Output voltage\015\012Maximum output current\015\012The polarity of the output connector (which bit is posit ... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

The battery will not charge in the sweeper. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. So the power supply and the battery are both good. Obviously there is a circuit failure in the on board charging control. Anyone know a fix or a likely faulty component? I had a shark handheld about 8 years ago and it developed the same problem. I examined the little circuit board inside but saw no visible indications that would isolate t

... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

The model is Miele S538, but I did not see it on the list. The suction power button( ) increasing the power does not work. The suction power button (-) decreasing the power does work.

... Miele Leo S5381 Canister HEPA Vacuum Cleaner Bagged Vacuum

I have cd mix 2, i lost the power cord, and i used a different 12v cord. The mixer played for a while then the power went off. I checked the fuse at the power supply it has continuity.

May be you unintentionally provided more voltage or current to the appliance and it has got damaged because i feel that if it played at first and then stopped then it might have got damaged due to overvoltage or excess of current .I would highly reco ... Vacuums

Can not find power supply for zoombot smart vacuum model RV501 charging power DC24V 20w. Power DC 14.4v 20W

... Vacuums

Scooba service light and tones go away when re-seating power supply

... iRobot Scooba 350 Robotic Vacuum

My electrolux 2100 vacuum hose broke. I replaced the hose but now I dop not have power at the hose end. is there a curcuit breaker in the canister tha supplies power to the hose??

... Electrolux Guardian Bagged Canister Vacuum

Looking for users manual for anti-bark dog collar (citrus spray) model name/no: innotek ssb-300. This is a replacement for my original unit which stopped working. Petsafe sent me the manual for the original unit again...not this one, which is slightly different. (categories below do not apply...could not 'un-choose' from the product list??!! - sorry) Darlene - Edmonton, Alberta Canada

Innotek has a manuals download site hereA citrus spray model manual is ... Vacuums

Miele vacuum. Model: Medivac: SEB 191 When plugged in, no power to vacuum. Could it be power cord supply, or switch?

... Vacuums

Power nozzle on E-series won't start when cold unless the red 'reset' button is pressed multiple times while also holding the trigger to 'warm it up'...this is w/the power nozzle off the floor - no restriction on it turning. Once it's been running and then turned off the button must be pressed w/the trigger to get it to run - again w/the nozzle off the floor. It also seems to shut off too easily while vacuuming. I replaced the motor,which didn't fix it. Is the reset switch next on my list? T

... Rainbow E series Canister Wet/Dry Vacuum

Wilson Jones auto 130 Shredder - No power out of power supply, and fuse is good. need circuit board.

... Vacuums

I have a swivel sweeper, the original series, that is about one year old and is losing power. The battery has been replaced but it still seems weaker than it used to be. The brushes do not turn as quickly and the overall pick-up is not as strong as it was when it was new. Any suggestions on how to get the power back up to what it once was?

HiThank you for your queryI think what you will find is the base of the sweeper has 4 brushes, each of these brushes are run from a cog, if you can take the base apart you will find that it has been clogged up with hair and ot ... As Seen On TV Swivel Sweeper Vacuum

I have a Husqvarna Embroidery Card reader/writer for a Viking Rose sewing machine, and I want to know if I can plug a 8-volt power supply into it. During our move the power attachment go separated and I don't want to risk the wrong voltage. The unit is for an older machine, not the USB version that is now in use, Thank you in advance.

The Reader/Writer's power cord is a transformer, with input 120VAC 60Hz, 9 Watt. Output is 12VAC 500mA. The connector is a standard small round plug-in. The one we have appeard to be generic and is labeled only " ... Vacuums

Where can i buy parts for the model C151D vacuum. any place i checked does not have that model of electrolux listed. i need the power wand attachment. i ordered one that looked like it from sears parts direct but it wasn't the proper one and they do not list the model C151D

Any Aerus Electrolux store. For the one nearest you, check the below link and follow the directions. Keep in mind that if it's too far away, they do ship. If you're close enough, they do deliver.\015\012This model is not the same company tha ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Power Supply For Euro-Pro Shark V1730 Cordless Professional. Where?

This power cord / adaptor can be found at http://www.totalvac.com/accessory/parts/1016FM.html ... Vacuums

Need power supply oreck qs110

... Vacuums

I need to replace power supply. where the cord

Greetings from GoVacuum.com,Unfortunately there is no fuse on a Kirby Generation model. In my 10 years of repairing Kirby's as well as other vacuums I will tell you that 9 times out of 10, when a Kirby Generation doesn't turn on, it's the ... Kirby Generation 3 Bagged Upright Vacuum

Solution supply hose, for a Bissel Power Steamer Deluxe 1631-1

... Bissell 1631 PowerSteamer ProHeat Canister Vacuum

Where can I get a new power head motor replacement for SE series,original motor GS ELECTRIC 5570-02-1 in UK or Ireland,Thank you,Liam.

... Rainbow E series Canister Wet/Dry Vacuum

The unit wont start,i have it pluged in to a known good power supply.

... Samsung Quiet Jet 9068 Bagged Canister Vacuum

Replacement motor I am undertaking the repair of an old dustbuster as a training exercise. ,The motor in my V2410 is Made by Johnson Electric but I cannot find reference to the numbers marked on it on the manufacturers website. Are you able to give me a model number for an equivalent replacement or the specifications of the original motor? Thanks, Gary.

... Black & Decker V2410 DustBuster Handheld Vacuum

I have a Beam Rugmaster Plus power head Model BM1 393 Type AB and the connection were the metal pipe meets the plastic swivel broke close to the unit. It appears like a manufacture defect in that is broke in two small places and not the entire unit. Can this piece be replaced or glued??

This is most likely repairable. Lots of the Beam parts are available. I would recommend checking out any local vacuum shop or searching online for a central vacuum store that sells beam products. ... Beam Industries 750 Classic Bagless Central System Cyclonic Vacuum

My Dyson DC 04 has stopped picking up I have checked the belt it is ok and emptied the cylinder what can I do.? My product does not appear on your list but it is one of the original and it is Green

I guess you've also checked that the washable filter is clean. If not, do that first. Next place to look is underneath - you will see a short length of spiral-reinforced clear plastic tube. That tube is liable to split, and even quite a small split w ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My roomba 550 is having an error code 3. I change the power supply and the problem still. I will appreciate your answer

Your error code is a charging fault code\015\012By clicking ojn the link below is a chart of fault codes. Save this useful chart for further use later\015\012\015\012\015\012\015\012\015\012 ... iRobot Roomba 550 Vacuum

I am looking for a contol board for a miele s143 stick vacuum. The vacuum wont start but when I supply power directly to the motor it spins. I think the switches are OK so I have concluded it is the control board Thanks Don Kenney

You should check the cord and switch's for continuity, the boards are usually pretty reliable, you could check the board for any bad solder joints, at least that would be obvious. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2948 seconds