Having problems with your Euro-Pro EP601 Bagless Upright Cyclonic Vacuum ?

Brush roller has stopped turning - Euro-Pro EP601 Bagless Upright Cyclonic Vacuum


Answers :

Look on the bottom of the unit for a small reset switch button.I have not worked on this unit but many are similar. If you can hear the roller motor running you may need to replace the belt
Repair Help & Product Troubleshooting for Euro-Pro EP601 Bagless Upright Cyclonic Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Brush roller has stopped turning - Euro-Pro EP601 Bagless Upright Cyclonic Vacuum


Look on the bottom of the unit for a small reset switch button.I have not worked on this unit but many are similar. If you can hear the roller motor running you may need to replace the belt ... Euro-Pro EP601 Bagless Upright Cyclonic Vacuum

Need a manual for an Euro Pro EP601 vacuum - Euro-Pro EP601 Bagless Upright Cyclonic Vacuum


... Euro-Pro EP601 Bagless Upright Cyclonic Vacuum

Shark Euro-pro EP621 Bagless Upright Vacuum. Q regarding the brush not spinning / after troubleshooting and taking actions listed below, it now spinning for a few secs, but then stopping. Already removed hair, strings, etc. Checked that belt is aligned properly, checked that small wheel that turns belt is working (spins fine when belt removed. Oiled the turning parts a bit, that made it spin better, but still stops. It turns about 3-4 seconds then stops. If I switch it off and on again, I get ag


... Euro-Pro EP621 Bagless Upright Vacuum

The roller stop rotating - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


Remove the brush assembly from the base unit and check the condition of the drive belt. Check the brush end bearings for wound-up thread, hair, and other debris. Place the brush back without the belt--it should spin freely. Reinstall the belt if it i ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I need the manual for the Euro Pro EP602vac - Euro-Pro EP602 Bagless Stick Cyclonic Vacuum


Hi\012Here is one for you\012http://www.sharkclean.com/manual/EP602_REV_1007C_Reader.pdf\012you can read it on line or download or p ... Euro-Pro EP602 Bagless Stick Cyclonic Vacuum

Vacuum getting hot in filter area - Euro-Pro Shark Professional Upright Vacuum with Bonus StickVac Red Bagless Vacuum


That's not abnormal, unless it's getting very hot. Have you changed the filter recently? If the filter is blocked it will get hotter than normal. the filter should be changed every 4 to six weeks of normal usage. ... Euro-Pro Shark Professional Upright Vacuum with Bonus StickVac Red Bagless Vacuum

How to put roller back on vacuum - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


More info required which vacuum you have etc ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

No suction but green light on shark vacuum - Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum


... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

Shark vacuum belt - Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum


... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

Bissell Power Track Cyclonic Upright Bagless Vacuum.. ..The spin brush works laying down....when upright it won't spin! I cleaned any and all hair from the roller....belt is not broken....but do I need a new belt though? The vac is a few years old bever replaced the belt yet.


You need a new belt. ... Vacuums

It stopped sucking @ brush stopped turning - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum


Usually on this vacuum those two problems are not related, but if you got a lot of stuff stuck in the brushroll and in the suction tube at the same time it could happen. Check the belt to make sure it's not broken. If the vacuum is over a year old th ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Parts diagram of vacuum navigator - Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum


... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

Stopped sucking! - Dyson DC14 Low Reach Bagless Upright Cyclonic Vacuum


Have you emptied the dirt and cleaned the filter? Hope this helps. Good luck! ... Dyson DC14 Low Reach Bagless Upright Cyclonic Vacuum

My bagless upright model v209af vacuum motor thermostat keeps shutting down after 3 minutes have checked for blockages and have just cleaned and dried all filters. euro pro


... Euro-Pro Vacuums

Roller bars on bottom not rolling - Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum


The belt has probably broken. Hoover says that the belt on this model should last the life of the vacuum, but that is rarely the case. They do wear and break. Changing the belt is simple and the belts aren't to much. You can get a replacement here: ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Vax v5 roller not spinning even after reset - VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum


... VAX Appliances Vax X5 Bagless Upright Cyclonic Vacuum

Diagram of shark navigator - Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum


... Euro-Pro NV22 Shark Navigator Bagless Upright Vacuum

Roller does not spin - Dyson DC07 Bagless Upright Cyclonic Vacuum


A broken belt is the most common cause. Check and replace. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Roller is not rolling-belt missing - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


You need to take of the base plate then take out the roller then put a new belt in then put the roller back in ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Stopped running. won't turn on - Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum


Check power cord or replaced Powercord Assy part no : 905449-04\015\012check power switch or replaced power switch part no : 910971-01 ... Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum

Cannot get the brush roller back in properly - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


You could try checking out this video on dyson replacements\015\012\015\012good luck ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Just stop working - Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum


So, please check(a) the fuse, if ok check (b) power cord ,if ok check (c) the switch,if you have a miltimeter, it will be very easy for you ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

Brush roller quit spinning. - Euro-Pro V1828 Shark Stick Vac Bagless Vacuum


... Euro-Pro V1828 Shark Stick Vac Bagless Vacuum

Roller does not turn - Dyson DC14 Bagless Upright Cyclonic Vacuum


It sounds as though you need to replace the drive belt. The necessary part is available from http://www.espares.co.uk/dyson/dc04/p/1086/716/4. Fitting it is tricky, but guidance is available from http://www.dysonmedic.com/DC04%20Folder/DC04%20belt%20 ... Dyson DC14 Bagless Upright Cyclonic Vacuum

Roller brush does not turn when vacum is on - Dyson DC07 Bagless Upright Cyclonic Vacuum


The belt is broken or stretched. You can get replacement belts for the DC07 here:Belt for DC07 with clutch ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1539 seconds