Having problems with your Euro-Pro EP750M Stick/Hand Bagless Handheld Vacuum ?

I need a replacement adgitator motor for a euro-pro x for the floor cleaning attatchment


Answers :

Repair Help & Product Troubleshooting for Euro-Pro EP750M Stick/Hand Bagless Handheld Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need a replacement adgitator motor for a euro-pro x for the floor cleaning attatchment


... Euro-Pro EP750M Stick/Hand Bagless Handheld Vacuum

Need parts diagram for euro-Pro ep601. I need to replace the power cord, but cannot get the motor gasket guard off.


Hi!You need to release a "clip" under the handle(this is on top of the dust cup) and then look for a hidden screw right under the thermostat label. ... Vacuums

Loose handle on shark v1950 sweeper - Shark Euro-Pro V1950 VX3 Rechargeable Stick Broom Sweeper, 13" Motorized Brush Roll, Folding Handle, 2 Speeds, 50 Min Cleaning, Carpets & Floors


... Shark Euro-Pro V1950 VX3 Rechargeable Stick Broom Sweeper, 13" Motorized Brush Roll, Folding Handle, 2 Speeds, 50 Min Cleaning, Carpets & Floors

My older Dyson DC14 (the purple one) early model with a clutch on the beater bar belt needs a clutch replacement. The bar has been cleaned and there are no worn or damaged parts so I conclude that the clutch at the motor end of the belt needs to be replaced. I can find the part online but no instructions on how to disassemble the vacuum to get to and replace it. Dysons only advice is to give me the address and phone of the nearest service center. Can you help me?


Have a look at www.dysonmedic.com which has some very useful info on dismantling and repairing Dysons.\015\012\015\012Although this site doesnt actually cover the DC1 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a new Euro-Pro shark model S3101. Used it one time and while I was doing my tile floor in my kitchen I reached under a cabnet to clean and hit the floor kick kind of hard and broke the head off of the shark. I have only the T shaped end on the shark now with the cleaning head broken off and looks unrepairable. I did kind of hit the floor kick hard but the plastic broke like glass. Can I put a new head on the remaining piece or is it repairable? thanks Angie


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Pro ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I Have two questions concerning my AIRVAC AV2500 Red Series Vacuum System. How do you replace the light in the floor power head sweeper and can you replace the permanent fabric filter? We had the system installed in 2004 and the light in the sweeper head just went out and can not find any manual on line on how to replace it. The filter if not torn but avter 6 years it probably needs some kine of cleaning or replaced even though it says permanent. Any help would be appreciated. Jim McCluskey


... Vacuums

Need replacement part for model ep95 euro-pro steam cleaner concentrator


... Euro-Pro Steam Cleaner EP95 Canister Vacuum

I have a Euro-Pro upright Vacuum model UV205H and I need the manual so I can find out the name of the various parts which I need to replace.


Try this site, they might just have the manual you are looking for:- www.retrevo.com/samples/Euro-Pro-manuals.html ... Euro-Pro UV205H Bagless Upright Cyclonic Vacuum

Shark infinity vacuum nv31c motor overheats. everything is clean and free of clogs. it will work for 3-4 minutes, then shut off. does the motor need replacing?


Mine takes longer to shut down, but I just started having this same problem. I wish I knew what's causing it so I could fix it. I think maybe we had a power surge at some point when I was using it last week. :( ... Euro-Pro NV30 Infinity Bagless Upright Cyclonic Vacuum

I have a Euro-Pro Shark Cordless Sweeper Model UV610. The motor still runs but the spinning brushes are no longer spinning. Can someone that is familiar with this appliance please assist me at repairing it and/or what parts I may need for repairing it? Thanks T.R.


IT SOUNDS LIKE YOU HAVE A BROKEN BELT, THAT CONNECTS THE MOTOR TO THE ROTOR BRUSH. ... Euro-Pro Shark Cordless Stick Vacuum SV775R Vacuum

SHARK CORDLESS SWEEPER 3 SPEED CONTROL FLOOR, CARPET, TURBO BATTERY EURO-PRO 8.4V - 1.3 Ah SB617U 3305 BELT Turned on and almost immediately turned off At least four years old - not used all the time - not used in six months Checked belt - seems O.K. Do I need a new battery, if so, where do I get one? Or should I just get a new sweeper? Cost?


... Vacuums

My Hoover floormate motor started smoking. It is over 9 years old. I keep the floor brushes clean. I am wonder if replacing the mother is worth it.


MSRP on this motor is $69.95. Labor may be another $30.00. I often see these units in thrift shops, which may be worth a try. ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

I have a Euro Pro canister EP754 vacuum that runs HOWEVER the main floor attatchment brushes wont turn. Does this require a new belt? And where is it located?


... Euro-Pro Canister EP754 Bagged Vacuum

Need Charger KA12D120015023U for my Euro-Pro No-Touch Dust cup baglss floor vacuum made by Sharp. Can anyone help [email protected]


Http://www.zis4u.com/ka12d120015023u-adapter-150ma-v1917-apl1172-cordless-sweeper-p-469.html ... Euro-Pro S3325 Handheld Steam Vacuum

My euro-pro steam mor model s3101q needs a replacement for the tube connecting the heating unit to the mop head.


Hi, Here is a tip that I wrote about how to find the parts you need for your SharkHow to Find Shark Parts and Accessories ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Accessory adapter, need replacement - Euro-Pro S3325 Handheld Steam Vacuum


... Euro-Pro S3325 Handheld Steam Vacuum

The vacuum is making a noise like something is stuck when it is in the carpet position but not when in the floor position. I can't find anything that is stuck in the areas that I can see. I have cleaned the brush but it does not seem to want to turn. Does this machine need to be oiled so the roller will turn? Is there a way to check inside the motor? Do you think that because the brush won't turn that is making the noise? Do you know of any repair shops in the Lake Havasu City, Arizona area?


As far as the roller brush goes, yes, it does need to be cleaned. Follow the directions to remove it and clean as best you can of all debris. On both ends of the roller brush there will be two "holders" of sort that connect the brush to the frame o ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Need instruction manual for shark euro pro s3325 floor cleaner


Hi, You can get the manual for your Euro Pro s3325 here:Shark Euro Pro s3325 ManualThank You ... Vacuums

My bagless upright model v209af vacuum motor thermostat keeps shutting down after 3 minutes have checked for blockages and have just cleaned and dried all filters. euro pro


... Euro-Pro Vacuums

Need a replacement handle modle S3101C - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Hi,Look under the manuals link... they sell replacement handles...\012\012Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a euro-pro ultra stem shark model #EP903. Where can I find replacement ACCESSORIES? (the extension for floor steaming)


This URL would be a good place to start looking:\015\012\015\012http://www.best-price.com/search/landing/query/euro+pro+accessories/s/google/koid/9385510129/gkaid/38607740/?gclid=CO-J7_PInKQCFQgEbAodaUYIEw ... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

I need a replacement dirt basket and screen for Shark Euro-Pro Model EP85SS


... Euro-Pro S3325 Handheld Steam Vacuum

I need a replacement part for the S3325 Shark ultra steam blaster hard surface cleaner: part #22, Accessory Adapter, on page 3 of the owners manual. Euro Pro shipped me a totally wrong part. Can you help me find this adapter? Thank you.


... Euro-Pro S3325 Handheld Steam Vacuum

I need to replace the hose on my Euro Pro Shark canister vacuum EP722. After numerous searches, unable to find online. Looking for simular hose that will attachment to canister. What hose from another model or even maker will work? Thanks


Go to shark in GOGGLE. Go sharks wedsite, find your vaccum, click your hose. We have 3 mops and vacuum. No trouble getting parts and filters. Not high priced. ... Euro-Pro EP722 Canister Vacuum

Need replacement o rings for euro-pro steamer


... Euro-Pro Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1114 seconds