Having problems with your Euro-Pro S3325 Handheld Steam Vacuum ?

"O" ring in Main Unit brock

\015 Steam Pocket Mop S3501CO "O" Ring in the Unit brocken\015

Answers :

Repair Help & Product Troubleshooting for Euro-Pro S3325 Handheld Steam Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

"O" ring in Main Unit brock


... Euro-Pro S3325 Handheld Steam Vacuum

How can I get my DAB radio working again? I have a Sony XDRS100CD with DAB radio. The DAB radio has stopped working although I can still use the CD and get FM radio. The unit has a readout on the front that usually shows the time and this stopped working too, presumably because it got the time via the DAB radio. The unit works from mains and batteries although I have only ever used it on mains.


I have the same problem... did you ever get a fix..[email protected] ... Vacuums

We lost our instructions to the Kirby Shampoo attachement and how to attach it to the main unit, the belt and how to use it. We need complete instructions and explanations on how to use this as we have tried and the belt does not attach to the main unit, the brush does not turn and the hops along the carpet and no water, etc. returns to the tray. Please help us with as simple and complete instructions as possible. THANK YOU VERY MUCH, LOUIE CAPLAN


First, you'll need to fill the tank with water (warm or cold). There are three fill lines on the side of the tank. Fill to the desired line and add one shampooer tank lid full of Kirby shampoo for each line of water. A full tank will require th ... Vacuums

Modelsc505uk steam is staying in the main unit and not coming out of the hand held floor unit


... Euro-Pro Shark SC-505 Handheld Steam Vacuum

Hi. We have a Riccar N2100 vacuum cleaner, which has served us well for many, many years. I'd like to attempt a repair on this unit, and looking for advice and/or a parts diagram to proceed. The unit makes a groaning sound when shut off. The sound tapers off in pitch as the motor and beater bar come to a stop. The sound only happens when the vacuum cleaner is turned off in the normal upright position. The sound does not happen when the lower unit and main housing are both laying flat. I took


... Vacuums

My Triton T80 SI shower is leaking from where the outlet pipe assy joins to the heater can assembly. when I checked where the two join together I see that there is a rubber O ring fitting into a recess in the heater can assy. The screws which hold the two parts together does not force a compression between the two parts causing it to leak. Is there another modified unit or am I stuck with what Ive got and should I replace the O ring or the shower.


... Vacuums

My vac's hose works but the main machine stops picking up dust and stuff after about a minute or so. Thn I have to take the hose of and clean the stuff from the main unit. My machine is 6 yrs. old


... Beam Industries 2775 Serenity Plus Central System Vacuum

GE 106766 When turned on, rubber burn smell from the main body. Can't locate screws etc to open and inspect the main unit. Very little suction. Motor functions.


... GE 106766 Bagged Canister Vacuum

Model # 5770 the brush motor runs and shuts down after a few seconds...Turn unit off and the brush again will run for a second or two...If I don't turn unit off brush will not start up..Could it be the printed board..the motor brushes..or the wiring that goes from the printed board to the main motor...Thank you


Seems like your unit goes into failsafe because it detects something wrong. Well you should check the brushes and replace them if they are worn out. Also check the wiring for shorts etc, becaue the unit maybe tripping due to an overload. The printed ... Bissell Vacuums

Help hi there. i have a hoover savvy u8172-900 vaccum. the hose has great suction, but there is limited suction on the main unit and the brush does not spin when i try to use the product. we have cleared the brush of any debris and have also installed a new bag. a few days ago, we disconnected the hose to make sure there was not any foreign bodies stuck in the unit...nothing seems to help. any advise?


As the hose fits into the base (if i am correct) the power at the base should be fine, make sure the base is clean and free from blockage,\015\012you say the brush doesn't spin, has the belt broken, if so replace it, (very cheap) and only a couple of ... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

I have an easy flo vacuum model # 199C and it won't shut off. It started out as an intermitent problem but now will not shut off when the hose is unplugged, nor when the off/on switch on the main unit is shut off. the only way to get the motor to stop running is to unplug the unit. Any ideas?


Just had this same problem. I unplugged the low voltage signal wires and the vacuum stayed on. Thus eliminating the possibility of the signal wires shorting out somewhere. I'm not really sure which wire(s) were causing the problem. But when I disasse ... Easy Flo EF1500 Vacuum

We've used this 5 times...the tools work, but not the main unit


Hi, W/D here. Couple of things will make your life difficult with these machines. What usually happens is that the cleaning solution sets up in the tubing and hose low points as a gel. Sometimes the attachments work, sometimes the floor spray wil ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Split hose? My machine has stopped suction on the main unit. When I tilt the neck all the way back, the hose is split around its diameter. Is there a straightforward way to fix this AND where can I order th part?


This piece is available but is very difficult to install. the upper handle needs to be split to reach the upper part of this hose. i would call the manufactuer and find a local warranty service center to get this part. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Kenmoore Intellivac w direct drive suddenly started making internal sound like something was stuck. Hose is clear, and sound is made when hose is detached from main unit. Vacuum sounds find at lower pressure, only makes sound with bag door closed and/or placing my hand over the end of hose.


Shut off the vac and open container and remove the bag. Try dropping a coin into the hose, then raise up to see if it falls thru to the bag area. If it does check the throat of the vac where the dirt is sucked upward to dump into the bag itself. ... Kenmore 35912 / 35913 Progressive Upright Vacuum

Dyson clogs at main intake . Cleaned entire unit, it appears to work fine and within 15 minutes it is clogged again.


Six months just stopped steaming. Don't wast your time trying to take apart.I poured small amount of vinegar in and let it sit an hour then empty it out and ran a small wire into the base of the steamer. I could feel resistance but after poking i ... Dyson DCO3 Absolute Bagless Upright Cyclonic Vacuum

I own a Hoover Steam Vac V2 deep cleaner with Auto Rinse feature. The Model Number is not available ex: was on the bottom of the machine and the sticker is completely worn off the machine. I am having a problem with the bottle you fill with detergent ex: this bottle is seperate from the main clean water tank. THE PROBLEM: The little plastic part that goes in the bottom of the bottle has an "O" ring ex: cone shaped with a spring.....it keeps falling out. Can you supply a part number for this


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=641300\015\012Generic problem for all Vacuums\015\012I own a Hoover Steam\015\012Posted by w_brennan on ... Vacuums

My Dyson ball dc25 extension pole for attachments won't detach from the main unit. It was sticking a bit last time but now it won't come off at all. UGH. Any ideas? Thanks, Liz PLEASE note I have dc25 not 24


... Dyson Ball DC24 Bagless Upright Vacuum

My model F5906-900 --- problem is the brushes have stoped working... I pulled the brush assembly out by holding the two tabs, and all seems clean and the brush assembly rotates easly... onced the brush assembly is removed. What I did notice is the female driver slot (found in the main assembly unit) that drives the brushes seems stuck..Is that normal when the machine is not hooked up to power? How can I get the brushed going??? it is a good machine, but the brush options is important too it's ab


(1) Assure the Brush Control on the hood is NOT set to the OFF position.\015\012(2) Remove the brush assembly by pulling/unlatching it from base on each side.\015\012(3) Does one of the brushes ... Hoover F5906-900 Upright Steam Vacuum

There seems to be a lack of suction on the main unit(brushes). Its fine when using the pipe


There is a blockage in the neck where the power head connects to the machine. Remove the base plate. Look behind the beater bar and you will see where the dirt enters the machine. There is likely something blocking the entry into the mach ... Dyson Vacuums

I'm not getting suction out of the main unit - Bissell Vacuums


Clean all of the filters, and remove the hoses and shake them, and try to stick something all the way through the vaccuum hose (broom handle or garden hose works great) and then see if it works better. If not, be more specific. ... Bissell Vacuums

No suction on main unit


Take the top cover off and check the inlet hose by the brush roll for a clog. ... Eureka 2961AVZ Bagless Upright Vacuum

Missing parts missing o ring around main body and need wheels


I need a new wand solution tube, Part Number 016-9463, for my Bissell Power Steamer Model number 1631. Actually, the nozzle at the end of the tube has broken, and I need to replace it, but I imagine I would have to buy the entire part, hose and nozz ... Bissell 1631 PowerSteamer ProHeat Canister Vacuum

I have hoover mdl U6459-900 and the brush will not rotate even though the main pulley belt is rotating. i have changed booh belts and this did not solve the problem. the suction on the unit seems ok. thanks??


Sound like you need tear down and find whats jamed in it to stop it from turning like string ore hair ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

How do i hook up the upholstery attachment to the main unit


See http://www.hoover.com/CustomerService/Manuals/Default.aspx to lookup the manual for your model. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Main unit wont **** up water but hose does, is there a clog some where and if so how do i fix it.


Hello your problem could that you have a clog in the front of the machine take the screws loose that hold the front cover on and check to see if the uptake sceen is clear. ... Bissell 8910 ProHeat Clear View Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0288 seconds