Having problems with your Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum ?

Plug the unit in, the power light doesnt illuminate and heat element doesnt heat the water. wall plug has power, mop cord isnt damaged


Answers :

Mine too
Repair Help & Product Troubleshooting for Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Plug the unit in, the power light doesnt illuminate and heat element doesnt heat the water. wall plug has power, mop cord isnt damaged


Mine too ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Dog chewed off the plug. Can I replace the plug or do I have to replace the entire power cord? Or is the mop trash?


You should be able to replace the plug, just follow the instructions on the replacement plug to insure you wire the proper polarity. Otherwise, you could create a potential for a shock. Not a good thing with a wet mop. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Not getting any power. plugged in, but light not on, and just not heating up. This is a shark steam mop.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Electrolux Centralux I have a Electrolux Centralux. When I plug the hose in at one of the wall outlets the motor will not start. If I go to the motor and slap the unit it will start.....then...it will not stop unless I unplug the power cord to the motor. If I plug the power cord back in, the unit will not restart until I slap the motor unit again. The unit has only been used 20 - 30 times. Any suggestions?? Thanks, Bruce


I dont know if you had your unit looked at yet but it sounds like the Power module is going. I repair the machines so I know some of the work. ... Electrolux Centralux Vacuum

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop's head but all of a sudden no power light would go on and no steam would come out. I can still use the mop, cause water from the tank still is able to flow down to the head. It's just that I'd have to use it like an ordinary mop not as the steam mop I liked. Pls help!!!


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I just purchased a Sebo Airbelt D canister vacuum. I plugged it in and used it for ten seconds then turned it off, retracted the power cord and now cannot get the power cord out of the machine. Did I not spend enough money to get a quality product? Does anyone have any idea how to get the power cord out without breaking the machine?


... Vacuums

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop's head but all of


HEATING ELEMENTS BURNT OUT. WILL COST OVER $100. TOFIX. SHARK NOW HAS A NEW MODEL "SHARK 3" MUCH BETTER ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My kenmore progressive caniser needs a new power cord. the plug had one of the metal prongs break on the plug. how can I replace the cord? model 22812201


I do not know if you want to replace the replace the power\012cord or the receptacle for the power wand?\012\012If you need the prong for the power cord you can purchase a\012replacement power plug from a local hardware store and it will functi ... Kenmore 25512/ 25513 Progressive Canister Vacuum

The power brush floor rug attachment on my Eureka 6997 A Oxygen Canister Vacuum goes on an off as I use it. I replaced the The power cord from the handle has 2 plug in connections: 1 at the handle / upper wand 1 at the lower wand top of the power brush attachment I replaced the entire wand assembly and it worked great for a year or so and now it's doing the same thing again. I was told to keep the power switch on the handle set to off when connecting the power brush attachment or it will bu


This is from the prongs not making a good connection causing an arch inside the plugg causing what looks like rust on the plugg. I would try snugging up the connection by squeezing the female section to get a better connection on the prongs when it i ... Vacuums

Power cord has been split accidentally - needs to be adjoined to new plug


... Dyson DC07 Bagless Upright Cyclonic Vacuum

HELP! My HAAN floor steam mop water pump went silent & dead! Heat element still heats, but the pump is inactive.


... Vacuums

Hot cord the cord on my vacuum cleaner has been getting very hot the heat is from one end to the other incuding the plug and also where the cord exits the back of the canister please help I love this vacuum cleaner it has been faithful to me for over 15 years!


Likely after all these years that the motor is starting to go bad and draw more amps thasn it should. a new motor at a vac dealer is your best bet. it was likely made by panasonic, so a new panasonic is your best bet, and less $$$than the kenmore for ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Vacuum dead I have oreck XLx2 bagged upright - the belt ,plug and cord have been replaced - has been working great - now went to plug it in and it does not work - the light goes on in the on/off switch so power is working but vacuum is dead - any suggestions


If the cord coming from the bottom up to the handle is loose, and is a plug, push it in. If that doesn't help. then could be a problem with the motor. One other thing to check is inside the handle, maybe a wire came loose. ... Oreck XL2200 Bagged Upright Vacuum

I plugged it in, pushed the power button and it came on for about 5 seconds. Then, it shut off by itself. I checked the outlet and it was working fine. I then cleaned the brushes and tried again, but no power... Nothing. Could it be the cord??? Any other ideas? Thanks for your help!


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My omega steam cleaner Model SC104 hasn't got the light on and it will not heat up. I was in the middle of a job and waited to fill for 3 min. then I refilled the tank. When I plugged it back in I had no power or heat. Can you help?


... Euro-Pro Omega SC104 Steam Vacuum

Miele vacuum. Model: Medivac: SEB 191 When plugged in, no power to vacuum. Could it be power cord supply, or switch?


... Vacuums

Shark Steamer model S3325 will not power on; switch appears to be working but will not indicate on and will not heat tank. I can hear it try to start the heating element (secondary clicks) however, does not seem to work.


There's a thermal fuse inside. If it gets too hot, the fuse will blow and the thing won't turn on.\015\012\015\012It has a 216 C temp limit. You can find thermal fuses at radio shack for less than 5$. If you're adventurous enough, you can fi ... Euro-Pro S3325 Handheld Steam Vacuum

I have a BISSELL CLEANVIEW II, I turn the power switch to "on" and am able to clean carpet for 1/2 a minute until the power shuts off in the outlet the vacuum is plugged into! The same repeats itself! I wonder if the motor is damaged or just plain shorted out!


Well yes in deed it is time for a new vac. for the motor bearings or armature are ceasing up ang causing the breaker to pop. if the vac. cord is hot then you know for sure... ... Vacuums

I was using kirby g5 and I think I stepped on cord and lost power on vacuum. Now it won't start. Could this be a damaged cord..or what?


Either that, or it was pulled so hard, it came disconnected from the vac switch. stepping on a cord rarely affects power. so, check vac switch and outlet to make sure the outlet has power.\015\012\015\012(if you know an electrician or if ... Kirby G5 Bagged Upright Vacuum

My steam blaster S3350 will not heat up when I fill in with the correct amount of water. Tried it plugged into other electric sockets & still have no steam.. The red light always came on when heating, now as soon as the power is on the yellow light comes on, & no results


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

The Dyson Animal won't turn on or off. The red power button doesn't control the on/off for this machine any longer. Once plugged in, the vacuum will work and the power cord must be unplugged to turn it off. Any help would be appreciated.


The machine needs a new switch. The switch is stuck to the "on" position. ... Dyson DC05 Bagless Canister Cyclonic Vacuum

Power cord plug broke and cord went back inside.......how do i open??


Call your local Electrolux office. Trying to fix it yourself will void your warranty. If you need any assistance call 570-326-1731 and ask for Liz, I will be happy to assist you if I can. ... Electrolux Guardian Bagged Canister Vacuum

Damage power cord needs to be replaced on Bissell 3920


... Bissell 3920 Bagless Upright Vacuum

GE canister 106766 Power cord does not stay in bezel


Yes you are absolutely right.you would save on shipping cost if order both together.\015\012\015\012and for parts you can also order it from \015\012www.radioshack. ... GE 106766 Bagged Canister Vacuum

Plug in but does not heat up, no light on but


Hi,The thing just plain broke...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1074 seconds