Having problems with your Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum ?

No steam. Back fired and left black mark on pad.


Answers :

This machine has a fuse on the heater. It sounds like it blew out and there is no way to repair it except to replace this machine. That is just the way they are built.
Repair Help & Product Troubleshooting for Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No steam. Back fired and left black mark on pad.


This machine has a fuse on the heater. It sounds like it blew out and there is no way to repair it except to replace this machine. That is just the way they are built. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Last time I used my Bissell Pet Hair Remover vacuum it smelled like something was burning and it left a black mark on the carpet. What should I do?


When you smell burning like that it usually indicates that the belt is worn and slipping on the motor shaft. You probably need to change the belt. You can get the belts for your model here: ... Bissell Upright Vacuum - The Pet Hair Eraser 1 ea Vacuum

Black marks on carpet


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=19810&thid=706295\015\012Black marks on carpet\015\012posted by carpetburner on Jun 25, 2008\015\012While I was w ... Oreck XL Ultra Bagged Upright Vacuum

When replacing the motor I noticed 2 pieces of black foam had fallen out, but I don't know where from? slightly leans to the left


... Vacuums

On a Kirby sentria the metal spool sticking out that goes into hose or power head becomes extremely hot and left burns marks on brush tube. It only gets hot when using power head. I checked all adjust


Check the brush roll to be sure it's spinning free too much drag can cause that to get hotter but usually it would break the belt. That spindle will get hot from the friction created by turning the belt and from the motor's heat. They'll just get hot ... Kirby Vacuums

My bissell 1699 series will not spray water, the flow indicator barely moves, but when left tank on it leaked all over floor, so the water when left unattended came out. When I first hooked up the machine black stuff was on my carpet when I first sprayed.


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Replaced Oreck power switch. 2 black leads and 1 white lead for switch. Posts marked 1, 2, and 3. 2 black wires to switch powers on. Connect white wire and breaker trips. Where does the white wire go?


Both black go to the switch. Power in - black to switch / white to white from motor. From motor - black to switch / white to white from power cord The black wire from the power hooks to ... Vacuums

Oreck vaccuum is leaving black marks on hardwood floor


... Oreck XL2200 Bagged Upright Vacuum

I have an Easy-Flo central vac unit. The handle on the electric hose has a switch on the handle. With the switch on ''O'' in the center, it's off. On the left, is the ''I'' position. The vacuum runs but the power brush doesn't. On the right is the ''II'' position. The switch won't flip that way. It feels stuck. It feels as if there is something underneath of it that won't let it push that direction. I have the switch out of the handle, but I can't seem to get the actual black casing around the


Switches are not usually designed to be dissembled.I would strongly suggest that you dont take the switch apart. you are better off getting a new one. then if you feel like it you can take the old switch apart and if it dosnt work you still hav ... Vacuums

Bought a ultimate g off trade me and it has left marks all over the carpet - am wondering why may be the problem - I have cleaned the outer bag and cleaned the rest of the outside - I am renting and n


Dirt build up on rug plate, or copy belt on m/c ... Kirby Ultimate G Bagged Upright Vacuum

My new oreck magnesium upright is making a black marks on my hardwood floor. what should i do?


... Oreck XL2200 Bagged Upright Vacuum

How to remove the residue on hardwood floors left by carpet pads?


... Vacuums

A small spring and a black plastic part fell off the handle release pad


... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Vacuum smells like burning rubber when on, no suction, leaving black marks on carpet


Usually when my vacuum smells like burning rubber, the belt needs to be changed and that is very easy to do. You just need to remove the the screws that hold in the rotator and put in a new belt. When the belt needs to be changed the vacuum will no ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Dear Sir or Madam, I own a black 23 x 47 x 7 mm Rowenta lighter. It has a screw on bottom that I cannot remove. What is it hiding ? Is this lighter refillable ? Is there a flint to replace ?. I've found on your site the following : "By jbbiii on Apr 06, 2009 Father died and left me a Rowenta lighter purchased in Stutgart in 1952. It has a screw on bottom with spring to replace the flint, but I cannot figure out how to open the bottom to replace the cotton wadding which I can see through the hole


Hello \015\012The flint should be near the striker.Or the thumb roller,usually below it.\015\012As old as it is you may not see it beacause its worn down.\015\012\015\012Maybe taking it to an antique store or a smoke shop woul ... Vacuums

Roomba circles My Roomba circles for a few minutes, then beeps 9 times and stops. A red exclamation mark appears on the left hand side of the controls. If you persist in restarting it, eventually I have been asked to clear Roombas wheels. As far as I can see, there isn't anything blocking the wheels.


Yes, this is known issue and if your bumper moves freely, you might be facing a sensor fault caused by poor quality of components.Here is a guide to fix ithttp://www.schneordesign.com/Avi/irobot/roomba_mod2.htmHave fun ... iRobot Roomba 560 Robotic Vacuum

Not picking up no suction leaving black marks on carpet


... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

A black plastic ring fell off underneath at the bottom left... looks like it goes around something... ? bissell steamcleaner


Plastic or rubber? If it's a rubber ring it's the drive belt for the brush cylinder and should be replaced. You can buy one online or at a hardware store. ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Substandard carpet pad?


This had occurred in the past, and we had replaced the sump pumps and employed agencies, such as Serve Pro to insure that the carpeting and padding were appropriately treated and in the nine+ years we owned the home, this never caused any problem wit ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I don't understand the confusing marks on the detergent holder on the Spotbot. I understand to fill it to the "water" mark, and I understand to then fill it to the "Oxy Gen" mark. But, what is the "Formula" mark? Do they mean other regular carpet cleaning formula is used with the Oxy Gen? BJR


We have a machine like yours, we interprate the same as you. "Formula" is for some product other than Oxy Gen.\015\012\015\012Of course, try this in an area that is out of the main view. We did and we were satisfied we guessed correctly ... Bissell 12005 Spot Bot Handheld Vacuum

How do I install brushes on Hoover V2 Windtunnel? Does a right and left go on the right side and vice versa on the left side? That is how it orignally came? Or do I put both rights on the right and both lefts on the left? Thanks for your help and advice.


Both right with right left with left. ... Hoover U8122-900 WindTunnel V2 Bagged Upright Vacuum

Kirby heritage mark 2


I know this is forever away, but I wanted the answer to be completed.The black brush lead wire attaches to the foot switch. It probably got pulled out when the unit was disassembled. Look at the side of the switch and where the power cord c ... Kirby Ultimate G Bagged Upright Vacuum

I have a motor for the Bissell 3750 power head with a black and brown wire, which wire is connected to what?? The old motor just had 2 black wires. There is a blue wire coming from the vacuum and blue wire coming from the light that are together, and a blue wire coming from the light and a black wire that are together. What does the blue and brown wire coming from the motor connect too? Thanks


... Bissell 3750 Lift Off Bagless Upright Vacuum

How do you wire a 2 speed fq motor. I know the blue/blue. the red/red. The yellow /yellow and I believe the whites together with the grey of the pn outlet. Does the black from the motor the black from the cord and the other grey from the pn outlet connect together ?


I have not seen the new two speed but sounds like the wiring is coded to teh switch by colorOn a single speed it would be this way.\015\012\015\012Power cord to side 1 of switch.\015\012Switch to motor 1 and PN receptacle 1, etc ... Filter Queen Cheetah II Ash - MU305 Bagless Canister Vacuum

Motor doesn't run I believe it the brush on the motor. two motor brushes one is completly gone about 1/8 inch left could this be the problem.the other motor brush still has 1/2 inch left. and current to motor tested good.


Sounds like your belt slipped off. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0287 seconds